Page 72 of 340

Downloaded from www.Manualslib.com manuals search engine Key in the Ignition
If you walk away from your vehicle with the keys inside, it’s an easy target
for joy riders or professional thieves
- so don’t do it.
When you park your vehicle and open the driver’s door, you’ll hear
a chime
reminding you to remove your key from the ignition and take it with you.
Always do this. Your steering wheel
will be locked, and so will your
ignition and transmission. And remember to lock the doors.
Parking at Night
Park in a lighted spot, close all windows and lock your vehicle. Remember
to keep your valuables out
of sight. Put them in a storage area, or take them
with you.
Parking Lots
If you park in a lot where someone will be watching your vehicle, it’s best
to lock
it up and take your keys. But what if you have to leave your ignition
key? What
if you have to leave something valuable in your vehicle?
Put your valuables in a storage area out of sight.
Lock all the doors except the driver’s.
Then take the door key with you.
New Vehicle “Break-In ”
NOTICE:
Your modern vehicle doesn’t need an elaborate “break-in.” But
it will perform better in the long run if you follow these
guidelines:
0 Keep your speed at 55 mph (88 km/h) or less for the first
500 miles (804 km).
Don’t drive at any one speed - fast or slow - for the first
500 miles (804 km). Don’t make full-throttle starts.
0 Avoid making hard stops for the first 200 miles (322 km) or
so. During this time your new brake linings aren’t yet broken
in. Hard stops with new linings can mean premature wear and
earlier replacement. Follow this “breaking-in” guideline
every time you get new brake linings.
2-12
Page 88 of 340
Downloaded from www.Manualslib.com manuals search engine Hatch Release Switch
This switch is to the
left of the steering
column. It will release
the rear hatch.
The vehicle must be
in “P’ (Park) or “N’ (Neutral) to release the hatch and
unlock the split-panel doors. The hatch will release with or without the key
in the ignition.
2-28
Page 104 of 340
Downloaded from www.Manualslib.com manuals search engine Headlights-On Reminder
If you have this option, a reminder tone will sound when your he\
adlights are
turned on and your ignition is in OFF, LOCK or ACC. To turn the tone off,
press the OFF switch.
Dome Lights
Reading Lights
The dome lights may
come on when you
open any of the doors.
You can also turn
on
the dome lights by
turning the dimmer
dial to the right until it
clicks.
You may have the
optional reading lights
next to the dome
lights. Turn the lights
on and
off by pressing
the switch next to the
light.
You can adjust the lights to any desired position by rotating the lamp\
and
they will work when the ignition is on or off. Be sure to turn the lights
off
before you leave the vehicle.
2-44
Page 143 of 340

Downloaded from www.Manualslib.com manuals search engine Clock
To set the clock, just:
Push SET.
Within 5 seconds, push ant Ild SCA .N until the correct hour appears.
0 Press and hold SEEK until the correct minute appears.
To display the clock
with the ignition off, push the upper knob. The time
will be displayed for a few seconds.
Cassette Tape Player
Your tape player is built to work best with tapes that are 30 to 45 minutes
long on each side. Tapes longel [an that are
so thin they may not work well
in this player.
To play a cassette tape:
Have the radio on.
0 Insert the tape squarely rnrough the tape door.
The longer side with the tape visible goes in first. If you hear nothing or
hear just garbled sound, it may not be
in squarely. Push STOP-E JECT to
remove the tape and start over.
Once the tape is playing, use the upper and lower knobs for volume and
balance, just
as you do for radio. The arrows show which side of the tape is
playing.
To go forward to another part of the tape, push the button with an
arrow pointing toward the lighted arrow.
To stop the tape, push the
STOP-E JECT button lightly.
To go backward, push the button with an arrow pointing away from
the lighted arrow. To stop the tape, push the
STOP-EJECT button
lightly.
To go from one side of the tape to the other, push in the upper knob on
your radio.
To remove or stop the tape, push STOP-EJECT.
3-15
Page 146 of 340

Downloaded from www.Manualslib.com manuals search engine Clock
To set the clock, just:
0 Press SET. (SET appears in the VF display for a few seconds.)
Within 5 seconds, push and hold SCAN until the correct hour appears.
0 Press and hold SEEK until the correct minute appears.
To display
the clock with the ignition off, push the upper knob. The time
will be displayed for a few seconds.
To Play A Cassette
Your tape player is built to work best with tapes that are 30 to 45 minutes
long on each side. Tapes longer than that are
so thin they may not work well
in this player.
To play a cassette tape:
Have the radio on.
0 Insert the tape squarely through the tape door.
The longer side with the tape visible goes in first. If you hear nothing or
hear just garbled sound, it may not be
in squarely.
Push
STOP-EJECT to remove the tape and start over.
Once the tape is playing, use the upper and lower knobs for volume and
balance, just as you do for radio. The arrows show which side of the tape is
playing.
0 To go forward to another part of the tape, push ,.
To go backward, push 4. To stop the tape, push the STOP-E JECT
button lightly.
0 To go from one side of the tape to the other, push in the upper knob on
your radio. To remove or stop the tape, push
STOP-EJECT.
APS (Automatic Program Search)
Press this button to activate the automatic program search. When the
button is pressed, the tape will rapidly advance to the beginning
of the next
selection. When the
4 button is pressed, the tape will rapidly reverse to the
beginning
of the current selection.
Press
STOP-EJECT to remove the cassette and start the radio.
3-18
Page 204 of 340
Downloaded from www.Manualslib.com manuals search engine Jack Storage
Your jack, extension, ratchet and wheel blocks are stored by your vehicle’s
rear doors, along the passenger side wall.
I
To remove your jack
cover, take off the
plastic wing
nut by
turning it
to the left.
Lift up on the latch
and pull the jack cover
off.
Remove the wheel
blocks and jack
by
turning the wing nut
to the left. Remove the
wing nut and washer
then
pull the wheel
blocks and jack off the
5-20
Page 215 of 340
Downloaded from www.Manualslib.com manuals search engine Storing The Jack and Spare Tire
Put the tire on the ground at the rear of the vehicle, with the valve stem
pointed down.
Pull the retaining bar through the center of the wheel, making sure it is
properly attached. Attach the ratchet, with the
UP side facing you, to the
extension.
Put the flat end
of the extension on an angle through the hole in the rear
door frame, above the bumper. Turn the ratchet to the right until the tire is
against the underside
of the vehicle.
You will hear two"c1icks" when the tire is all the way.
Try to move the tire
with your hands to make sure it is securely in place.
Return the jack, ratchet, extension and wheel blocks to the proper location
in the rear storage area. Replace all bolts, retainers and wing nuts in the
proper location. Secure the jacking equipment in its proper location and
replace the jack storage cover.
Page 224 of 340
Downloaded from www.Manualslib.com manuals search engine While refueling, hang
the cap inside the fuel
door.
To take off the cap,
turn
it slowly to the
left (counter-
clockwise). The
fuel filler door
release button
is in the
upper corner of the
driver's side stepwell.