Downloaded from www.Manualslib.com manuals search engine To fold a front seatback forward, push the seatback toward the rear as
you lift this latch. Then the seatback will fold forward. The latch must be
down for the seat to work properly.
SAFETYBELTS: THEY’RE FOR EVERYONE
This part of the manual tells you how to use safety belts properly. It also
tells you some things you should not
do with safety belt. And it explains
the Supplemental Inflatable Restraint, or “air bag” system.
I CAUTION: I
Don% let anyone ride where they can’t wear a safety belt
properly. If you are irr a crash and you’re not wearing a safety
belt, your injuries can be much worse. You c%n hit things inside
the vehicle or be ejected from it. You can be seriously inijared or
killed.
In the same crash, you might not be ifyou are buckled
up. Always fasten your safety belt, and check that your
passenge--’ belts are fastened properly too. I I-
10
Downloaded from www.Manualslib.com manuals search engine .- -
A CAUTION:
Air bags inflate with great force, faster than the blink of an eye.
If yoii’re too close to an inflating air bag, it could seriously
injure
you. Safety belts help keep you in position for an air bag
inflation in a crash. Always wear your safety belt, even with an
air bag, and sit as
far back as you can while still maintaining
control
of your vehicle,
Air Bag System Light
There is an air bag readiness light on the instrument panel, which shows
“Inflatable Restraint”. The system checks itself and the light tells you if
there
is a problem.
You will see this light
flash for a
few seconds
when you turn your
ignition to
“Run” or
“Start.” Then the light
should
go out, which
means the system
is
ready.
A CAUTION:
If the air bag readiness light doesn’t come on when you start
your vehicle, or stays on, or comes on when you are driving, your
air bag system may not work properly. Have your vehicle
serviced right
away.
29
Downloaded from www.Manualslib.com manuals search engine But if a safety belt isn’t long enough to fasten, your dealer will order you
an extender. It’s free. When you go in to order it, take the heaviest coat
you will wear,
so the extender will be long enough for you. The extender
will be just for you, and just for the seat in your vehicle that you choose.
Don’t
let someone else use it, and use it only for the seat it is made to fit.
To wear it, just attach it to the regular safety belt.
CHECKING YOUR RESTMNT SYSTEMS
Now and then, make sure all your belts, buckles, latch plates, retractors,
anchorages and reminder systems are working properly.
Look for any
loose parts or damage. If you see anything that might keep a restraint
system from doing its job, have it repaired.
REPLACING SAFETYBELTSAFTER A
CRASH
If you’ve had a crash, do you need new belts?
After a very minor collision, nothing may be necessary. But
if the belts
were stretched, as they would be
if worn during a more severe crash, then
you need new belts.
If belts are cut or damaged, replace them. Collision damage also may
mean you will have to have safety belt parts, like
the retractor, replaced
or anchorage locations repaired
-- even if the belt wasn’t being used at
the time of the collision.
If your seat adjuster won’t work after a crash, the special part
of the
safety belt that goes through the seat to the adjuster may need to be
replaced.
56
Downloaded from www.Manualslib.com manuals search engine Should interference to this system occur, try this:
0 Check to determine if battery replacement is necessary. See the
instructions on battery replacement.
0 Check the distance. You may be too far from your vehicle. This
0 Check the location. Other vehicles or objects may be blocking the
product has
a maximum range.
signal.
See your Cadillac dealer or a qualified technician for service.
Changes or modifications to this system by other than an authorized
service facility could void authorization to use this equipment.
Operation
The driver’s door will unlock automatically when “UNLOCK” is pressed.
If “UNLOCK” is pressed twice, all doors will unlock. All doors will lock
when “DOOR” is pressed. The trunk will unlock
when the opened trunk -
symbol is pressed.
The Keyless Entry System allows a transmitter to be matched to as many
different vehicles as you own with this system. Each vehicle can
have only
two transmitters matched to it.
P-
The transmitter will arm the Theft Deterrent System whenever the doors
are closed and
you push the DOOR button. It will disarm the system
when you push the UNLOCK button.
-
,.
If your Cadillac is equipped with the Illuminated Entry System, you can
make it
work by pushing any button on the transmitter. The lights will
stay on for
20 seconds.
Matching Transmitter (s) To Your Vehicle
Each key chain transmitter is coded to prevent another transmitter mom
unlocking your vehicle.
If a transmitter is lost or stolen, a replacement --
can be purchased through your dealer. Remember to bring the remaining
transmitter with
you when you go to your dealer. When the dealer
matches the replacement transmitter to your vehicle, the remaining
transmitter must also be matched. Once the new transmitter is coded, the
lost transmitter will not unlock your vehicle.
-
Downloaded from www.Manualslib.com manuals search engine Always unlock a door with a key, or use the Keyless Entry System.
If you set
off the alarm by accident, unlock any door with your key.
You can also turn off the alarm by using the Keyless Entry System,
if you
have it. The alarm
won’t stop if you try to unlock a door any other way.
Unlocking
a door
any other way will set off the alarm.
