1994 Lexus LS400 ECU

COMFORT ADJUSTMENT
73
CHILD RESTRAINT
Child restraint precautions
Lexus strongly urges the use of child restraint system for
children small enough to use it.
The laws of all fifty states in the U.S.A. and Canada now
require the use of a child restraint system.
CAUTION:
For effective protection in automobile accidents and
sudden stops, children must be properly restrained.
Holding a child in your arms is not a substitute for a child
restraint system. In an accident, the child can be crushed
against the windshield, or between you and the vehicle’s
interior if you are unrestrained.
Child restraint system
A child restraint system for a small child or baby must
itself be restrained on the seat with either the lap belt or
the lap portion of the lap / shoulder belt.
The child restraint system should conform to the size of the
child and properly fit the vehicle seat. For greater safety. the
child restraint system should be installed in the rear seat.
According to accident statistics, children are safer when
properly restrained in the rear seat than in the front seat.When installing a child restraint system, refer to the
instructions provided by its manufacturer and follow the
directions under the following illustrations.
CAUTION:
After installing the child restraint system, make sure it is
secured in place. If it is not restrained securely, it may
cause injury to the child in the event of a sudden stop or
accident.
When not using the child restraint system, keep it secured with
the seat belt or place it in the trunk or somewhere other than
in the vehicle. This will prevent it injuring passengers in the
event of a sudden stop or accident.

COMFORT ADJUSTMENT
74Top strap anchors and locations
Your vehicle has anchors for securing the top strap of a child
restraint system. Anchor nuts are welded beneath the sheet
metal to permit installation of an anchor bracket for a child
restraint system.
To install an anchor bracket, use an 8 mm x 30 mm x 1.25 mm
coarse thread metric bolt and a 10 mm (0.4 in.) spacer for the
outer anchors or a 15 mm (0.6 in.) spacer for the center anchor.
Note that the bolts accompanying many child restraint systems
are not metric. You can damage the anchor nuts on your
vehicle if you force bolts with different thread into the anchor
nuts.If your child restraint system does not provide any of the
necessary parts, you can purchase the following items from
your Lexus dealer.

CRS installation kit (Part No. 04731-22012)
− contains 1 bolt, 3 types of spacer and 1 locking clip.

Bolt (Part No. 91511-60830)
370 mm
(14.5 in.)370 mm
(14.5 in.)
90 mm
(3.5 in.)35 mm
(1.5 in.)
1. Run your fingers across the trim of the filler panel to locate
the holes underneath it in the positions shown above.
2. Make a hole in the covering directly above the hole in the
filler panel.

COMFORT ADJUSTMENT
76
Fasten the center lap belt over the child restraint system
following the instructions provided by its manufacturer.
Make sure the belt is tight by pulling its free end while you firmly
push down the child restraint system.
If your child restraint system requires the use of a top strap,
latch the hook onto the anchor bracket and tighten the top
strap.
CAUTION:
Push and pull the child restraint system in different
directions to make sure it is secure.

COMFORT ADJUSTMENT
78
Place the shoulder belt between the vehicle seatback and the
child restraint system and allow it to retract. To hold the child
restraint system securely, let the shoulder belt retract as far as
it will go while firmly pushing down the child restraint system.
If your child restraint system requires the use of a top strap,
latch the hook onto the anchor bracket and tighten the top
strap.
CAUTION:
Make sure the seat belt is securely locked. Also make sure
the child restraint system is secure by pushing and
pulling it in different directions.
To remove the child restraint system, press the buckle release
button and allow the belt to retract, Unhook the top strap.

COMFORT ADJUSTMENT
80
Place the shoulder belt between the vehicle seatback and child
restraint system and allow it to retract. To hold the child
restraint system securely, let the shoulder belt retract as far as
it will go while firmly pushing down the child restraint system.
If your child restraint system requires the use of a top strap,
latch the hook onto the tab of the rear center seat belt and
tighten the top strap.
CAUTION:
Make sure the seat belt is securely locked. Also make sure
the child restraint system is secure by pushing and
pulling it in different directions.
To remove the child restraint system, press the buckle release
button and allow the belt to retract. Unhook the top strap.