Downloaded from www.Manualslib.com manuals search engine CAUTION: (Continucd)
remove any rust or dirt from the places where the wheel
attaches to the vehicle. In an emergency,
you can use a cloth or a
paper towel to do this; but be sure to use a scraper or wire
brush later,
if you need to, fr) get all the rust or dirt off.
Remove any rust or dirt from the wheel bolts, mounting surfaces or spare
wheel. Place the spare
on the wheel mounting surface.
Never use oil or grease on studs or nuts.
If you do, the nuts
might come loose. Your wheel could fall off, causing
a serious
accident.
I
r
Replace the wheel
nuts
with the
rounded end
of the
nuts toward the
wheel. Tighten each
nut
by hand until the
wheel
is held against
the hub.
25 3
Downloaded from www.Manualslib.com manuals search engine While the tires available as standard or optional equipment on General
Motors vehicles may vary
with respect to these grades, all such tires meet
General Motors performance standards and have been approved for use
on General Motors vehicles. All passenger type
(P Metric) tires must
conform to Federal safety requirements in addition
to these grades.
meel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced carefully at the
factory to give
you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again.
However,
if you notice unusual tire wear or your vehicle pulling one way
or the other,
the alignment may need to be reset. If you notice your
vehicle vibrating
when driving on a smooth road, your wheels may need
to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked or badly rusted. If wheel nuts
keep coming loose, the wheel, wheel bolts, and wheel nuts should be
replaced. If the
wheel leaks air out, replace it (except some aluminum
wheels, which can sometimes be repaired). See your Cadillac dealer if any
of these conditions exist.
Your dealer
will know the kind of wheel you need.
Each new
wheel should have the same load carrying capacity, diameter,
width, offset, and be mounted the same way as the one
it replaces.
If you need to replace any of your wheels, wheel bolts, or wheel nuts,
replace them only
with new GM original equipment parts. This way, you
will be sure to have the right wheel, wheel bolts, and wheel nuts for your
Cadillac model.
312
Downloaded from www.Manualslib.com manuals search engine ‘ 1 CAUTION:
Using the wrong replacement wheels, wheel bolts, or wheel nuts
on your vehicle can be dangerous. It could affect the braking
and handling of your vehicle, make your tires lose air and make
you lose control. You could have a collision in which you or
others could be injured. Always use the correct wheel, wheel
bolts, and wheel nuts for replacement.
Used Replacement Wheels
I
A CAUTION
Putting a used wheel on your vehicle is dangerous. You can’t
know how it’s been used
or how many miles it’s been driven. It I
could fail suddenIy and cause an accident. If you haw ~ II replace
a wheel use anew GM original equipment wheel. I
I
I
3 13
