1994 PONTIAC FIREBIRD ECU

7. Push and pull the child restraint in
different directions
to be sure it is
secure.
To remove the child restraint, just
unbuckle the vehicle's safety belt and
remove the locking clip. Let the safety
belt
go back all the way. The safety belt
will move freely again and
be ready to work
for an adult or larger
child passenger.
37. .
ProCarManuals.com

Parking Lots: If you park in a lot where
someone will be watching your vehicle,
it's best to lock it up and take your keys.
But what if you have to leave your
ignition key? What if you have to leave
something valuable in your vehicle?
Put your valuables in a storage area,
like your glove
box.
0 Lock the glove box.
0 Lock all the doors except the driver's.
Then take the door key with you.
I
GM -
I PASS-Key@IZ
four vehicle is equipped with the
-'ASS-Key@II (Personalized Automotive
iecurity System) theft-deterrent system.
-'ASS-Key@II is a passive theft-deterrent
iystem.
This means you don't have to do
mything different to
arm or disarm the
iystem. It works when you insert or
'emove the key from the ignition.
-'ASS-Key@II uses a resistor pellet in
he ignition key that matches a decoder
n your vehicle. When
the PASS-Key@II system senses
that someone is using the wrong key, it
shuts down the vehicle's starter and fuel
systems. For about three minutes, the
starter won't work and fuel won't
go to
the engine. If someone tries to start your
vehicle again or uses another key -during
this time, the vehicle will not start. This
discourages someone from randomly
trying different keys with different
resistor pellets in an attempt to make a
match.
. ..,.
49 . 8
ProCarManuals.com

Features and Controls
I rl SECUIITY
The ignition key must be clean and dry
before it’s inserted in the ignition or the
engine may not start. If the engine does
not start and the “SECURITY” light stays on when you
try to start the vehicle, the
key may be dirty or wet. Turn the
ignition
off.
Clean and dry the key. Wait about three
minutes and try again. The security light
will remain on during this time. If the
starter still won’t work, and the key
appears to be clean and
dry, wait about
three minutes and try another ignition key.
At this time, you may also want
to check
the fuses (see “Fuses and Circuit
Breakers” in the Index). If the starter
won’t work with the other key, your
vehicle needs service.
If your vehicle
does start, the first ignition key may be
... 50
Faulty. See your Pontiac dealer or a
locksmith who can service the
PASS-Key@II.
[f you accidentally use a key that has a
Jamaged or missing resistor pellet, the
starter won’t work and the security light
will flash. But you don’t have to wait
three minutes before trying another
ignition key.
See your Pontiac dealer or a locksmith
who can service the PASS-Key@II to
have a new key made.
If you’re ever driving and the
“SECURITY’’ light comes on and stays
on, you will be able to restart your engine
if you turn it
off. Your PASS-Key@ I1
system, however, is not working properly
and must be serviced by your Pontiac
dealer. Your vehicle is not protected by
the PASS-Key% system.
If you lose or damage a PASS-Key@ I1
ignition key, see your Pontiac
dealer or a locksmith who can service
PASS-Key% to have a new key made.
In
an emergency, call the Pontiac Roadside
Assistance Program on
1-800-ROADSIDE
or 1-800-762-3743.
New Vehicle
“Break-Zn”
NOTICE:
Your modem Pontiac doesn’t need an
elaborate “break-in.” But it will per-
form better in the long run if you fol-
low these guidelines:
Keep your speed at
55 mph (88
km/h) or less for the first 500
miles (804 km).
Don’t drive at any one speed
-
fast or slow - for the first 500
miles (804 km). Don’t make
full-throttle starts.
Avoid malung hard stops for the
first 200 miles (322 km) or
so.
During this time your new brake linings aren’t yet broken in. Hard
stops with new linings can mean
premature wear and earlier
replacement. Follow this
“brealung-in” guideline every
time you get new brake linings.
ProCarManuals.com

Then push on the release handle to
unlatch the panel. Lift the outer edge of
the panel and pull it toward you. Open the
close-out panel completely.
Place the panel in the correct slot
(“DRIVER’ or “PASSENGER’) in the
rear area of your vehicle. Make sure the
handle
is open and facing you when you
put it in the storage slot. lush
the handle closed to secui-e the panel
I the slot. To lock each panel in the
torage’area, use your door key.
81 ...
ProCarManuals.com

