1995 LAND ROVER DISCOVERY cruise control

CRUISE CONTROL
7
REPAIR CRUISE CONTROL ECU - V8i
Service repair no - 19.75.49
Remove
1.Remove lower dash panel.
2.Disconnect ECU multi-plug.
3.Remove ECU fixing.
4.Remove ECU.
5.Reverse removal procedure. Ensuring that
electrical multi-plug is securely reconnected.
SPEED TRIP ECU - MANUAL V8i
NOTE: The neutral lock out relay
module/speed trip ECU is mounted in the
right hand side footwell. To identify
components.
See Electrical Trouble Shooting
Manual.
VEHICLE SPEED SENSOR
Service repair no - 18.30.22
For Tdi
See FUEL SYSTEM Tdi, Repair, Vehicle
Speed Sensor
For V8iSee FUEL SYSTEM MFI, Repair, Vehicle
Speed Sensor
NEUTRAL LOCK OUT RELAY
Service repair no - 19.75.28
1.Remove 3 studs securing fascia right hand side
closing panel.
2.Release and move closing panel aside.
3.Remove 2 studs securing right hand side 'A' post
lower trim casing.
4.Remove casing.
5.Locate relay (neutral coloured base) and release
base from bracket.
6.Remove relay.
NOTE: For further information.See
Electrical Trouble Shooting Manual.
Refit
7.Reverse removal procedure.

CRUISE CONTROL
9
REPAIR CRUISE CONTROL ECU - Tdi
Service repair no - 19.75.49
Remove
1.Remove 4 studs securing fascia left hand
closing panel.
2.Remove closing panel.
3.Remove nut securing ECU/relay bracket.
4.Lower bracket for access.
5.Remove bottom nut securing ECU to bracket.
6.Open glove box, align stops with cut-outs in
fascia panel and lower.
7.Move SRS harness aside.
8.Remove top nut securing ECU to bracket.
9.Disconnect ECU multiplug.
10.Remove ECU.
Refit
11.Reverse removal procedure. Ensure electrical
multiplug is securely reconnected.

STEERING
3
DESCRIPTION AND OPERATION Steering column components
1. Upper shroud
2. Column harness
3. Cruise control switch (if fitted)
4. Steering wheel and nut
5. Rotary coupler
6. Column switch
7. Shear bolts
8. Switch saddle
9. Upper steering column
10. Universal joint
11. Universal joint bolt
12. Steering column lock assembly13. Lower shroud
14. Column lock/ignition
15. Air bag mounting bracket (if fitted)
16. Air bag module
17. Steering pad (non-airbag)
18. Lower shaft
19. Rubber coupling
20. Compression joint
21. Universal joint
22. Universal joint bolt

SUPPLEMENTARY RESTRAINT SYSTEM
3
REPAIR
8.Disconnect harness connector from airbag
module.
9.Remove airbag module.
CAUTION: Store the airbag module in
accordance with the storage procedures
outlined in Description and Operation.
NOTE: If airbag module is to be replaced
the serial numbers must be recorded in
the vehicle service record.
Refit
10.Reverse removal procedure.
11.Connect harness connector to airbag module
with harness downwards (as shown at 8).
12.Position airbag module on steering wheel and
engage retained screws. Use special socket to
tighten screws to
8Nm (6 lbf ft).
CAUTION: Take care not to cross thread
screws.
13.Check Supplementary Restraint System using
Testbook.STEERING WHEEL
Service repair no - 57.60.01
Remove
1.Remove driver's airbag module.
See driver's
airbag module.
2.Position steering wheel so the road wheels are
in the straight ahead position.
3.Disconnect cruise control switch connector
(where fitted) from rotary coupler harness.
4.Release harnesses from clip on steering wheel.
5.Remove steering wheel nut.
6.Release steering wheel from column.
7.Feed harnesses through hole in steering wheel.
8.Remove steering wheel.
CAUTION: Prevent rotation of rotary
coupler once steering wheel is removed.
Secure in position with adhesive tape.

HEATING AND VENTILATION
5
REPAIR RECIRCULATION SWITCH
Service repair no - 80.10.27
Remove
1.Release fascia centre louvre vent panel from its
fitted position to gain access to rear of panel.
See CHASSIS AND BODY, Repair, Dash
Panel Central Louvre Panel
2.Disconnect multiplug from switch
3.From the rear, push switch out of panel.
Refit
4.Reverse removal procedure.RECIRCULATION FLAP SOLENOID
Service repair no - 80.10.43
Remove
1.Open glove box, manoeuvre side springs
through cut-outs and lower lid.
2.Remove 2 locknuts securing cruise control ECU
to bracket.
3.Position cruise control ECU aside.
4.Remove 2 screws securing recirculation
solenoid to casing.
5.Release solenoid from lever.
6.Disconnect multiplug and remove solenoid.
Refit
7.Reverse removal procedure.

ELECTRICAL
1
REPAIR FUSE BOX - INTERIOR
Right Hand Drive shown
The interior fusebox is fitted below the steering column, behind the trim panel. It comprises of three integral units.
'A'Main fusebox,'B'Satellite 2,'C'Satellite 1.
A label in the fusebox cover shows the circuits protected, the fuse rating and their locations. Access is by
releasing the fixing screws and lowering the panel.
'A' Main fusebox
1. Stop lights, direction indicators
2. LH side light
3. Radio/cassette/CD player
4. RH headlight main beam
5. LH headlight main beam
6. Cigar lighter
7. Airbag SRS
8. RH side lights
9. Rear fog guard lights
10. RH headlight dipped beam
11. LH headlight dipped beam
12. Multi-function unit
13. Ignition feed for Multi-function unit
14. Instruments, reversing lights
15. Air conditioning, windows
16. Washers & wipers - front
17. Starter, glow plug
18. Wash/wipe - rear, mirrors, cruise control
'B' Satellite 2
1. Electric windows - front
2. Electric windows - rear
3. Anti-lock braking
4. Central door locking
5. Electric sun roof
6. Trailer lights
'C' Satellite 1
1. Anti-theft alarm
2. Headlight washers
3. Engine management
4. Anti-lock brakes
5. Anti-theft alarm
6. Rear air conditioning, heater
'D' Spare fuses (5 off)