ELECTRICAL
27
REPAIR WINDOW LIFT MOTOR - FRONT
Service repair no - 86.25.04
Remove
1.Ensure that the window glass is in its fully closed
position and secure it with adhesive tape.
2.Disconnect battery negative lead.
3.Remove the door pull, trim panel, and plastic
vapour barrier.
See CHASSIS AND BODY,
Repair, Front Door Trim Panel
4.Release the window lift motor wiring harness
from the three retaining clips to allow the
harness to be pulled out of the opening at the
front of the inner door panel.
5.Disconnect the window lift motor harness
multi-plug from the main door harness.
6.Support the motor, remove the three securing
bolts and withdraw the motor through the top
front opening of the door panel.
Refit
7.Reverse removal procedure.
NOTE: Ensure drive gear is engaged and
correctly aligned with window lift linkage
before fitting securing bolts.WINDOW LIFT MOTOR - REAR
Service repair no - 86.25.09
Remove
1.Ensure that the side door glass is in the fully
closed position and secure with adhesive tape.
2.Disconnect battery negative lead.
3.Remove the door pull, trim panel and plastic
vapour barrier.
See CHASSIS AND BODY,
Repair, Rear Side Door Trim - Panel
4.Disconnect the lift motor harness multi-plug from
the door harness.
5.Support the motor and remove the three
securing screws.
6.Withdraw the motor through the lower opening in
the inner door panel.
Refit
7.Reverse removal procedure.
NOTE: Ensure drive gear is engaged and
correctly aligned with window lift linkage,
before fitting securing bolts.
86ELECTRICAL
40
REPAIR INSTRUMENT ILLUMINATION ELECTRONIC
DIMMER/RHEOSTAT
Service repair no - 86.65.07
Electronic dimming control switch is located in
instrument panel finisher. Rotate control to vary
intensity of illumination.
Remove
1.Disconnect the battery negative lead.
2.Remove instrument panel finisher.
See
CHASSIS AND BODY, Repair, Instrument
Panel Finisher
3.Remove 2 screws securing rheostat, remove
rheostat.
Refit
4.Reverse removal procedure.WINDOW LIFT/HEATED SEAT CUSHION
SWITCHES AND BULBS
Service repair no - 86.25.16 - Switches
Service repair no - 86.45.29 - Bulb
Switch Replacement
1.Disconnect the battery negative lead.
2.Carefully release rear of surround from centre
console.
3.Remove screws, pry window lift switch surround
from glove box.
4.Disconnect multi-plug(s) at rear of switch(es).
5.Apply pressure to rear of switch, push it through
surround.
Bulb replacement
6.Identify bulb to be replaced and remove
appropriate switch.
7.Rotate bulb holder 90°and withdraw it from
switch; discard bulb and holder.
Refit
8.Reverse removal procedure.
