1993 CHEVROLET TRACKER parking brake

Your Driving and the Road
= - 9 188
3. Shift your automatic transmission
into
P (Park), or your manual
transmission into
2 (Second).
4. Shift the transfer case to N (Neutral).
5. Set the hubs to FREE. See
“Four-Wheel Drive” in the Index.
6. Release the parking brake. Stop towing every
200 miles (300 km)
and
start the engine. Leave the transfer
case shift lever in
N (Neutral). Shift
your automatic transmission
to
D (Drive); leave a manual transmission
in
2 (Second) and release the clutch.
Run the engine at medium speed for one
minute to circulate
the oil in the transfer
case. Turn
the ignition key to ACC.
Now, you can continue towing your
Geo
.
NU I Kt
Make sure that the towing speed
does not exceed
50 mph
(80 km/h), or your Geo could
badly damaged.
ProCarManuals.com

Problems on the Road
To Jump Start Your Geo
1. Check the other vehicle. It must have
a 12-volt battery with a negative
ground system.
If the other system isn’t a 12-volt I
system with a negative ground,
both vehicles can
be damaged.
I I
2. Get the vehicles close enough so the
jumper cables can reach, but be sure
the vehicles aren’t touching each
other.
If they are, it could cause a
ground connection you don’t want.
You wouldn’t be able
to start your
Geo, and the bad grounding could
darnage the electrical systems.
CAUTION -1
A
You could be injured if the
vehicles roll. Set the parking
brake firmly on each vehicle. Put
an automatic transmission in
P (Park) or a manual transmission
in
N (Neutral). If you have a
four-wheel-drive vehicle, be sure
the transfer case
is not in
N (Neutral).
ProCarManuals.com

That your vehicle has rear-wheel
drive, or that
it has the
four-wheel-drive option.
vehicle.
The make, model, and year of your
Whether you can still move the shift
levers for the transmission and
transfer case,
if you have one.
If there was an accident, what was
damaged.
When the towing service arrives, let the
tow operator know that this manual
contains detailed towing instructions and
illustrations. The operator may want to
see them.
* T- help avoid injury to you or
Never let passengers ride in a
vehicle that is being towed.
Never tow faster than safe or
posted speeds
Never tow with damaged parts
not fully secured.
0 Never get under your vehicle
after it
has been lifted by the
tow truck.
chains on each side when towing
a vehicle.
hooks instead.
* Always use separate safety
Never use T-hooks. Use “J”
When your vehicle is being towed, have
the ignition key off. The steering wheel
should be clamped
in a straight-ahead
position, with
a clamping device
designed for towing service.
Do not use
the vehicle’s steering column lock for
this. The transmission and transfer case,
if you have one, should be in Neutral
and the parking brake released.
ProCarManuals.com

CAUTION
A
Changing a tire can cause an injury. The vehicle can slip off the jack
and roll over you or other people. You and they could be badly injured.
Find a level place to change your tire.
To help prevent the vehicle from
moving:
1. Set the parking brake firmly.
2. Put the shift lever in P (Park).
3. Shift a manual transmission to 1 (First) or R (Reverse).
4. If you have a four-wheel-drive vehicle, be sure the transfer case is in a
5. Turn off the engine.
To be even more certain the vehicle won’t move, you can put chocks at the
front and rear of the tire farthest away from the one being changed. That
would be the tire on the other side of the vehicle, at the opposite end.
drive gear
- not in N (Neutral).
I The following steps will tell
you how to use the jack and change a tire. The
equipment you’ll need
is under the
front seats.
The jack and wheel wrench are under
the passenger’s seat.
209 =
ProCarManuals.com

