THEFT DETERRENT
85 After one minute, the alarm will automatically stop, but the
starter circuit will remain disabled.
REACTIVATING THE ALARM
Once set, the system automatically resets the alarm each time
all the doors, trunk and hood are closed after the alarm stops.
The alarm will be activated again under the following
conditions:
If any of the doors, trunk or hood is opened.
If the battery terminal is disconnected and then
reconnected.
STOPPING THE ALARM
Turn the ignition key from the “LOCK” to “ACC” position.
The alarm will be stopped but the starter circuit will remain
disabled. Stopping the alarm in this manner will keep the alarm
from being reactivated when any of the doors, trunk or hood is
opened.
INTERRUPTING THE SYSTEM
With the system set, the trunk can be opened with the master
key without activating or cancelling the system. While it is
open, the doors and hood may be opened in addition, and the
system can be activated only by disconnecting the battery
terminal.To resume the setting, close and lock all the doors, trunk and
hood. The trunk must be closed with the key removed.
Cancelling the system
Open either of the front doors using an ignition key or wireless
door lock remote control.
This cancels the system completely and the starter circuit will
be reactivated at once.
INDICATOR LIGHT
The indicator light gives the following three indications when
the system is in use. When the light is:
FLASHING − The system is set. You need the key to open the
doors, trunk or hood.
ON − The system will automatically be set when the time
comes. The doors, trunk or hood may be opened without an
ignition key. The indicator light is also on when the alarm is
being sounded.
OFF − The system is inactive. You may open any door, trunk
or hood.
Testing the system
1. Open all the windows.
2. Set the system as described above.
Be sure to wait until the indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
