1995 LAND ROVER DISCOVERY differential

STEERING
17
REPAIR 3.Bend back tabs on locking washer and remove
drop arm using extractor LRT-57-012. Loosen
drop arm securing nut, but do not remove before
using extractor.
4.Remove nut, discard locking washer.
Refit
5.Centralise steering box.
See Adjustment,
Centralise Steering Box
6.Fit drop arm, align master splines.
7.Fit a new tab washer and drop arm fixing nut.
Tighten to
176 Nm,bend over tab.
8.Fit drag link. Tighten ball joint nut
40 Nm.
STEERING DAMPER
Service repair no - 57.55.21
Remove
1.Site vehicle on a ramp [hoist].
2.Remove fixings at differential case bracket.
3.Remove fixings at track rod bracket.
4.Remove steering damper.
Refit
5.Reverse removal procedure. 1 to 4.

ELECTRICAL
25
REPAIR STARTER MOTOR - Mpi
Service repair no - 86.60.01
Remove
1.Disconnect battery negative lead.
2.Remove 2 nuts securing cables to starter
solenoid; release cables.
3.Remove 3 bolts securing starter motor.
4.Manoeuvre starter motor clear of bell housing.
5.Remove starter motor.Refit
6.Clean mating faces of starter motor and
differential housing.
7.Manoeuvre starter motor into position.
8.Fit mounting bolts and Tighten to
45 Nm.
9.Connect battery cables to starter solenoid; fit
nuts and tighten to the correct torque.
10.Reconnect battery negative lead.

ELECTRICAL
47
REPAIR
10.From above, remove top bolt securing starter
motor and position earth lead aside.
NOTE: To assist removal, use 230 mm
extension bar positioned between engine
mounting bracket and exhaust manifold.
11.Remove bottom bolt securing starter motor.
12.Remove starter motor.Refit
13.Ensure mating faces are clean.
14.Locate starter motor in fitted position and fit
bottom bolt finger tight.
15.Fit top bolt. Tighten to
42 Nm.
16.Bottom bolt. Tighten to42 Nm.
17.Connect feed wires to solenoid terminal. Secure
with nut.
18.Connect Lucar to starter solenoid.
19.Manoeuvre heat shield down and forward to
position bracket against engine mounting.
Engage clip on solenoid.
20.Align bracket to hole using suitable tool and fit
retaining bolt.
21.Clean flange mating surfaces, locate propeller
shaft and align reference marks.
22.Fit bolts and NEW nyloc nuts. Tighten to
48 Nm.
NOTE: Fit bolts with head towards transfer
box and away from differential.
23.Lower vehicle.
24.Reconnect battery negative lead.