1994 Lexus ES300 service

SECTION 6 – 2
169
SERVICE PROCEDURES AND
SPECIFICATIONS
Engine
Specifications170 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fuel173 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Facts about engine oil consumption174 . . . . . . . . . . . . . . . . . . . . . . . .
Used engine oil175 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking the engine oil level176 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking the engine coolant level178 . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking and replacing the air cleaner filter179 . . . . . . . . . . . . . . . . .

ENGINE
175 The amount of engine oil consumed depends on the
viscosity of the oil, the quality of the oil and the way the
vehicle is driven.
More oil is consumed under driving conditions such as high
speeds and frequent acceleration and deceleration.
A new engine consumes more oil, since its pistons, piston rings
and cylinder walls have not become conditioned.
When judging the amount of oil consumption, note that
the oil may become diluted, making it difficult to judge the
true level accurately.
For example, if a vehicle is used for repeated short trips and
consumes a normal amount of oil, the dipstick may not show
any drop in the oil level at all, even after 1000 km (600 miles)
or more. This is because the oil is gradually becoming diluted
with fuel or moisture, making it appear that the oil level has not
changed.
The diluting ingredients evaporate out when the vehicle is then
driven at high speeds, as on an expressway, making it appear
that oil is excessively consumed after driving at high speeds.
Importance of engine oil level check
One of the most important points in proper vehicle
maintenance is to keep the engine oil at the optimum level so
that oil function will not be impaired. Therefore, it is essential
that the oil level be checked regularly. Lexus recommends that
the oil level be checked every time you refuel the vehicle.
NOTICE:
Failure to check the oil level regularly could lead to
serious engine troubles due to insufficient oil.
For detailed information on oil level check, see “Checking the
engine oil level” on page 176.
USED ENGINE OIL
CAUTION:
Used engine oil contains potentially harmful
contaminants which may cause skin disorders such as
inflammation or skin cancer, so care should be taken to
avoid prolonged and repeated contact with it. To
remove used engine oil from your skin, wash
thoroughly with soap and water.
Do not leave used oil within the reach of children.
Dispose of used oil and used oil filters only in a safe and
acceptable manner. Do not dispose of used oil and
used oil filters in household trash, in sewers or onto the
ground. Call your Lexus dealer or a service station for
information concerning recycling or disposal.

ENGINE
API Service SymbolILSAC Certification Mark
”FULL” line
”LOW” line
178
Oil identification marks
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.
The API Service Symbol is located anywhere on the outside
of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SH.
The center portion of the label shows the SAE viscosity
grade such as SAE 5W-30. “Energy-Conserving II”, shown
in the lower portion, indicates that the oil has fuel-saving
capabilities. Oils marked “Energy-Conserving II” will have
higher fuel-saving capabilities than oils marked
“Energy-Conserving”.
The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on the
front of the container.
CHECKING THE ENGINE COOLANT
LEVEL
Look at the see-through coolant reservoir. The coolant
level is satisfactory if it is between the “FULL” and “LOW”
lines on the tank. If the level is low, add ethylene-glycol
type coolant.
The coolant level in the reservoir will vary with engine coolant
temperature. However, if the level is on or below the “LOW”
line, add coolant to bring the level up to the “FULL” line.
Use only ethylene-glycol type coolant. For information on
ethylene-glycol coolant, see also “Engine coolant selection” on
page 179.
If the coolant level drops within a short time after replenishing,
there may be a leak in the system. Visually check the radiator,
hoses, radiator cap, drain cocks, and water pump.