Comfort Controls and Audid Systems
Forward
Press and hold “FWD’ to quickly
advance within a track. Release it to
resume playing. The radio will play
during this operation.
Random
Press “RDM’ to hear a random selection
of tracks.
To Stop the Disc Player
Turn the power off or turn the ignition
key
off. The disc stays in the player
and will resume,playing at the point
where it stopped.
Press
“AM/FM’ to stop playing the
disc and switch to radio. Press
“CDPLAY” to restart the disc at the
point wherk it stopped.
Press “EJECT” to eject the disc or
stop the disc
arid switch to radio.
“EJECT” wili work with the ignition
or radio
off. Press “EJECT” to load a
disc when the audio system is
off.
rheft-Deterrent System
Your auklio system is equipped with the
‘THEFTLOCK” theft-deterrent system.
See “Theft-Deterrent System” at the end
3f this section.
rheft-Deterrent Feature
rHEFTZOCK is a security feature for the
Zassette tape and compact disc player. It
:an be used or ignored. If ignored, the
System functions normally:
If it is used,
your system won’t be usable if it’s ever
stolen. When the system is active, the
indicator light will flash while the ignition
is off.
Setting Your Security Code
The instructions below tell you how to
enter a security code into the system. If
your vehicle loses battery power for any
reason, you must enter the security code
again before the system will turn on.
1. Write down any number from 000 to
1999 and keep it in a safe place.
2. Turn the ignition switch to tHk “ACC”
or “Run” position.
3. T~irn the audio system off.
4. Press and hold pushbuttons “1” and
“4” together until “---” shows on the
display.
You are now ready to enter your security
:ode. Don’t wait more than
15 seconds
between steps.
5. Press “MIN” and “000” will appear
on the display.
6. Press “MIN’ again and hold until the
last two digits of your code appear.
Release the button.
7. Press “HR’ until the first one or two
digits of your code appears.
on tine display.
verification.
8. Press “A”.” “rEP” will appear
9. Repeat steps 5 through 7 for
10. Press “A”.” “SEC” will appear
on the display. This means that your audio system is secured.
. . .I20
ProCarManuals.com

Shutting Off the Theft-Deterrent
Feature
If your audio system is secured (“SEC”
shows on display) and you wish to disable
it, enter your security code as follows,
pausing no more than
15 seconds between
steps:
1. Turn the ignition on. Make sure the
audio system is
off. The time will
show
on the display.
together until “SEC” shows on the
display.
3. Press “MIN.” “Oi>O,’ will appear on
the display.
4. Press “MIN’ again and hold until the
last two digits of your code appear.
Release
the button.
5. Press “HR’ until the first one or two
digits of your code appear.
6. Press “AM/FM.” If “---” shows, you
have shut off the theft-deterrent
feature. If “SEC” shows, your aud
system is still secured.
NOTE: If you lose or forget your security
code, see your dealer for assistance.
2. Press pushbuttons “1” and “4”
4
Unlocking the Audio System after a
Power Failure
If power is disrupted to the audio system
while in the “SEC” mode, the unit will
not work and “LOC” will show on the
display whenever the ignition is on. To
unlock the unit:
1. Press “MIN.” “000” will appear on
the display.
2. Press “MIN’ again and hold until the
last two digits of your code appear,
Release the button.
3. Press “HR’ until the first one or two
4. Press “AM/FM.” “SEC” will appear
digits
of your code appear.
on the display and the unit will work.
If “LOC” shows, the numbers did not
match and the unit is still locked.
How to Change Your Security Code
You can change your security code by
following these steps:
1. Using your old code, follow the
directions given under “Shutting
Off
the Theft-Deterrent Feature.”
2. Repeat directions of “Setfing Your
Security Code” with your new
security code.
Understanding Radio Reception
FM Stereo
FM stereo will give you the best sound.
But FM signals will reach only about
10 to 40 miles (16 to 65 km). And, tall
buildings or hills can interfere with
FM signals, causing the sound to come
and go.
AM
The range for most AM stations is greater
than for FM, especially at night. The
longer range, however, can cause stations
to interfere with each other. AM can pick
up noise from things like storms and
power lines. Try reducing the treble to
reduce this noise if you ever get it.
AM Stereo
This means the Delco@ system can
receive C-QUAM@ stereo broadcasts.
Many AM stations around the country
use C-QUAM@ to prodyce stereo, though
some do not. (C-QUAM@
is a registered
trademark
of Motorola, I&) If your
Delco@ system can get C-QUAM@, your
“STEREO” light will come on when
you’re receiving it.
121 ...
ProCarManuals.com

