Solenoid Plunger Inspection
Check the contact points and the face of the staner sole-noid plunger for burning, pitting or any other defects. lfsurfacas are rough, recondition them with a strio of# 500 or #600 sandpaper.
soLEr{otDPIUNGER
Starter Reassembly
R€assemble the starter in the reverse order of disas-sembly.
1. Pry back each brush spring with a screwdriver, thonposition the brush about halfway out of its holder,
and release the spring to hold it there.
2. Instsll the armature in the housing. Next pry back
each brush spring again and push the brush down
until it seats against the commutator, then release
the spring against the end of the brush.
a&T&'
s..
V BRUSH
3. Install the end cover on the brush holder.
23-85
