1995 CADILLAC ELDORADO ignition

Downloaded from www.Manualslib.com manuals search engine Power Antenna Mast Care
Your power antenna will look its best and work well if it’s cleaned from
time to time.
To Clean the Antenna Mast
1. Turn on the ignition and radio to raise the antenna to full mast
2. Dampen a clean cloth with mineral spirits or an equivalent solvent.
3. Wipe the cloth over the mast sections, removing any dirt.
4. Wipe dry with a clean cloth before retracting.
5. Make the antenna go up and down by turning the radio or ignition on
6. Repeat if necessary.
extension.
and
off.
NOTICE:
Don’t lubricate the power antenna. Lubrication could damage it.
NOTICE:
Before entering an auromarrc car wasn, turn off your radio to
make the power antenna go down.
This will prevent the mast
from possibly getting damaged.
If the antenna does not go down
when you turn the radio
off, it may be damaged or need to be
cleaned.
In either case, lower the antenna by hand by carefully
pressing the antenna down.
3-21

Downloaded from www.Manualslib.com manuals search engine Ignoring these steps could result in costly damage to your
vehicle that wouldn’t be covered by your warranty.
wing to start your Cadillac by pushing or pulling it won’t
work
and it could damage your vehicle.
TO JUMP START YOUR CADILLAC
1. Check the other vehicle. It must have a 12-volt battery with a negative
ground system.
NOTICE:
If the other system isn’t a 12-volt system with a negative ground,
both vehicles can be damaged.
2. Get the vehicles close enough so the jumper cables can reach, but be
sure the vehicles aren’t touching each other.
If they are, it could cause
a ground connection you don’t want. You wouldn’t be able to start
your Cadillac and
the bad grounding could damage the electrical
systems.
3. Turn off the ignition on both vehicles. Turn off all lamps that aren’t
needed and radios. This will avoid sparks and help save both batteries
as well as avoiding damage to any of the accessories.
5-4

Downloaded from www.Manualslib.com manuals search engine When your vehicle is being towed, have the ignition key off. The steering
wheel should
be clamped in a straight-ahead position, with a clamping
device designed for towing service.
Do not use the vehicle’s steering
column lock
for this. The transaxle should be in NEUTRAL (N) and the
parking brake released.
Don’t have your vehicle towed
on the front wheels, unless you must. If the
vehicle must
be towed on the front wheels, don’t go more than 35 mph
(56 km/h) or farther than 25 miles (40 km) or your transaxle will be
damaged. If these limits must be exceeded, then the front wheels have
to be supported on a dolly.
5-1 1

Downloaded from www.Manualslib.com manuals search engine WIPER BLADE REPLACEMENT
To replace the entire wiper blade, follow these steps:
1. Position the windshield wipers on the windshield in the “mid” wipe
position.
To do this, turn the ignition key to ACCESSORY and turn
the wipers
on. Then with the door open, turn the ignition key to OFE
“I I
1
2. Insert the tip of a small screwdriver into the slot as shown and gently
press down
to release the wiper blade from the arm.
3. To install the wiper blade, align the wiper arm pin with the hole on the
wiper blade assembly and snap
it into place. Return the wipers to their
normal position.
If you only want to replace the wiper insert, follow these steps:
1. Position the windshield wipers on the windshield in the “mid” wipe
position.
To do this, turn the ignition key to ACCESSORY and turn
the wipers on. Then with the door open, turn the ignition key to OFF.
2. Insert the tip of a small screwdriver into the slot as shown and gently
3. Insert a small coin between the edge of the blade housing and the
press down
to release the wiper blade from the arm.
rubber blade insert.
4. Carefully apply pressure until the insert clears one side of the housing tabs.
5. Now pull the insert from the blade housing.
6-4 1

