1993 Oldsmobile Cutlass Supreme brake

Your Driving and the Road
Driving with a Trailer (CONT.)
Making Turns
When you’re turning with a trailer,
make wider turns than normal.
Do this
so your trailer won’t strike soft
shoulders, curbs, road signs, trees, or
other objects. Avoid jerky or sudden
maneuvers. Signal well in advance.
Turn Signals When Towing a Trailer
When you tow a trailer, your vehicle has
to have
a different turn signal flasher
and extra wiring. The green arrows
on
your instrument panel will flash
whenever you signal a turn or lane
change. Properly hooked up, the trailer
lights will also flash, telling other
drivers you’re about to turn, change
lanes or stop. When towing a
trailer, the green arrows
on your instrument panel will flash for
turns even if the bulbs on the trailer are
burned out. Thus, you may think
drivers behind you are seeing your
signal when they are not. It’s important
to check occasionally to be sure the
trailer bulbs are still working.
Driving On Grades
Reduce speed and shift to a lower gear
before you start down a long or steep
downgrade.
If you don’t shift down, you
might have to use your brakes
so much
that they would get hot and
no longer
work well.
On a long uphill grade, shift down and
reduce your speed to around
45 mph
(70 lm/h) to reduce the possibility of
engine and transaxle overheating.
If you are towing a trailer and you have
an automatic transaxle with Overdrive,
you may want to drive in
D instead of
(or, as you need to, a lower gear).

Probkms on the Road
Jump Starting (CONT.)
190
2. Get the vehicles close enough so the
jumper cables can reach, but be sure
the vehicles aren’t touching each
other. If they are,
it could cause a
ground connection you don’t want.
You wouldn’t be able to start
your
Oldsmobile, and the bad grounding
could damage the electrical systems.
You could be injured
if the
vehicles roll. Set the parking
brake firmly on each vehicle. Put
an
automatic transaxle in P (Park) or
a manual transaxle in
N (Neutral).
3. Turn off the ignition on both
vehicles. Turn
off all lights that aren’t
needed, and radios. This will avoid
sparks and help save both batteries.
And it could save your radio!
4. Open the hoods and locate the
batteries.
I
~~~~
I 2 /i An even electric when the f- engine is not
I running and can injure you. Keep
hands, clothing and tools away
I from any underhood electric fan.
Find the positive
(+) and negative (-)
terminals on each battery. Your
Oldsmobile has a remote positive
(+)
jump starting terrninal. The terminal is
on the same side
of the engine
compartment as your battery.
You should always use the remote
positive
(+) terminal instead of the
positive
(+) terminal on your battery.
To uncover the remote positive
(+)
terminal, lift the red plastic cap.

Problems on the Road
194
Towing Your Oldsmobile (CONTJ
When your vehicle is being towed, have
the ignition key
off. The steering wheel
should be clamped in
a straight-ahead
position, with
a clamping device
designed for towing service. Do not use
the vehicle’s steering column lock for
this. The transaxle should be in
N (Neutral), and the parking brake
released.
Don’t have your vehicle towed on the
front wheels, unless you must. If the
vehicle must be towed on the front
wheels, don’t go more than
35 mph
(56 km/h) or farther than 50 miles
(80 lun) or your transaxle will be
damaged.
If these limits must be
exceeded, then the front wheels have to
be supported on a dolly. A vehicle can fall from a
car
secured. This can cause a collision,
serious personal injury and vehicle
damage. The vehicle should be
tightly secured with chains or steel
cables before it is transported.
Don’t use substitutes (ropes,
leather straps, canvas webbing,
etc.) that can be cut by sharp edges
underneath the towed vehicle.
/A carrier if it isn’t properly
Towing from the Front-
Vehicle Hook-up
Before hooking up to a tow truck, be
sure
to read all the information on
Towing
Your Oldsmobile earlier in this
section.
All Models
1. Attach T-hook chains into the side
slots in the cradle in front of the
wheels, on both sides.

204
Problems on the Road
Engine Overheating (cow.)
IO. Then replace the pressure cap. Be
sure the
arrows on the pressure cap
line up like this.
1 1. Check the coolant recovery tank.
The coolant level should be at
HOT
when the engine is hot and at
COLD when the engine is cold.
Ifa Tire Goes Flat
It’s unusual for a tire to (‘blow out’’
while you’re driving, especially if you
maintain your tires properly. If air goes
out
of a tire, it’s much more likely to
leak out slowly. But
if you should ever
have a “blowout,” here are a few tips
about what to expect and what to do:
If a front tire fails, the flat tire will
create a drag that pulls the vehicle
toward that side. Take your foot
off the
accelerator pedal and
grip the steering
wheel firmly. Steer to maintain lane
position, then gently brake to a stop
well out of the trafEic lane.
A rear blowout, particularly on a curve,
acts much like a skid and may require
the same correction you’d use in a skid.
In any rear blowout, remove your foot
from the accelerator pedal. Get the
vehicle under control by steering the
way you want the vehicle to go. It may
be very bumpy and noisy, but you can
still steer. Gently brake to a stop, well
off the road if possible.
If your tire goes flat, the
next section
shows how to use your jacking
equipment to change a flat tire safely.

Changing a Flat Tire
If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level
place. Turn on
your hazard warning flashers.
1. Set the parking brake firmly.
2. Put the shift lever in P (Park).
3. Turn off the engine.
To be even more certain the vehicle won't move, you can put chocks at the
front and rear of the tire farthest away
from the one being changed. That would
! the tire on the other side of the vehicle. at the omosite end.
c& ..:
The following steps will tell you how to
use the jack and change a tire.
The equipment you'll need is
in the
trunk.
1. Pull the carpeting from the Boor of
the trunk.
2. Turn the center retainer bolt on the
compact spare tire housing
countercloclwise to remove it, then
lift
the^ tire cover.
205

17. Store the flat tire as far forward in
the trunk
as possible. Store the jack
and wheel wrench in their
compartment in the trunk.
only. Replace the compact spare t&e
with a full-size tire
as soon as you can.
See
Compact Spare Tire later in this
section.
Compact Spare Tire
Although the compact spare was fully
inflated when your vehicle was new,
it
can lose air after a time. Check the
inflation pressure regularly. It should be
60 psi (420 1rPa). The compact spare is
made to
go up to 3,000 miles (5 000 km), ' so you can finish your trip and have
your full-size tire repaired or replaced
where you want. Of course, it's best to
replace your spare with a full-size tire as
soon as you can. Your spare will last
longer and be in
good shape in case you
need it again. Your anti-lock brake
2LI

Then go to the front of the vehicle and
release the secondary hood release.
Lift the hood. An electric fan
under the
hood can start up and injure
you even when the engine is not
running. Keep hands, clothing and
tools away from any underhood
electric fan.
‘I f. E
F
Things that burn can get on
hot engine parts and start a
fire. These include liquids like gasoline,
oil, coolant, brake fluid,
windshield washer and other fluids,
and plastic or rubber.
You or others
nnuld be burned. Be careful not to
-,3p or spill things that will burn
onto
a hot enqine.
I
3efore closing the hood, be sure all the
iller caps are on properly. Then just
~ll the hood down and close it firmly.
223

224
P P
3,IL V6 Engine (CODE TI
When you open the hood, you’ll see:
1. Power Steering Fluid Reservoir
2. Automatic Transaxle Fluid Dipstick
3. Brake Fluid Reservoir
4. Windshield Washer Fluid Reservoir
5. Battery
6. Air Cleaner
7. Engine Oil Fill Cap
8. Engine Oil Dipstick
9. Radiator Pressure Cap
IO. Engine Coolant Reservoir
W6118