Service & Appearance Care
... 236
Let the engine run at idle for three
minutes or more.
To check the fluid hot or cold:
Park your vehicle on a level place.
Place the shift lever in P (Park) with
the parking brake applied.
With your foot on the brake pedal,
move the shift lever through each gear
range, pausing for about three seconds
in each range. Then, position the shift
lever in
P (Park).
Then, without shutting off the engine,
follow these steps:
1. Pull out the dipstick and wipe it with
2. Push it back in all the way, wait
a clean rag
or paper towel.
three seconds and then pull
it back
out again.
3. Check both sides of the dipstick, and
read the lower level. The fluid level
must be
in the COLD (A) area for a
cold check or in the
HOT (B) or
cross-hatched area for a hot check.
4. If the fluid level is where it should
be, push the dipstick back
in all the
way.
How to Add Fluid:
Refer to the Maintenance Schedule to
determine what kind of transmission fluid to use.
See “Recommended Fluids
and Lubricants”
in the Index.
If the fluid level is low, add only
enough of the proper fluid to bring the
level up into the COLD area for a cold
check or the
HOT area for a hot check.
It doesn’t take much fluid, generally less
than a pint. Don’t overfill. We
recommend you use only fluid labeled
DEXRON@-11, because fluids with that
label are made especially for our
automatic transmission. Damage caused
by fluid other than DEXRON@-I1 is not
covered by your new vehicle warranty.
ProCarManuals.com

Service & Appearance
I Replacement Bulbs
Care
Back-up ............................................................. 1156
Dome
............................................................. 9605 1559
Front Parking and Turn Signal
......................................... 1157 NA
Headlight (Halogen) ..................................................... 9004
Heater or Air Conditioning Control
.................................... 96052599
Charging System
................................................... 9433184
Check Engine
..................................................... 9433 184
Engineoil Pressure
................................................ 9433184
Indicator
and Warning
Brake
............................................................ 9433184
4WD
............................................................. 9433184
Headlight HighBeam
............................................... 9433184
Safety Belt
........................................................ 9433184
TurnSignal
....................................................... 9433184
Instrument Cluster
.................................................... 9605 156
License Plate
............................................................ 194
Lighter
............................................................. 9433184
Rear Defogger Switch
............................................. 96061736
Rear Wiper/Washer Switch
........................................... 9606 1736
Rear
Hazard and Turn Signal
........................................... 1156
Rear Parking andstop
................................................... 1157
Sidemarker
................................................. ........ 194
9 - 276
ProCarManuals.com

Maintenance Schedule
Section B: Owner Checks and Services (Cont.)
.r
Body Lubrication Lubricate all body door hinges including the tailgate. Also lubricate all hinges and latches,
including those for the hood, rear compartment, glove box door, console door and any folding
seat hardware. Section
D tells you what to use.
Starter Switch
At Least Once a Year
?
CHECK
OR SERVICE WHAT TO DO
Kev Lock Cylinders Lubricate the key lock cylinders with the lubricant specified in Section D.
1. Before you start, be sure you have enough room around the vehicle.
2. Firmly apply both the parking brake (see “Parking Brake” in the Index if necessary) and the
NOTE: Do not use the accelerator pedal, and be ready to turn off the engine immediately if it
3. On automatic transmission vehicles, try to start the engine in each gear. The starter should
work only in
P (Park) or N (Neutral). If the starter works in any other position, your vehicle
needs service, On manual transmission vehicles, put the shift lever
in Neutral, push the
clutch down halfway and try to start the engine. The starter should work only when the clutch
is pushed down
all the way to the floor. If the starter works when the clutch isn’t pushed all
the way down, your vehicle needs service.
regular
brake.
starts.
I.. 300
ProCarManuals.com

At Least Once a Year (CONT.)
CHECK
OR SERVICE 4- WHAT TO DO
Brake-Transaxle Shift
Interlock
- BTSI
(Automatic Transaxle)
I CAUTION m A When you are doing this check, the vehicle could move suddenly. If it does, you or others I
1. Before you start, be sure you have enough room around the vehicle. It should be parked on a
2. Firmly apply the parking brake (see “Parking Brake” in the Index if necessary).
NOTE: Be ready to apply the regular brake immediately if the vehicle begins to move.
3. With the engine off, turn the key to the ON position, but don’t start the engine. Without
level
surface.
applying the regular brake,
try to move the shift lever out of P (Park) with normal effort. If
the shift lever moves out of
P (Park), your vehicle’s BTSI needs service.
301 9
ProCarManuals.com