1995 CHEVROLET TRACKER belt

Lap-Shoulder Belt
The rear seats have lap-shoulder belts. Here’s how to
wear one properly.
1. Pick up the latch plate and pull the belt across you.
Don’t let it get twisted.
The shoulder belt may lock
if you pull the belt across
you very quickly.
If this happens, let the belt go back
slightly to unlock
it. Then pull the belt across you
more slowly.
2. Push the latch plate into the buckle until it clicks.
Pull up
on the latch plate to make sure it is secure.
When the shoulder belt is pulled out all the way, it
will lock.
If it does, let it go back all the way and
start again. If the belt is not long enough, see “Safety
Belt Extender” at the end
of this section. Make sure
the release button on the buckle is positioned
so you
would be able to unbuckle the safety belt quickly if
you ever had to.
3. To make me lap part tight, pull aown on the buckle
end
of the belt as you pull up on the shoulder part.
1-22
ProCarManuals.com

force to the strong pelvic bones. And you’d be less
likely to slide under the
lap belt. If you slid under it, the
belt would apply force at your abdomen.
This could
cause serious
or even fatal injuries. The shoulder belt
should
go over the shoulder and across the chest. These
parts
of the body are best able to take belt restraining
forces.
The safety belt locks
if there’s a sudden stop or a crash,
or if you pull the belt very quickly out of the retractor.
The lap
part of the belt should be worn low and snug on
the hips, just touching the thighs. In a crash, this applies
ProCarManuals.com

To unlatch the belt, just push the button on the buckle.
Children
Everyone in a vehicle needs protection! That includes
infants and all children smaller than adult size.
In fact,
the law in every state in the United States and
in every
Canadian province
says children up to some age must be
restrained while in
a vehicle.
Smaller Children and Babies
ProCarManuals.com

Child Restraints
Be sure to follow the instructions for the restraint. You
may find these instructions on the restraint itself or in a
booklet,
or both. These restraints use the belt system in
your vehicle, but the child also has to be secured within
the restraint to help reduce the chance
of personal injury.
The instructions that come with the infant or child
restraint will show you how to do that.
Where to Put the Restraint
Accident statistics show that children are safer if they
are restrained in the rear rather than the front seat. We at
General Motors therefore recommend that you put your
child restraint in the rear seat unless the child is an
infant and you’re the only adult in the vehicle. In that
case, you might want to secure the restraint in the front
seat where you can keep an eye on
the baby. Wherever
you install it, be sure to secure the child
restraint properly.
Keep in mind that an unsecured child restraint can move
around
in a collision or sudden stop and injure people in
the vehicle. Be sure to properly secure any child
restraint
in your vehicle -- even when no child is in it.
Top Strap
Some child restraints have a top strap. Don’t use a
restraint like that
in your vehicle because the top strap
anchor cannot be installed properly.
You shouldn’t use
this type of child restraint without anchoring the top
strap.
1-26 -. ProCarManuals.com

Securing a Child Restraint in a Rear Seat
Position
4. Buckle the belt. Make sure the release button is
positioned so you would be able to unbuckle the
safety belt quickly if you
ever had to.
You'll be using the lap-shoulder belt.
See the earlier part
about the top strap if the child restraint has one.
1. Put the restraint on the seat. Follow the instructions
for the child restraint.
2. Secure the child in the child restraint as the
instructions say.
3. Pick up the latch plate, and run the lap and shoulder
portions of the vehicle's safety belt through
or
around the restraint. The child restraint instructions
will show
you how.
If the shoulder belt goes in front of the child's face or
neck, put it behind the child restraint.
5. Pull the rest of the shoulder belt all the way out of
the retractor to set the lock.
ProCarManuals.com

6. To tighten the belt, feed the shoulder belt into the
retractor while you push down on the child restraint. 7. Push and pull the child restraint in different
directions to be sure it is secure.
To remove the child restraint, just unbuckle the vehicle’s
safety belt and let it
go back all the way. The safety belt
will move freely again and be ready to work for
an adult
or larger child passenger.
1-28
ProCarManuals.com

Securing a Child Restraint in the Right
Front Seat Position
You'll be using the lap-shoulder belt. See the earlier part
about the top strap if the child restraint has
one.
1. Move the seat as far back as it will go. (See "Seats"
in the Index.)
2. Put the restraint on the seat. Follow the instructions
for the child restraint,
3. Secure the child in the child restraint as the
instructions say.
4. Pick up the latch plate, and run the lap and shoulder
portions of the vehicle's safety belt through or
around the restraint. The child restraint instructions
will
show you how.
If the shoulder belt goes in front of the child's face or
neck, put it behind the child restraint.
5. Buckle the belt.
Make sure the release button is positioned
so you
would be able to unbuckle the safety belt quickly if
you ever had
to.
ProCarManuals.com

6. Pull the rest of the shoulder belt all the way out of
the retractor to set the lock.
I 7. To tighten the belt, feed the shoulder belt back into
the retractor while you push down on the child
restraint.
8. Push and pull the child restraint in different
directions to be sure it is secure.
To remove the child restraint, just unbuckle the vehicle’s
safety belt and let
it go back all the way.
The safety belt will move freely again and be ready to
work for an adult or larger child passenger.
1-30
ProCarManuals.com