1993 CHEVROLET CAMARO check oil

Service & Appearance Care
. = 226
Engine Oil 3.4L L32 (Code S)
It's a good idea to check your engine oil
every time
you get fuel. In order to get an
accurate reading, the oil must be warm
and the vehicle must be on level ground,
5.7L LTl (Code P)
Turn off the engine and give the oil a few
minutes to drain back into the oil
pan. If
you don't, the oil dipstick might not show
the actual level.
To Check Engine Oil
(3.4L L32 (Code S) Engine)
Pull out the dipstick and clean it with a
paper towel or cloth, then push it back in
all the way. Remove it again, keeping the
tip lower.
ProCarManuals.com

To Check Engine Oil
(5.7L LT1 (Code P) Engine)
Pull out the dipstick slightly. Pinch the
end of the dipstick tube as you remove
the dipstick to wipe the oil from it.
Then
push it all the way back in. Now remove
it without pinching the tube, keeping the
tip lower.
3.4L L32 (Code S:
When to Add Oil:
If the oil is at or below the ADD line, then
you’ll need
to add some oil. But you must
use the right kind. This section explains
what kind
of oil to use. For crankcase
capacity, see “Capacities and
Specifications” in the Index.
11 NOTICE:
UUll 1 auu LUU IIIULII u11. 11 ywul
engine has so much oil that the oil
I level gets above the cross-hatched
area that shows the proper operating
I
range, you
damaged.
I I
5.7L LT1 (Code P)
Just fill it enough to put the level
somewhere in the proper operating range.
Push the dipstick all
the way back in
when you’re through.
227 9
ProCarManuals.com

Automatic Transmission Fluid
When to Check and Change:
A good time to check your automatic
transmission fluid level is when the
engine oil is changed. Refer
to the
Maintenance Schedule
to determine when
to change your fluid. See “Scheduled
Maintenance Services” in the Index.
How to Check:
Because this operation can be a little
difficult, you may choose to have this
done at a Chevrolet dealership Service
Department.
If you do it yourself, be sure to follow all
the instructions here,
or you could get a
false reading
on the dipstick. damage
your transmission.
Too
much can mean that some of thr
fluid could come
out and fall on hc
~.: engine parts, starting a fire. Be sure
to get an accurate reading if you ~“* check your transmission fluid. ~, \- ~
%it at least 30 minutes before checking
he transmission fluid level
if you have
>een driving:
D When outside temperatures are above
At high speed for quite a while.
0 In heavy traffic - especially in hot
While pulling a trailer.
90°F (32°C).
weather. To
get the right reading, the fluid should
be at normal operating temperature,
which is 180°F to 200°F
(82°C to 93°C).
To check transmission fluid hot: Get
the vehicle warmed up by driving
about
15 miles (24 km) when outside
temperatures are above
50°F (10OC). If
it’s colder than
50°F (lO”C), drive the
vehicle in
D (Third Gear) until the engine
temperature gage moves and then remains
steady for ten minutes. Then follow the
hot check procedures.
To check transmission fluid cold: A cold
check is made after the vehicle has been
sitting for eight hours
or more with the
engine off and
is used only as a reference.
Let the engine run at idle for five minutes
233 = =
ProCarManuals.com

3. Check both sides of the dipstick, and
read the lower level. The fluid level
must be
in the COLD area for a cold
check or in the
HOT area or
cross-hatched area for a
hot check.
4. If the fluid level is where it should be,
push the dipstick back
in all the way.
How to Add Fluid:
Refer to the Maintenance Schedule to
determine what kind of transmission fluid
to use. See “Recommended Fluids and
Lubricants” in the Index. If the fluid level is low, add only enough
of the proper fluid to bring the level up to
the COLD area for
a cold check or the
HOT area for a hot check. It doesn’t take
much fluid, generally less than a pint.
Don’t overfill. We recommend you use
only fluid labeled
DEXRON@-IIE,
because fluids with that label are made
especially for your automatic
transmission. Damage caused by
fluid
other than DEXRON@-IIE is not covered
by your new vehicle warranty.
After adding fluid, recheck the fluid
level as described under “How to
Check.”
obtained, push the dipstick back
in all
the way.
When the correct fluid level is
Manual Transmission Fluid
When to Check:
A good time to have it checked is when
the engine oil is changed. However, the
fluid in your manual transmission doesn’t
require changing.
How to Check:
Because this operation can be a little
difficult, you may choose to have this
done at a Chevrolet dealership Service
Department.
If
you do it yourself, be sure to follow all
the instructions here, or you could get a
false reading.
235 9
ProCarManuals.com