Downloaded from www.Manualslib.com manuals search engine [Engine Compartment Fuse Block
~~~
E DISTR
USAGE I
INJ
IGN 1
FUEL PUMP
PCM (BAT) RTD (BAT)
F
A/C COMP
HDLPS
TURN/HAZ
DRL
DRL
HTD W/S
IGN OFF
L HDLP
LO
I R HDLP LO Ignition
Control Module
I
L HDLP HI
R HDLP HI
I
I
TRANSECS Sensing
& Diagnostic Module
Powertrain Control Module (PCM); PASS-KeymII Decode llodule
1,4,6 and 7 Fuel Injectors
2,3,5 and 8 Fuel Injectors
A/C Refrigerant Pressure Switch; Transaxle Range Switch;
Stop/BTSI/Cruise Brake Switch; Instrument Panel Cluster; Keyless
Entry Module; DiagnosticEnergy Reserve Module (Derm);
Cornering Lamps; Tbrn/Hazard Switch Assy; Chime Module;
Headlamp Switch; Twilight Sentinel/DRL Module
Fuel Pump; Oil Pressure Switch; Powertrain Control Module
Powertrain Control Module (PCM)
Road Sensing Suspension (RSS) Module
NC Compressor Clutch
Headlamp Dimmer Switch; Headlamp Relay “D” (Engine Comp.
Micro Relay Center); DRL Headlamp Relay
“E’ (with Daytime
Running Lamps); Powers C13
Stop/BTSI/Cruise Switch; Sto lamp Switch Capacitor; Anti-Slip
Regulation (ASR)S Traction 8ontrol
Hazard Flasher; Turn Flasher Relay; Turn Flasher Module
Daytime Running Lamps (Canada)
Left and Right Lo-Beam Headlamp (Canada)
Heated Windshield Control Module
Instrument Panel Cluster
Left Lo-Beam Headlamu
(PCM)
Right Lo-Beam Headlamp
Left Hi-Beam Headlamp
Right Hi-Beam Headlamp
Rear Defogger Relay; Electronic Level Control (ELC); Heated
Windshield; Heater and A/C Programmer; Cruise Control
Extended Travel Brake Switch; Powertrain Control Module (PCM); \
Cooling Fan Relays
1,2 and 3; Front and Rear Heated Oxygen Sensor
Power Steering Pressure Switch; Exhaust Gas Recirculation (EGR)
Valve; Transaxle Shift Solenoids A
& B; Evaporative Emission
Control Solenoid; Powertrain Control Module (PCM); Torque
Converter Clutch Solenoid; TCC Brake Switch
6-65

Downloaded from www.Manualslib.com manuals search engine Horn ............................................. 2-37
Hydroplaning
...................................... 4-19
I
If You’re Stuck: In Sand. Mud. Ice or Snow ............. 5-31
Ignition Key Positions
............................... 2-19
Ignition Switch
..................................... 2-19
Illuminated Entry System
............................. 2-6
Information Button. Driver Information Center ......... 2-84
Instrument
Panel Cluster ............................ 2-69
Analog
......................................... 2-70
Canadian Analog
................................ 2-70
Digital
......................................... 2-69
Instrument Panel Intensity Control
.................... 2-50
Instrument Panel. Cleaning
.......................... 6-55
Interior Lamps ...................................... 2-50
J
Jack. Tire ......................................... 5-23
Jump Starting ....................................... 5-3
Keyless Entry System
......................... 2.7.2.8. 2.9
Keys .............................................. 2-1
L
Lamp Housings. Exterior ............................ 6-34
Lamps
............................................ 2-49
Cornering
...................................... 2-52
Daytime Running
................................ 2-53
Lamp. Malfunction Indicator
......................... 2-78
Lamp. Underhood
.................................. 2-52
Fog ............................................ 2-51
Interior
........................................ 2-50
On Reminder ................................... 2-50
Reading ........................................ 2-54
RearFog ....................................... 2-52
Lane Change Indicator
.............................. 2-39
Larger Children. Safety Belt Use
...................... 1-48
Latches.
Front Seatback .............................. 1-6
Leaving Your Vehicle ................................ 2-6
. ._
8