1994 Lexus ES300 brake fluid

MAINTENANCE
149 Seats
Check that all front seat controls such as seat adjusters,
seatback recliner, etc. operate smoothly and that all latches
lock securely in any position. Check that the head restraints
move up and down smoothly and that the locks hold securely
in any latched position.
Seat belts
Check that the seat belt system such as buckles, retractors
and anchors operate properly and smoothly. Make sure the
belt webbing is not cut, frayed, worn or damaged.
Accelerator pedal
Check the pedal for smooth operation and uneven pedal effort
or catching.
Brake pedal
Check the pedal for smooth operation and the proper
clearance and freeplay. Check the brake booster function. See
page 185 for additional information.
Brakes
At a safe place, check that the brakes do not pull to one side
when applied.
Parking brake
Check that the lever has the proper travel and that, on an
incline, your vehicle is held securely with only the parking
brake applied. See page 186 for additional information.Automatic transmission “Park” mechanism
Check the lock release button of the selector lever for proper
and smooth operation. On a safe incline, check that your
vehicle is held securely with the selector lever in “P” position
and all brakes released.
Engine compartment
Items listed below should be checked from time to time,
e.g. each time when refueling.
Windshield washer fluid
Make sure there is sufficient fluid in the tank. See page 210 for
additional information.
Engine coolant level
Make sure the coolant level is between the “FULL” and “LOW”
lines on the see-through reservoir. See page 178 for additional
information.
Radiator and hoses
Make sure the front of the radiator is clean and not blocked with
leaves, dirt or bugs. Check the hoses for cracks, kinks, rot and
loose connections.
Battery
Your Lexus has a maintenance free battery. You do not have
to add distilled water. For longer life of the battery, however,
see page 202 for additional information.

MAINTENANCE
150Brake fluid level
Make sure the brake fluid levels is correct. See page 184 for
additional information.
Engine drive belts
Check the belts or fraying, cracks, wear or oiliness.
Engine oil level
Check the level on the dipstick with the engine turned off and
the vehicle parked on a level spot. See page 176 for additional
information.
Power steering fluid level
Check the level through the reservoir. The level should be in
the “HOT” or “COLD” range depending on the fluid
temperature. See page 187 for additional information.
Automatic transmission fluid level
Check the level on the dipstick with the engine idling and the
selector lever in “P”. The level should be in the “HOT” or
“COOL” range according to the fluid temperature. See page
188 for additional information.
Exhaust system
Look for cracks, holes and loose supports. If you notice any
change in the sound of the exhaust or smell exhaust fumes,
have the cause located and corrected immediately. (See
engine exhaust cautions in Section 3-1.)
DOES YOUR VEHICLE NEED
REPAIRING?
Be on the alert for changes in performance and sounds, and
visual tip-offs that indicate service is needed. Some important
clues are:

Engine missing, stumbling, or pinging

Appreciable loss of power

Strange engine noises

A fluid leak under the vehicle (However, water dripping from
the air conditioning alter use is normal.)

Change in exhaust sound (This may indicate a dangerous
carbon monoxide leak. Drive with the windows open and
have the exhaust system checked immediately.)

Flat-looking tires, excessive tire squeal when cornering;
uneven tire wear

Vehicle pulls to one side when driving straight on a level
road

Strange noises related to suspension movement

Loss of brake effectiveness, spongy feeling brake pedal,
pedal almost touches floor, vehicle pulls to one side when
braking

Engine coolant temperature continually higher than normal

MAINTENANCE
154SCHEDULE A
Maintenance operations:
A = Check and adjust as necessary; I = Inspect and correct or replace as necessary; R = Replace, change or lubricate.
Service interval
(Use odometer reading or
months, whichever comes first.)Maintenance services beyond 96,000 km (60,000 miles) should continue to be performed at the same intervals shown for each maintenance schedule.
Miles x 1,00013.757.511.251518.7522.526.253033.7537.541.254548.7552.556.2560MonthsMaintenance items km x 1,0001.66121824303642485460667278849096CHASSIS AND BODYBrake linings and drumsIIIIIIIII: Every 12 monthsBrake pads and discsIIIIIIIII: Every 12 monthsBrake fluidIIRIRR: Every 36 monthsBrake line pipes and hoseIIIII: Every 24 monthsSteering linkageIIIIIIIII: Every 12 monthsSRS airbagAfter inspection at 10 years, inspect every 2 years.Steering gear box See note (7)IIIIII: Every 24 monthsBall Joints, dust covers and drive shaft bootsIIIIIIIII: Every 12 monthsAutomatic transaxlelRRRRR: Every 24 monthsBolts and nuts on chassis and body See note (8)IIIIIIIIII: Every 12 monthsBody inspection (paint, corrosion)IIIIIIIIII: Every 12 monthsROAD TESTIIIIIIIIII: Every 12 months
NOTE:
(7) Inspect the steering gear housing for oil leakage only.
(8) Applicable when operating mainly on rough and / or muddy roads. If not, follow schedule B.