How to Test The Alarm
Roll down your window and lock your vehicle using the power door
Reach in and unlock the door using the manual lock, and open the
If the alarm does not sound when it should, check to see if the horn
works.
The horn fuse may be blown. To replace the fuse, see “Fuses and
Circuit Breakers”
in the Index.
To reduce the possibility of theft, always arm the theft deterrent system
when leaving your vehicle.
PASS-KEY IIm
lock or the Keyless Entry System.
door. The horn
will sound and your headlights will flash.
(Personalized
I
Your vehicle is equipped with the PASS-Key I1
Automotive Security System) theft deterrent system. PASS-Key I1 is a
passive theft deterrent system.
This means you don’t have to do anything
different
to arm or disarm the system. It works when you insert or remove
~ ~~
Downloaded from www.Manualslib.com manuals search engine - the key from the ignition. PASS-Key TM uses a resistor pellet in the
ignition key that matches a decoder in your vehicle.
When the PASS-Key
11 TM system senses that someone is using the wrong
I_ key, it shuts down the vehicle’s starter and fuel systems. For about three
minutes, the starter won’t work and fuel won’t go to the engine. If
someone tries to start your vehicle again or uses another key during this
.- time, the vehicle will not start. This discourages someone from randomly
trying different keys with different resistor pellets
in an attempt to make a
match.
~ ~ .~ The ignition key must be clean and dry before it’s inserted in the ignition
or the engine may not start. If the engine does not start and the
“SECURITY” light comes on, the key may be dirty
or wet. Turn the
ignition
off.
Clean and dry the key. Wait about three minutes and try again. The
security light will remain on during this time. If the starter still won’t
and try the other ignition key. At this time, you may also want
to check
the fuse (see “Fuses and Circuit Breakers”
in the Index). If the starter
won’t work with the other key, your vehicle needs service.
If your vehicle
does start, the first ignition key may be faulty. See your Cadillac dealer or
a locksmith who can service the PASS-Key I1
TM .
. -.
~ work, and the key appears to be clean and dry, wait about three minutes
If you accidentally use a key that has a damaged or missing resistor pellet,
the starter won’t work and the security light
will flash. But you don’t have
to wait three minutes before trying one
of the other ignition keys.
~- See your Cadillac dealer or a locksmith who can service the Pass-Key I1 TM
to have a new key made.
-
If you’re ever driving and the “SECURITY” light comes on and stays on,
~- you will be able to restart your engine if you turn it off. Your PASS-Key I1 TM
system, however, is not working properly and must be serviced by your
Cadillac dealer. Your vehicle is
not protected by the PASS-Key I1 TM system.
while the security light stays
on as described. So you should service your
vehicle as soon as possible.
If you lose or damage a PASS-Key I1
TM ignition key, see your Cadillac
dealer or a locksmith who can service PASS-Key I1
TM to have a new key
made.
I_
Downloaded from www.Manualslib.com manuals search engine To start vour V8 engine:
1. Don’t push the accelerator pedal before starting your engine. In some
other vehicles you might need to do this, but because
of your vehicle’s
computer systems, you don’t.
c
2. Turn your ignition key to “Start.” When the engine starts, let go of the
key. The idle speed
will go down as your engine gets warm.
3. If it doesn’t start right away, hold your key in “Start” for about three
seconds at a time until your engine starts. Wait about
15 seconds
between each try to help avoid draining your battery.
-
-
will cause your battery to be drained much so0
ive heat can damage your starter motor.
-
4. If your engine still won’t start (or starts but then stops), it could be
flooded with too much gasoline. Try pushing your accelerator pedal all
the way to the floor and holding it there
as you hold the key in “Start’’
for about three seconds.
If the vehicle starts briefly but then stops
again, do
the same thing.
Jour ~II~III~: IS ueslgrleu LU work wi
ding electrical equipment, check with your d
n’t, your engine might not
perform properly.
nual that tells how
to do it without damagi
“Towing Your Vehicle” in the Index.
76
r
Downloaded from www.Manualslib.com manuals search engine If a bulb is burned out, replace it to help avoid an accident. If the green
arrows don’t go on at all when you signal a turn, check the fuse (see
“Fuses”
in the Index) and for burned-out bulbs.
Operation of Lights
Although your vehicle’s lighting system (headlights, parking lights, fog
lamps, side marker lights and taillights) meet all applicable federal
lighting requirements, certain states and provinces may apply their own
lighting regulations that may require special attention before you operate
these lights. For example, some jurisdictions may require that you operate
your lower beam lights with fog lamps at all times, or that headlights be
turned on whenever you must use your windshield wipers. In addition,
most jurisdictions prohibit driving solely with parking lights, especially at
dawn
or dusk. It is recommended that you check with you own state or
provincial highway authority for applicable lighting regulations.
Headlight High-Low Beam
To change the
headlights
from low
beam to high or high
6-
low, pull the turn signai
lever all the way toward
you. Then release it.
-’
When the high beams
are
on, this blue light
on the instrument
7
panel also will be on.
94