Page 1830 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Adjusting the sunroof panel (G)
Page 1832 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Interior sunroof screen (J)
Page 1833 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Interior sunroof screen (J)
Page 1835 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Sunroof panel drive bar (L)
Page 1836 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Sunroof panel drive bar (L)
Page 1979 of 2492
TOP OF BODY
Roof acoustic cross member
INTRODUCTION
The replacement of this part is a complementary
operation to the replacement of the roof for a
roll-over.
For reasons of standardisation, the Parts
Department only supplies parts for the version wi-
thout sunroof.Where a sunroof is fitted originally,
the roof and the centre roof cross member must
be cut according to the diagram below.
These cuts must also be made to fit a sunroof as an
accessory.
IMPORTANT : the roof cross member has a struc-
tural reinforcement function. For the version with
sunroof, the sunroof frame fulfils this function.
When fitting a sunroof as an accessory it is re-
commended that only sunroofs approved by the
Renault accessories department are used.
The method described only contains descriptions
of joints specific to the part concerned. Joints with
complementary parts are not included.
These are dealt with in their respective section (re-
fer to the contents page).
COMPOSITION OF PART FROM PARTS
DEPARTMENT
Single part.
PRE4502
45B
PARTS CONCERNED (thickness in mm) :
1Acoustic cross member 0.7
2Centre pillar reinforcement 1.5For sunroof
45-6
Page 2140 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Sunroof (A)
Page 2141 of 2492
52
NON-SIDE OPENING ELEMENT MECHANISMS
Sunroof (A)