MAINTENANCE
156SCHEDULE B
Maintenance operations:
A = Check and adjust as necessary; I = Inspect and correct or replace as necessary; R = Replace, change or lubricate.
Service interval
(Use odometer reading or
months, whichever comes first.)Maintenance services beyond 96,000 km (60,000 miles) should continue to be performed at the same intervals shown for each maintenance schedule.
Miles x 1,00017.51522.53037.54552.560MonthsMaintenance items km x 1,0001.61224364860728496CHASSIS AND BODYBrake linings and drumsIIIII: Every 24 monthsBrake pads and discsIIIII: Every 24 monthsBrake fluidIIRIRR: Every 36 monthsBrake line pipes and hosesIIIII: Every 24 monthsSteering linkageIIIII: Every 24 monthsSRS airbagAfter inspection at 10 years, inspect every 2 years.Steering gear box See note (5)IIIIII: Every 24 monthsBall Joints, dust covers and drive shaft bootsIIIII: Every 24 monthsAutomatic transaxleIIIIII: Every 24 monthsBolts and nuts on chassis and bodyIIIIII: Every 24 monthsBody inspection (paint, corrosion)IIIIIIIIII: Every 12 monthsROAD TESTIIIIIIIIII: Every 12 months
NOTE:
(5) Inspect the steering gear housing for oil leakage only.

MAINTENANCE
158Spark plugs
Install new plugs of the same type as originally equipped. A
qualified technician should perform this operation.
Charcoal canister
Inspect for internal damage or clogging. Clean with
compressed air or replace if necessary. A qualified technician
should perform this operation.
CHASSIS AND BODY
Brake linings and drums
Check for scoring, burning, broken parts, and excessive wear.
A qualified technician should perform this operation.
Brake pads and discs
Check the pads for excessive wear and the discs for runout
and wear. Also check for leaking fluid. A qualified technician
should perform this operation.
Brake fluid
Check for correct levels of the brake fluid. If the level is low, add
FMVSS No. 116 DOT3 or SAE J1703 brake fluid to the brake
reservoir. Change the brake fluid as scheduled. A qualified
technician should perform these operations.Brake line pipes and hoses
Visually check for proper installation. Check for chafing,
cracks, deterioration, and any evidence of leaking. Replace
any deteriorated or damaged parts immediately. A qualified
technician should do these operations.
Steering linkage
With the vehicle stopped, check for excessive freeplay in the
steering wheel. Check the linkage for bends or damage. Check
the dust boots for deterioration, cracks, or damage. Replace
any damaged parts.
Steering gear box
Inspect the steering gear box for signs of leakage. If you
discover any leakage, have it repaired by a qualified technician
immediately.
Drive shaft boots
Inspect the drive shaft boots for clamp looseness, grease
leakage or damage. Replace any deteriorated or damaged
parts immediately. A qualified technician should perform these
operations.
Ball joints and dust covers
Check the suspension and steering linkage ball joints for
looseness or damage. Check all dust covers for deterioration
or damage. A qualified technician should perform these
operations.

MAINTENANCE
159 Automatic transaxle
Inspect each component for signs of leakage. If you discover
any leakage, have it repaired by a qualified technician
immediately. Under severe driving conditions, change the fluid
and oil when scheduled.
SRS airbags
This should be periodically inspected by a qualified technician.
For details, see the maintenance schedule.
Bolts and nuts on chassis and body
Where necessary, retighten to specified torque.
Body inspection (paint, corrosion)
Visually check for corrosion, scratches and other damage.
Check body outer panels, underneath the vehicle, inner panels
of the hood and doors, etc. Apply touch-up paint to any chips
or scratches, or have them repaired by a qualified technician.
ROAD TEST
While driving the vehicle, check the proper operation of engine,
transmission, brakes and steering, and check for abnormal
noise or vibration from any part of the vehicle.