Your Driving and the Road
Winter Driving
Here are some tips for winter driving:
Have your Pontiac in good shape for
winter. Be sure your engine coolant
mix is correct.
. . .I42
You may want to put winter
emergency supplies in your vehicle.
Include an ice scraper, a small brush
or broom, a supply of windshield
washer fluid, a rag, some winter outer
clothing, a small shovel, a flashlight, a
red cloth, and a couple of reflective
warning triangles. And, if you will be
driving under severe conditions, include a small bag of sand, a piece
of
old carpet or a couple of burlap bags
to help provide traction. Be sure you
properly secure these items in your
vehicle.
Driving on Snow or Ice
Most of the time, those places where your
tires meet the road probably have good
traction.
However, if there is snow or ice between
your tires and the road, you can have a
very slippery situation. You’ll have a lot
less traction or “grip” and will need to be
very careful.
ProCarManuals.com

Hitches
It’s important to have the correct hitch
equipment. Crosswinds, large trucks
going by, and rough roads are a few
reasons why you’ll need the right hitch.
Here are some rules to follow:
0
0
Will you have to make any holes in
the body of your vehicle when you
install a trailer hitch? If you do, then
be sure to seal the holes later when
you remove the hitch. If you don’t
seal them, deadly carbon monoxide
(CO) from your exhaust can get into
your vehicle (see “Carbon Monoxide”
in the Index). Dirt and water can,
too.
The bumpers on your vehicle are not
intended for hitches.
Do not attach
rental hitches or other bumper-type
hitches to them. Use only a
frame-mounted hitch that does not
attach to the bumper.
Safety Chains
You should always attach chains between
your vehicle and your trailer. Cross the
safety chains under the tongue of the
trailer
so that the tongue will not drop to
the road if it becomes separated from the
hitch. Instructions about safety chains
may be provided by the hitch manufacturer or
by the trailer
, 1.
manufacturer. Follow the manufacturer’s
recommendation for attaching safety
chains. Always leave just enough slack
so
you can turn with your rig. And, never
allow safety chains to drag on the ground.
Trailer Brakes
If your trailer weighs more than 1,000
pounds (450 kg) loaded, then it needs its
own brakes
- and they must be adequate.
Be sure to read and follow the instructions
for the trailer brakes
so you’ll be able to
install, adjust and maintain them properly.
Because you have anti-lock brakes, do not
try to tap into your vehicle’s brake
system. If
YOU do, both brake systems
won’t work well, or at all.
Driving with a Trailer
Towing a trailer requires a certain amount
of experience. Before setting out for the
open road, you’ll want to get to know
your rig. Acquaint yourself with the feel
of handling and braking with the added
weight
of the trailer. And always keep in
mind that ’the vehicle you are driving is
now a good deal longer and not nearly as
responsive
as your vehicle is by itself. Before you
start, check the trailer hitch
and platform, safety chains, electrical
connector, lights, tires and mirror
adjustment. If
the trailer has electric
brakes,
start your vehicle and trailer
moving and then apply the trailer brake
controller by hand to be sure the brakes
are working. This lets you check your
electrical connection at the same time.
During your trip, check occasionally to
be sure that the load is secure,. and that
the lights and any trailer brakes are still
working.
Following Distance
Stay at least twice as far behind the
vehicle ahead as you would when driving
your vehicle without a trailer.,,This can
help
you avoid situations that’.require
heavy braking and sudden turns.
Passing
You’ll need more passing distance up
ahead when you’re towing a trailer. And,
because you’re a good deal longer, you’ll
need to go much farther beyond the
passed vehicle before you can return to
your lane.
147 ...
ProCarManuals.com