26-18
C - Secondary Air Injection (AIR) pump motor - Remove vacuum line -1-.
- Disconnect connection tube -2- from combination valve.
Tightening torque: 10 Nm (7 ft lb).
- Remove bolts -3- for combination valve from cylinder head and if
necessary, remove bracket -4- from cylinder head.
Bolt -3- tightening torque: 10 Nm (7 ft lb).
Bracket -4- tightening torque: 20 Nm (15 ft lb).
- Remove combination valve.
Repair Manual, Body Exterior, Repair Group 63
Repair Manual, Body Exterior, Repair Group 50 - Remove noise insulation panel (arrows).
- Remove front bumper.
- Move lock carrier into service position.
Pa
ge 9 of 10 Secondar
y Air In
jection
(AIR
) system
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.26.2
26-19
- Remove air duct to generator at front of air shroud.
- Disconnect connection at connector tube to Secondary Air Injection
(AIR) pump combination valves (left arrows), pull down to remove and
cut tie wraps.
- Remove three bolts on Secondary Air Injection (AIR) pump (lower right
arrows) but do not remove nuts.
- Remove pump toward rear from bracket.
- Remove connection line on Secondary Air Injection (AIR) pump to air
cleaner.
Installing
Installation is the reverse of removal. -
Turn connector tube for Secondary Air Injection (AIR) pump 45 to
right and disconnect. - Remove air Secondary Air Injection (AIR) pump.
Pa
ge 10 of 10 Secondar
y Air In
jection
(AIR
) system
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.26.2
