Page 18 of 399
Downloaded from www.Manualslib.com manuals search engine These symbols are used on warning and indicator lights:
m BRAKE
c
I I
ENGINE COOLANT
TEMPERATURE RADIATOR
COOLANT
CHARGING
1
ENGINE OIL PRESSURE I FUEL 1 - ENGINE OIL TEMPERATURE
ANTILOCK BRAKE
Here are
some other symbols you may see:
F
L FUSE I AIR
CONDITIONING I RADIO SELECTOR RADIO VOLUME
r 1 1
E I
P
=I
1 LIGHTER I
SPEAKER TRUNK HATCHBACK
RELEASE
5
Page 122 of 399
Downloaded from www.Manualslib.com manuals search engine r C.
NOTICE:
0
0
I
0
0
-
!
r
n
r I
When using concentrated washer fluid, follow the
manufacturer’s instructions for adding water.
Don’t mix water with ready-to-use washer fluid. Water can
cause the solution to freeze and damage your washer fluid
tank and other parts of the washer system.
Also, water
doesn’t clean as well as washer fluid.
Fill your washer fluid tank only
3/4 full when it’s very cold.
This allows for expansion, which could damage the tank
if it
is completely full.
Don’t use radiator antifreeze in your windshield washer.
It
can damage your washer system and paint.
CRUISE CONTROL
With Cruise Control, you can maintain a speed of about 25 mph (40
km/h) or more without keeping your foot on the accelerator. This can
really help on long trips. Cruise Control does not work at speeds below
about
25 mph (40 km/h).
When you apply your brakes, the Cruise Control shuts off.
109
Page 241 of 399
Downloaded from www.Manualslib.com manuals search engine COOLING SYSTEM
When you decide it’s safe to lift the hood, here’s what you’ll see:
Coolant recovery tank
Radiator pressure cap
Electric engine fans
. . ..~ . -~~ . .- - .
A CAUTION:
An electric fan under the hood can start up even when the
engine is not running and can injure
you. Keep hands, clothing
and
tools away from any underhood eIectric fan.
If the coolant inside the coolant recovery tank is boiling, don’t do
anything else until
it cools down.
Page 243 of 399
Downloaded from www.Manualslib.com manuals search engine How to Add Coolant to the Coolant Recovery Tank
If you haven’t found a problem yet, but the coolant level isn’t at or near
“FULL COLD” on the coolant recovery tank, add a 50/50 mixture of
clean water (preferably distilled) and a proper antifreeze at the coolant
recovery tank. (See “Engine Coolant” in the Index for more ififormation
about the proper coolant mix)
C-
NOTICE:
In cold weather, water can freeze and crack the engine, radiator,
heater core and other parts. Use the recommended coolant.
230
Page 245 of 399
Downloaded from www.Manualslib.com manuals search engine You can be burned if you spill coolant on hot engine parts,
Coolant
contains ethylene glycol and it will burn if the engine
parts are hot enough. Don’t spill coolant on a hot engine,
I
I --
1. You can remove the radiator pressure cap when the cap and upper
radiator hose are no longer hot.
0 Turn the pressure
cap slowly to the
left until
it first
stops. (Don’t press
down while turning
the pressure cap.)
If you hear a hiss, wait for that to stop. A hiss means there is still some
pressure left.
232
Page 246 of 399
Downloaded from www.Manualslib.com manuals search engine 2. Then keep turning the pressure cap,
but now push down
as you turn it.
Remove the
pressure cap.
3. Fill the radiator
with the proper
mix, up to the base
of the filler neck.
Page 247 of 399
Downloaded from www.Manualslib.com manuals search engine 4. Then fill the
coolant recovery
tank to
the FULL
COLD mark.
5. Put the cap back
on
the coolant
recovery tank, but
leave the radiator
pressure cap
off.
234
c-
2.
LI
LA
Page 248 of 399
Downloaded from www.Manualslib.com manuals search engine 6. Start the engine
and let it run until
you can
feel the
upper radiator hose
getting hot.
Watch out for the
engine fans.
7. By this time the coolant level inside the radiator filler neck may be
lower. If the level is lower, add more of the proper mix to the radiator
until the level reaches the base
of the radiator filler neck.
8. Replace the
pressure cap. Be
sure the arrows on
the pressure cap
line up like this.