10W-30
5W-30 Preferred
Temperature range anticipated before next oil change
ENGINE
193 Oil capacity
Drain and refill
with filter
without filter
Oil grade
Recommended oil viscosity (SAE):
5.1 L (5.4 qt., 4.5 Imp.qt.)
4.8 L (5.1 qt., 4.2 Imp.qt.)
API grade SG or SH, Energy-Conserving II multigrade engine
oil or ILSAC multigrade engine oil
− COOLING SYSTEM
Capacity
Coolant type
10.8 L (11.4 qt., 9.5 Imp.qt.)
Ethylene-glycol coolant (Do not use alcohol type.)
− FUEL
Fuel type
Research octane umber
Only UNLEADED
96 (Octane Rating 91) or higher
− IGNITION SYSTEM
ENGINE
199
Engine oil selection
Use API SG or SH, Energy-Conserving II multigrade engine oil
or ILSAC multigrade engine oil. Recommended viscosity is as
follows with SAE 5W-30 being the preferred engine oil for your
vehicle.
Recommended viscosity (SAE):
Temperature range anticipated before next oil change
10W-30
5W-30 Preferred
If you use SAE 10W-30 engine oil in extremely low
temperatures, the engine may become difficult to start, so
SAE 5W-30 engine oil is recommended.
Oil identification marks
API Service SymbolILSAC Certification Mark
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.
The API Service Symbol is located anywhere on the outside
of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SH.
The center portion of the label shows the SAE viscosity
grade such as SAE 5W-30. “Energy-Conserving II”, shown
in the lower portion, indicates that the oil has fuel-saving
capabilities. Oils marked “Energy-Conserving II” will have
higher fuel-saving capabilities than oils marked
“Energy-Conserving”.
