1996 AUDI A4 wiring

24-78

Checking voltage supply

- Disconnect TP sensor harness connector.

- Switch ignition ON.

If neither specified value is obtained:
If one of the specified values is not obtained, check ECM wiring as
follows: -
Switch multimeter (Fluke 83 or equivalent) to measure resistance ( )
and connect in sequence between terminals 1 (B+) and 2 (GND), then
between terminals 1 (B+) and 3 (signal). Specified value: 4.5 to 5.5 volts
- Check TP sensor resistance page 24
-77
.
- Connect VAG 1598/19 test box to ECM harness connector page 01
-
255
.

- Check Ground (GND) wire for continuity between TP sensor connector
terminal 2 and test box socket D12.

Specified value: max. 1 ohm ( )
Pa
ge 2 of 5 Throttle Position
(TP
) sensor, checkin
g and ad
justin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.22

24-79

- Check B+ wire for continuity between TP sensor
connector terminal 1 and test box socket A3.


Specified value: max. 1 ohm ( )
- Check signal wire for continuity between TP
sensor connector terminal 3 and test box socket
A24.


Specified value: max. 1 ohm ( ) If the specified value is not obtained:

- Determine open or short circuit in wiring using
wiring diagram; repair as necessary.

6-pin TP sensor
connector terminal ECM connector A
terminal or Ground
1 A3
3 A24
2 Intake manifold Ground
(GND)

Note:
If it becomes necessary to repair or replace any of the throttle position
sensor electrical terminals, ONLY replace with gold-plated terminals.
Pa
ge 3 of 5 Throttle Position
(TP
) sensor, checkin
g and ad
justin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.22

If the wiring is OK:
- Replace ECM page 01
-265
.
Pa
ge 4 of 5 Throttle Position
(TP
) sensor, checkin
g and ad
justin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.22