Page 75 of 90
24-65
      
Voltage supply for Mass Air Flow (MAF) 
sensor, checking (Bosch MAF sensor)  
    
Note:  
Voltage is supplied to Mass Air Flow (MAF) sensor from Fuel Pump (FP) 
relay. 
If there is no battery voltage.  
 Electrical Wiring Diagrams, Troubleshooting & Component Locations    -  Disconnect connector from Mass Air Flow (MAF) sensor.
-  Connect multimeter to terminal 2 of connector and engine Ground 
(GND) for voltage measurement. 
-  Operate starter briefly. 
   Specification: approx. battery voltage
-  Check wire connection from terminal 2 of connector to Fuel Pump (FP) 
relay via fuse for open circuit and short circuit to Ground (GND), repair 
if necessary. 
Pa
ge 75 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
        Page 77 of 90
24-67
      
Wire connections for Mass Air Flow (MAF) 
sensor, checking (Bosch MAF sensor)  
     
Note:  
     Signal wire is also checked during wire test. 
     
-  Connect VAG1598/31 test box at wiring harness 
to ECM, do not connect ECM   Page 24
-20
 . 
    
The following wire connections must be checked for short circuit to B+, 
Ground (GND) and for open circuit  Connector for Mass Air Flow (MAF) 
sensor -G70-  
VAG1598/31 test box 
terminal  
3   27  
4   53  
5   29  
Pa
ge 77 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
        Page 78 of 90
24-68
      
   Wire resistance: max: 1.5 Ohm
     
-  Also check all wires for short circuit to each 
other. 
     
   Specification: infinite Ohms (no continuity)
     
-  If the voltage supply and the wire connection are 
OK, replace Mass Air Flow (MAF) sensor -G70-. 
Pa
ge 78 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
        Page 82 of 90
24-71
 Reading Display Group 002  Display field 
4  
Possible cause of malfunction  
Corrective action  
Less than 3.0 
g/s   
Large quantity of un-metered air between intake manifold 
and Mass Air Flow (MAF) sensor 
 Voltage supply to Mass Air Flow (MAF) sensor or wiring to 
Engine Control Module (ECM) - Check intake system for leaks (un-
metered air)   Page 24
-76
 
- Check voltage supply and wiring   Page 24
-72
 
More than 4.5 
g/s   
Load on engine due to accessories- Eliminate load (A/C, power steering, 
generator) 
  
 Voltage supply to Mass Air Flow (MAF) sensor or wiring to 
Engine Control Module (ECM) - Check voltage supply and wiring   Page 
24
-72
 
Pa
ge 82 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
        Page 83 of 90
24-72
      
Checking voltage supply to Mass Air Flow 
(MAF) sensor  
     
-  Disconnect harness connector from air mass 
meter. 
    
Note:  
The mass air flow sensor receives its voltage supply via the fuel pump 
relay. 
If the reading does not match the battery voltage:  
 Electrical Wiring Diagrams, Troubleshooting & Component Locations    -  Connect hand-held multimeter (voltage measurement range) between 
engine Ground (GND) and socket 2 of connector. 
-  Operate starter briefly. 
   Specification: approx. battery voltage
-  Check for open circuit or short to Ground (GND) in wiring between fuel 
pump relay and socket 2 on connector via fuse. Repair if necessary. 
Pa
ge 83 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
        Page 85 of 90
24-74
      
Checking wiring for mass air flow sensor  
     
Note:  
     The wiring test includes also testing the signal 
wire. 
     
-  Connect VAG1598/31 test box to wiring harness 
for engine control module. Do not connect to the 
engine control module itself   Page 24
-20
 . 
    
-  Check for open circuit and short to B+ or Ground (GND) in the following 
wiring connections: Connector for MAF sensor -G70, 
socket  
VAG1598/31 test box, 
socket   
3   27  
4   53  
5   29  
Pa
ge 85 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
        Page 86 of 90
24-75
      
  
Resistance in wiring: max. 1.5      
-  Repair short circuit or open circuit if 
necessary. 
     
       Electrical Wiring Diagrams, Troubleshooting & 
Component Locations        
  
Specification: infinity   (open circuit)     
-  If wiring and voltage supply are OK, replace 
Mass Air Flow (MAF) sensor -G70. 
Pa
ge 86 of 90 Motronic Multi
port Fuel In
jection 
(MFI
) system, servicin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.1 
     
        
          
   
    
    Page:  
    < prev   1-8  9-16   17-24