Page 1 of 15
17-1
 
  
Lubrication system 
components, removing and 
installing  Special tools
 
The following special tools and test equipment are 
required for these operations  
VAG 1342  
Oil pressure tester  
VAG 1527  
Voltage tester  
Pa
ge 1 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 3 of 15
17-3
 
  
6 - 
Oil pan, lower 
7 - 
10 Nm (7 Nm) 
8 - 
Oil drain plug 
40 Nm (30 ft lb)
9 - 
Cover With integrated 5 bar (72 psi) and 11 bar 
(159 psi) pressure relief valves 
10 - 
Oil cooler 
11 - 
Oil filter NOT interchangeable with older versionRevised lubrication system requires 
different filter: Part no. 078 115 561 D 
Pa
ge 3 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 7 of 15
17-6
 
  
Revised oil circulation system
 
Note: 
 
Modifications compared to previous 2.8 liter V6 
(Audi 90, Audi 100). 
 Only the modified components should be 
installed on this engine. 
1 - 
Oil filter 
Larger outer dimensions
2 - 
Oil cooler Larger cross-sectional flow area
3 - 
Cover for oil pan New
4 - 
Pressure relief valve New
5 - 
Oil supply to engine 
6 - 
Oil pump New
Pa
ge 7 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 8 of 15
17-7
 
  
7 - 
Pressure relief valve 11 bar 
New
8 - 
Oil pick-up New
9 - 
Oil pressure switch 1.8 bar Color: BrownChecking  page 17
-9
Dynamic oil pressure warning system 
function  page 17
-11
 
Pa
ge 8 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 9 of 15
17-8
 
  
Function of revised oil circulation  
Intake side 
Oil is taken in from the oil pump -6- via the oil pick-
up pipe -8-.  
Pressure side 
Oil pressure comes from the oil pump -6- through 
the upper part of the oil pan past the pressure relief 
valve -7-, oil pressure switch -9-, oil cooler -2- and 
oil filter -1- to the pressure relief valve -4-.  
Pressure relief valve -4- controls the oil pressure to 
the engine.  
The pressure relief valve -7- is a safety valve that 
opens only at high RPM and cold engine 
temperature.  
Advantages 
Oil pressure is controlled from the oil filter and oil 
cooler, so that the oil pressure available at those 
locations is supplied via the pressure relief valve -4- 
or from the oil pump.  
Pa
ge 9 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 10 of 15
17-9
      
Oil pressure and oil pressure switch, 
checking
 
      Operational test and servicing the visible and 
audible oil pressure indicator:  
     
       Electrical Wiring Diagrams, Troubleshooting 
 Component Locations binder.   
     
Test requirements  
     
Oil level OK 
     Oil pressure warning light -K3- comes on 
with ignition on 
     Auto-Check system indication OK, if 
applicable. 
     Engine oil temperature approx. 80 C (176
F) and radiator coolant fan must have 
switched on at least once 
     
Checking oil pressure switch  
     
-  Disconnect harness connector from oil pressure 
switch. 
Pa
ge 10 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 11 of 15
    
-  Remove oil pressure switch and install into oil pressure tester VAG 
1342. 
-  Connect cable -2- (brown) to Ground (GND).
-  Connect cable -1- (blue) to oil pressure switch.
-  Connect VAG 1527B voltage tester to cable -1- and battery positive 
voltage (B+). 
Pa
ge 11 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1 
     
        
        Page 12 of 15
17-10
      
-  Start engine and slowly increase engine speed 
(RPM). 
     
At 1.6-2.0 bar (23-29 psi) pressure, the LED 
must come on 
      If not:  
     
-  Replace 1.8 bar oil switch.
Pa
ge 12 of 15 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.17.1