Downloaded from www.Manualslib.com manuals search engine Raising your vehicle with the jack improperly positioned will
damage the vehicle or may allow the vehicle to fall
off the jack.
Be sure to
fit the jack lift head into the proper location before
raising your vehicle.
Raise the vehicle by
rotating the ratchet to
the right. Make sure
the
UP marking faces
you. Raise the vehicle
far enough
off the
ground
so there is
enough room for the
spare tire to
fit.
Remove all the wheel
nuts.
Downloaded from www.Manualslib.com manuals search engine Storing The Jack and Spare Tire
Put the tire on the ground at the rear of the vehicle, with the valve stem
pointed down.
Pull the retaining bar through the center of the wheel, making sure it is
properly attached. Attach the ratchet, with the
UP side facing you, to the
extension.
Put the flat end
of the extension on an angle through the hole in the rear
door frame, above the bumper. Turn the ratchet to the right until the tire is
against the underside
of the vehicle.
You will hear two"c1icks" when the tire is all the way.
Try to move the tire
with your hands to make sure it is securely in place.
Return the jack, ratchet, extension and wheel blocks to the proper location
in the rear storage area. Replace all bolts, retainers and wing nuts in the
proper location. Secure the jacking equipment in its proper location and
replace the jack storage cover.
