Page 26 of 398
Downloaded from www.Manualslib.com manuals search engine SAFETY BELTS: THEY’RE FOR EVERYONE
This part of the manual tells you how to use safety belts properly. It also
tells you some things you should not do with safety belts.
And it explains the Supplemental Inflatable Restraint, or “air bag”
system.
A CAUTION:
Don’t let anyone ride where they can’t wear a safety belt
properly.
If you are in a crash and you’re not wearing a sa
belt, your injuries can be much worse. You can hit things
the vehicle
or be ejected from it. You can be seriously inj
killed. In the same crash, you might not be if
you are bu
up.
Always fasten your safety belt, and check that your ,*-*:.;...
passengers’ belts are fastened properly too. -1 y* *‘
This figure lights up when you turn the key to “Run” or “Start” when
your safety belt isn’t buckled, and
you’ll hear a chime, too. It’s the
reminder to buckle up.
12
Page 42 of 398

Downloaded from www.Manualslib.com manuals search engine A CAUTION
Air bags inflate with great force, faster than the blink of an eye. :
If you’re too close to an inflating air bag, it could- seriously
injure
you. Safety belts help keep you in position for an air bag
inflation in a crash, Always wear your safety belt, even with -an-
;74
-+< . v
, . .4:2
- fair bag, and the driver should sit as far back as possible 2.
-‘r I -. r: ’ still maintaining control of the vehicle.
An inflating air bag can seriously injure small children.. -Always
.secure children properly in your vehicle, To read how, see the
“Children
and Safety Belts” section of this manual, andmad
the caution label
on the front-passenger’s safety belt,
Air Bag System Light
There is an air bag readiness light on the instrument panel. The system
checks itself and the light tells you
if there is a problem.
INFL.
REST.
INFLATABLE
RESTRAINT
You will see this light
flash
for a few seconds
when you
turn your
ignition to
“Run” or
“Start.” Then the light
should
go out, which
means the system
is
ready.
1
1
1
28
Page 81 of 398

Downloaded from www.Manualslib.com manuals search engine interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Should interference to this system occur, try this:
0 Check to determine if battery replacement is necessary. See the
instructions on battery replacement.
0 Check the distance. You may be too far from your vehicle. This
0 Check the location. Other vehicles or objects may be blocking the
product has a
maximum range.
signal.
See your Cadillac dealer or a qualified technician for service.
Changes or modifications to this system by other than an authorized
service facility could void authorization to use this equipment.
Operation
Press this symbol to
unlock the driver’s
door. Press it again
within
4 seconds to
unlock the other
doors. Pressing this
button will also
disarm the Theft
Deterrent System
and turn on
the
interior lights.
Press this symbol to
lock your doors.
This also arms the
Theft Deterrent
System.
67
Page 88 of 398

