1995 LAND ROVER DISCOVERY warning

86ELECTRICAL
2
REPAIR FUSE BOX - ENGINE COMPARTMENT
The fusebox is located on the right side of the engine compartment. The circuits protected and their locations are
shown on the inside of the fusebox cover. To change a main circuit fuse prise off protective cover A and remove
retaining screws.
Fuses
1. Heated rear window
2. Sidelights
3. Air conditioning
4. Hazard warning lights, horn
5. ABS valve
6. Fuel pump
7. Fuel injectors
A Main circuit fuses
8. ABS pump
9. Ignition circuits
10. Lighting
11. Window lift, central door locking, rear blower
12. Heater, air conditioning
13. Generator

ELECTRICAL
3
REPAIR BATTERY
Service repair no - 86.15.01
NOTE: Some vehicles are fitted with a
battery backed-up sounder. Disconnecting
the vehicle battery will cause the alarm to
sound unless the following procedure is followed:
1.Turn starter switch 'ON' then 'OFF'.
2.Disconnect battery WITHIN 15 SECONDS (see
WARNING).
If alarm is accidentally activated, ensure sounder is
connected and silence by turning the starter switch to
position II.
Remove
WARNING: During battery removal or
before carrying out any repairs or
maintenance to electrical components
always disconnect battery negative lead first. If
positive lead is disconnected with negative lead in
place, accidental contact of wrench to any
grounded metal part could cause a severe spark,
possibly resulting in personal injury. Upon
installation of battery connect positive lead first.
3.Disconnect both battery leads, negative first.
4.Release four nuts securing battery bracket in
position.
5.Remove bracket.
6.Remove battery.
Refit
7.Reverse removal procedure.
NOTE: Coat battery clamps and terminals
with petroleum jelly before refitting.DISTRIBUTOR-LUCAS 35 DLM8 - V8i
Service parts
1. Cap
2. HT brush and spring
3. Rotor arm
4. Insulation cover
5. Pick-up module and base plate assembly
6. Vacuum unit
7. Amplifier module
8. 'O'-ring oil seal
9. Gasket

86ELECTRICAL
8
REPAIR PARK BRAKE WARNING SWITCH
Service repair no - 86.65.45
Remove
1.Disconnect battery negative lead.
2.Remove four screws and move aside window lift
switch panel.
3.Remove two screws, manoeuvre switch from
park brake and disconnect electrical lead.
Refit
4.Reverse removal procedure.GEAR SELECTOR-INTERLOCK
Interlock solenoid
Remove
1.Disconnect battery negative lead.
2.Remove gear selector head and illumination
panel.
See CHASSIS AND BODY, Repair,
Centre console
3.Disconnect electrical multiplug.
4.Remove screws and lift gear selector
mechanism above housing.
5.Remove screws from microswitch support
bracket.
6.Remove screws and separate side cover from
housing.

86ELECTRICAL
30
REPAIR INSTRUMENT ILLUMINATION AND WARNING
LIGHT BULBS
Service repair no - 86.45.48 - Instrument
Service repair no - 86.45.61 - Warning light
Remove
1.Remove binnacle.
See Instrument binnacle
2.Identify bulb to be replaced.
NOTE: If faulty bulb is not accessible,
remove screws securing circuit board and
carefully ease circuit board aside.
3.Rotate bulb holder anti-clockwise, withdraw bulb
holder and remove bulb.Refit
4.Fit new bulb to holder.
CAUTION: Ensure bulb of correct wattage
and type is fitted.
5.Reverse removal procedure.

ELECTRICAL
31
REPAIR MAIN PRINTED CIRCUIT
Service repair no - 88.20.19
Remove
1.Remove instrument cowl.
See Instrument
cowl and illumination board
2.Remove circuit board.See Circuit board
3.Remove illumination and warning lamp bulbs.
4.Remove 13 screws securing main printed circuit,
remove circuit.
Refit
5.Position main printed circuit to binnacle.
6.Ensure screw holes in instruments are aligned
with holes in binnacle, fit and tighten screws.
7.Reverse removal procedure. 1 and 2.

86ELECTRICAL
34
REPAIR PRINTED CIRCUIT AND WARNING LIGHTS
1. Panel illumination bulbs
2. Transmission oil temperature warning lamp bulb
3. Hazard warning lamp bulb
4. Check engine warning lamp bulb
5. Handbrake/brake fluid warning lamp bulb
6. ABS warning lamp bulb
7. Headlamp main beam warning lamp bulb
8. Trailer direction warning lamp bulb9. Direction indicator warning lamp bulb
10. Air suspension warning lamp bulb
11. Ignition/no charge warning lamp bulb
12. Seat belt warning lamp bulb
13. Not used
14. Traction control warning lamp bulb
15. Diesel heater plug warning lamp bulb (if fitted)
16. Main printed circuit

ELECTRICAL
39
REPAIR CIGAR LIGHTER AND BULB
Service repair no - 86.65.60
Service repair no - 86.45.55
Cigar Lighter
Remove
1.Remove centre console.
See CHASSIS AND
BODY, Repair, Centre Console
2.Depress lugs securing cigar lighter, withdraw
lighter from centre console.
Bulb replacement
3.Remove bulb from holder.
Refit
4.Reverse removal procedure.OIL PRESSURE WARNING SWITCH - V8i
Service repair no - 86.65.30
Remove
1.Disconnect the battery negative lead.
2.Disconnect electrical lead.
3.Unscrew switch unit.
4.Remove switch and sealing washer.
Refit
5.Reverse removal procedure. Using a NEW
sealing washer.

86ELECTRICAL
44
REPAIR BONNET SWITCH
Service repair no - 86.55.89
Remove
1.Remove 2 bolts securing sounder, move
sounder aside.
2.Locate and disconnect bonnet switch multiplug.
3.Release and remove switch.
Refit
4.Reverse removal procedure.ULTRASONIC SENSOR
Service repair no - 86.77.32
Remove1.Release sensor from switch panel.
2.Disconnect multiplug and remove sensor.
Refit
3.Reverse removal procedure.
ANTI-THEFT ALARM INDICATOR LIGHT (96
MODELS)
Service repair no - 86.45.61
See Instrument illumination and warning light
bulbs
ENGINE IMMOBILISATION WARNING LIGHT (96
MODELS)
Service repair no - 86.45.61
See Instrument illumination and warning light
bulbs