1995 LAND ROVER DISCOVERY remove seats

CHASSIS AND BODY
59
REPAIR
9.Remove 5 trim studs securing trim panel.
10.Remove trim panel.
Refit
11.Fit and align trim panel.
12.Fit trim panel retaining studs.
13.Position load space cover mounting bracket and
secure with screws.
14.Fold rear seat squab back and secure to latch.
15.Position load space cover to mounting brackets
and secure.
16.Fit 'E' post trim casing.
See 'E' post trim
casing - lh - with rear air conditioning fitted.
17.Fit fold down rear seat belts.See rear fold
down seat belts - lh - with rear air
conditioning fitted.
18.Fit rear fold down seat.See rear fold down
seats.
'E' POST TRIM CASING - RH
Service repair no - 76.13.13/03
Remove
1.Remove rear speaker.
See ELECTRICAL,
Repair, rear speaker.
2.Release 2 'E' post finisher retaining studs from
alpine light trim.
3.Release 2 'E' post finisher retaining clips from
lower trim panel.
4.Remove 'E' post finisher.
Refit
5.Position 'E' post finisher clips to lower trim panel.
6.Secure 'E' post finisher studs to alpine light trim.
7.Fit rear speaker.
See ELECTRICAL, Repair,
rear speaker.

CHASSIS AND BODY
69
REPAIR FRONT SEAT BELTS - 5 DOOR (96 MODELS)
Service repair no - 76.73.10
Remove
1.Move the seat to gain access to the seat belt
mountings.
2.Remove the cover and securing bolt to release
the upper mounting and spacer from the 'B' post
adjustable mounting.
3. Electric seats only:Release fixings securing
the seat side valance.
4.Remove the side valance.
5.Remove the Torx bolt securing the lower
mounting to the seat.
6.Detach the door seals from the 'B' post
sufficiently to allow removal of the lower trim
panel from the post.
7.Release the seat belt from the split section at the
top of the trim panel and withdraw the panel.

80HEATING AND VENTILATION
6
REPAIR BLOWER MOTOR UNIT - HEATER AND AIR
CONDITIONING
Service repair no - 80.20.17
Service repair no - 82.25.54.
Remove
1.Move seats to rear most position.
2.Disconnect battery negative lead.
3.Remove fascia panel assembly.
See CHASSIS
AND BODY, Repair, Dash Panel Assembly
4.Remove 2 nuts securing lower brackets to
toeboard.
5.Manoeuvre blower unit from heater unit and
remove.
Refit
6.Reverse removal procedure. Ensure seal
between blower and heater unit is tight.BLOWER MOTOR
Service repair no - 80.20.17
Service repair no - 82.25.33.
Remove
1.Remove blower motor unit.
See Blower Motor
Unit - Heater and Air Conditioning
2.Release wiring harness retaining clip.
3.Remove 3 screws securing casing.
4.Remove blower motor assembly.

86ELECTRICAL
26
REPAIR TRAILER SOCKET
Remove
1.If fitted remove the RH side facing seat
See
CHASSIS AND BODY, Repair, Rear Fold
Down Seats
2.Remove the rear lower side trim panelSee
CHASSIS AND BODY, Repair, Rear
Compartment Lower Trim Panels
3.Raise the carpet adjacent to the RH rear quarter
panel.
4.Disconnect the trailer socket lead multi-plug from
the RH body harness.
5.Displace the rubber grommet in the floor and
pass the socket lead through to the underside of
the vehicle.
6.Remove the securing screws and withdraw the
trailer socket from the towing hook mounting
bracket.
Refit
7.Reverse removal procedure.