I I A If you have too much brake
L , fluid, it can spill on the engine.
‘-L: fluid will burn if the engine is
hot enough. You or others could be
burned, and your vehicle could be
damaged. Add brake fluid only
when work is done
on the brake
hydraulic system.
Refer to the Maintenance Schedule
to
determine when to check your brake
fluid. See “Periodic Maintenance
Inspections” in the Index.
- Y
tE
fl
a1
11
c1
A
s:
P
b Check Brake Fluid:
ou can check the brake fluid without
king
off the cap. Just look at the brake
.uid reservoir. The fluid level should be
bove the plastic seam in the reservoir.
: It isn’t, have your brake system
hecked to see
if there is a leak.
,fter work
is done on the brake hydraulic
ystem, make sure the level
is above the
lastic seam, near
the base of the filler
eck.
dhat to Add:
When you do need brake fluid, use only
DOT-3 brake fluid - such as Delco-
Supreme
1 l@ (GM Part No. 1052535).
Use new brake fluid from a sealed
container only.
*I
NOTICE: I
0 DOT-5 silicone brake fluid can
damage your vehicle. Don’t
use it.
0 Don’t let someone put in the
wrong kind of fluid. For
example, just a few drops
mineral-based oil, such a5
engine oil, in your brake
system can damage brake
system parts
so badly that
they’ll have to be replaced.
Srake fluid can damage p----.,
-0 be careful not to snill brake
ProCarManuals.com

Crankcase VIN Engine Code
S .................................... 4.0 qt. (3.8 L)**
VIN Engine Code
P
Without Filter Change ................................ 4.0 qt. (3.8 L)**
With Filter Change
................................... 4.5 qt. (4.3 L)**
Fuel Tank
........................................... 15.5 gal. (58.7 L)
Manual Transmission Five-Speed
........................................... 5.9 pt. (2.8 L)*
Six-Speed ........................................... 8.0 pt. (3.8 L)*
Rear Axle Lubricant .................................... 4 fl. 02. (1 18 ml)
Vehicle Dimensions
Wheelbase ........................................... 101.1 “ (2 566 mm)
Tread Front
.............................................. .60.7“ (1 542 mmj
Rear
.............................................. .60.6” (1 540 mm)
Length
.............................................. 193.2” (4 908 mm)
Width
............................................... 74.1 “ (1 883 mm)
Height
............................................... 5 1.3“ (1 303 mm)
*Recheck fluid level after filling. See “Automatic Transmissio\
n Fluid”
or “Manual
Transmission Fluid” in the Index.
**Recheck the oil level after filling. See “Engine Oil” in the Index.
I
283
ProCarManuals.com

IMPORTANT: I
KEEP ENGINE OIL
AT THE PROPER
LEVEL AND CHANGE AS I
This part covers the
maintenance required
for your
Chevrolet . Your vehicle needs
these services to retain its safety.
dependability and emission
control performance
.
Section
.
Part
Maintenance Schedule
Introduction: A Word about Maintenance ........................... 286
Your Vehicle and the Environment
............................ 286
How This Part
Is Organized ................................. 287
A . Scheduled Maintenance Services ............................... 289
Using Your Maintenance Schedules
........................... 289
Selecting the Right Schedule
................................. 289
Schedule
I ................................................ 290
Schedulen
............................................... 292
Explanation
of Scheduled Maintenance Services ................. 294
B . Owner Checks and Services ................................... 298
At Each Fuel Fill
.......................................... 298
At Least Once a Month ..................................... 299
At Least Twice a Year ...................................... 299
At Least Once a Year ....................................... 300
C . Periodic Maintenance Inspections .............................. 303
D . Recommended Fluids and Lubricants ........................... 305 I
E . MaintenanceRecord ......................................... 308
piqm I
Have you purched the GM Protection Plan ? The Plan
supplements
your new car warranties .
See your GM dealer for details .
285 .
ProCarManuals.com

Maintenance Schedule
Section A: Scheduled Maintenance Services (Cont.)
Eirplanation of Scheduled Maintenance Semices
Below are explanations of the services listed in Schedule I
and Schedule 11.
The proper fluids and lubricants
to use are listed in Section
D. Make sure whoever services your vehicle uses these. All
ITEM
NO. SERVICE
1 Engine Oil and Filter Change* - Always use SG
Energy Conserving I1 oils of proper viscosity. The
SG designation may be shown alone or in
combination with others, such as
SGKC, SG/CD,
or SF, SG, CC, etc. To determine the preferred
viscosity for your vehicle’s engine (e.g., SAE
5W-30 or 10W-30), see “Engine Oil” in the Index.
2 Chassis Lubrication - If your vehicle is equipped
with grease fittings, lubricate the suspension and
steering linkage. Lubricate the transmission shift
linkage. parts should be replaced and all necessary repairs done
before
you or anyone else drives the vehicle.
NOTE: To determine your engine’s displacement and code, see ‘‘Engine Identification” in the Index.
ITEM
NO. SERVICE
3 Tire and Wheel Rotation and Inspection - For
proper wear and maximum tire life, rotate your tires
following the instructions in this manual. See “Tires, Inspection and Rotation’’
in the Index.
Check the tires for uneven wear or damage. If
you
see irregular or premature wear, check the wheel
alignment. Check for damaged wheels also.
Inspect the belt for cracks, fraying, wear and proper
tension. Replace
as needed.
4 Engine Accessory Drive Belt Inspection* -
I
*An Emission Control Service.
9 294
ProCarManuals.com