Downloaded from www.Manualslib.com manuals search engine How to Test The Alarm
0 Roll down your window and lock your vehicle using the power door
Reach in and unlock the door using the manual lock, and open the
If the alarm does not sound when it should, check to see if the horn
works. The horn fuse may
be blown. To replace the fuse, see “Fuses and
Circuit Breakers” in the Index.
lock
or the Keyless Entry System.
door. The horn
will sound and your headlights will flash.
To reduce the possibility of theft, always arm the theft deterrent system
when leaving your vehicle.
PASS-KEY IIm
Your vehicle is equipped with the PASS-Key I1 TM (Personalized
Automotive Security System) theft deterrent system. PASS-Key
I1 TM is a
passive theft deterrent system. This means
you don’t have to do anything
different to arm
or disarm the system. It works when you insert or remove
the key from the ignition. PASS-Key
TM uses a resistor pellet in the
ignition key that matches
a decoder in your vehicle.
When the PASS-Key
TI TM system senses that someone is using the wrong
key, it shuts down the vehicle’s starter
and fuel systems. For about three
minutes, the starter won’t work and fuel won’t go to the engine.
If
someone tries to start your vehicle again or uses another key during this
time, the vehicle will not start. This discourages someone from randomly
trying different keys with different resistor pellcts in
an attempt to make a
match.
The ignition key must
be clean and dry before it’s inserted in the ignition
or the engine may not start.
If the engine does not start and the
“SECURITY” light comes on, the key may be dirty
or wet. Turn the
ignition
off.
If you’re ever driving and the “SECURITY” light comes on and
continues to flash, you get the “PASS-KEY MALFUNCTION” message
and the “STARTING DISABLED” message appears, you
will be able to
restart your engine
if you turn it off. Your PASS-Key TI TM system,
however,
is not working properly and must be serviced bylour Cadillac
dealer. Your vehicle
is not protected by the PASS-Key I1 system.
74
Page 111 of 398
Downloaded from www.Manualslib.com manuals search engine As you signal a turn or a lane change, if the arrows don’t flash but just
stay on, a signal bulb may be burned out and other drivers won’t see your
turn signal.
If a bulb is burned out, replace it to help avoid an accident. If the green
arrows
don’t go on at ail when you signal a turn, check the fuse (see
“Fuses” in the Index) and for burned-out bulbs.
Headlight High-Low Beam
To change the
headlights from low
beam to high or high to
low, pull the turn signal
lever all the way toward
you. Then release it.
When the high beams
are on, a blue light on
the instrument panel
also will be
on.
Flash-To-Pass Feature
This lets you use your high beam headlights to signal a driver in front of
you that you want to pass. It works even if your headlights are off.
97
Page 114 of 398
Downloaded from www.Manualslib.com manuals search engine la CAUTION
splash-am block your vision. Yon could hit another vehicle or
go off the road. Check your washer fluid level often.
* Xn freezing weather, don't use your washer until the
windshield is warmed. Otherwise the washer fluid can fam
I Headlight Washer (Export Only)
If you have this feature, you will wash your headlights while washing your
windshield at the same time
in bad weather. Just press the PUSH paddle
on the multifunction lever.
100
U
c
0
fi
I
I
Page 121 of 398

Downloaded from www.Manualslib.com manuals search engine Twilight Sentinel
The control is next to the headlight switch. It switches your lights on and
off by sensing how dark
it is outside. To operate it, leave the light switch
off and move the control
to any position but off.
If you move the control all the way to MAX, your lights will remain on for
90 seconds after you turn your engine off. If you move the control almost
all the way in the other direction,
so it is just on, the lights will go off
quickly when you turn off your engine. You can change this delay time
from
only a few seconds to 90 seconds.
Operation of Lights
Although your vehicle’s lighting system (headlamps, parking lamps, fog
lamps, side marker lamps and tail lamps) meet all applicable Federal
lighting requirements, certain States and Provinces may apply their own
lighting regulations that may require special attention before
you operate
these lamps. For example, some jurisdictions may require that
you
operate your lower beam lamps with fog lamps at all times, or that
headlamps be turned on whenever
you must use your windshield wipers.
In addition, most jurisdictions prohibit driving solely with parking lamps,
especially at dawn
or dusk. It is recommended that you check with your
own State or Provincial highway authority for applicable lighting
regulations.
107
Page 138 of 398

Downloaded from www.Manualslib.com manuals search engine some warning lights come on briefly when you turn the ignition key just to
let you know they’re working.
If you are familiar with this section, you
should not be alarmed when this happens.
When one
of the warning lights comes on and stays on when you are
driving, check the section that tells you what to do about it. Please follow
the manual’s advice. Waiting to do repairs can be costly
-- and even
dangerous.
So please get to know your warning lights. They’re a big help.
Your vehicle may
also have a driver information system that works along
with the warning lights. See “Driver Information System” in the Index.
Brake System Warning Light
Your Cadillac hydraulic brake system is divided into two parts. If one part
isn’t working, the other part can still work and stop you. For good
braking, though, you need both parts working
well.
If the warning light goes on, there could be a brake problem. Have your
brake system inspected right away.
BRAKE
(0) BRAKE
This light should come
on as you start the
vehicle. If it doesn’t
come
on then, have it
fixed
so it will be ready
to warn you if there’s a
problem.
This light will also come
on when you set your parking brake, and will
stay
on if your parking brake doesn’t release fully. If it stays on after your
parking brake
is fully released, it means you have a brake problem. If the
light comes
on while driving, pull off the road and stop carefully. You may
notice that the pedal is harder
to push. Or, the pedal may go closer to the
floor. It may take longer to stop.
If the light is still on, have the vehicle
towed for service. (See “Towing Your Vehicle” in
the Index.)
124