ELECTRICAL
43
REPAIR ANTI-THEFT ALARM ECU (96 MODELS)
Service repair no - 86.55.85
Remove
1.Remove 4 studs securing fascia left hand
closing panel.
2.Remove closing panel.
3.Disconnect 2 multiplugs from ECU.
4.Remove nut securing ECU/relay bracket.
5.Lower bracket.
6.Remove 2 nuts securing ECU to bracket.
7.Remove ECU.
NOTE: A new ECU must be initialised
using TestBook.
Refit
8.Reverse removal procedure.HANDSET (96 MODELS)
If vehicle does not respond to handset immediately, it
may have lost synchronisation. To re-synchronise,
press either button, 4 times in quick succession. If
handset still fails to respond, check batteries, refer to
Owner's handbook. If batteries are okay, it may be
necessary to use emergency key access, refer to
Owner's handbook.
NOTE: New handsets must be initialised
using TestBook.
PASSIVE COIL (96 MODELS)
Service repair no - 86.77.35
Remove
1.Remove steering column shroud.
See
STEERING, Repair, Steering column shroud
2.Release multiplug from harness clip and
disconnect.
3.Release passive coil from starter switch.
4.Remove bulb holder/starter switch shroud.
5.Remove coil.
Refit
6.Fit coil, ensuring switch illumination bulb harness
passes through large cut-out.
7.Secure coil with cable tie.
8.Position bulb holder/starter switch shroud and
locate bulb.
9.Locate bulb holder/starter switch shroud,
ensuring cut-out in shroud aligns with lug on
starter switch.
10.Connect multiplug and secure to clip.
11.Fit column shroud.
86ELECTRICAL
2
OVERHAUL
LUBRICATION
Apply clean engine oil:
a. A spot into rotor spindle before fitting rotor
arm.
Apply Omnilube 2 (or equivalent) grease.
b. Auto advance mechanism.
c. Pick-up plate centre bearing.
d. Pre tilt spring and its rubbing area (pick-up
and base plate assembly).
e. Vacuum unit connecting peg (pick-up and
base plate assembly).
f. Connecting peg hole in vacuum unit
connecting rod.
Fitting pick-up and base plate assembly
1.Pick-up leads must be prevented from fouling
rotating reluctor. Both leads should be located in
plastic guide as illustrated. Check during
re-assembly.
Fitting reluctor
2.Slide reluctor as far as it will go on rotor shaft,
rotate reluctor until it engages with coupling ring
beneath pick-up base plate. Distributor shaft,
coupling ring and reluctor are 'keyed' and rotate
together. Fit 'O' ring, flat washer and retaining
circlip.Pick-up air gap adjustment
1.Air gap between pick-up limb and reluctor teeth
must be set within specified limits, using a
non-ferrous feeler gauge.
2.If adjustment is necessary, loosen two barrel
nuts to set the air gap.
See ENGINE TUNING
DATA, Information, Engine 3.9 V8i
NOTE: When original pick-up and base
plate assembly has been refitted, air gap
should be checked, and adjusted if
necessary.
When fitting a new assembly air gap will require
adjusting to within specified limits.
Amplifier module
1.Before fitting module, apply MS4 Silicone grease
or equivalent heat-conducting compound to
amplifier module backplate, seating face on
distributor body and both faces of heatsink
casting.
