1993 BUICK ROADMASTER light

The lever on the left side of the steering column
includes your:
0 Turn Signal and Lane Change Indicator
0 Headlight High-Low Beam & Passing Signal
Windshield Wipers The
turn signal has two upward (for Right) and two
downward (for Left) positions. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
0 Windshield Washer
Cruise Control (Option) instrument panel will flash
Turn Signal and Lane Change Indicator , ' in the direction of the turn
.-- A green arrow on the
I .or lane change.
To signal a lane change, just raise
or lower the lever
until the green arrow starts
to flash. Hold it there until
you complete your lane change. The lever will return by
itself when you release it.

As you signal a turn or a lane change, if the arrows don't
flash but just stay on, a signal bulb may be burned out
and other drivers won't see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the green arrows don't go on at all when you
signal a turn, check the fuse (see "Fuses" in the Index)
and for burned-out bulbs.
If you have a trailer towing option with added wiring for
the .trailer lights, a different
turn signal flasher is used.
With this flasher installed, the signal indicator will flash
even if
a turn signal bulb is burned out. Check the front
and rear turn signal lights regularly to make sure they
are working.
Turn Signal Reminder
A chime will sound if your turn signal remains on after
having driven
1/2 mile, to remind you to turn off your
signal.
Operation of Lights
Although your vehicle's lighting system (headlamps,
parking lamps, fog lamps, side marker lamps and tail
lamps) meet all applicable Federal lighting
requirements, certain States and Provinces may apply their own lighting regulations that may require special
attention before you operate these lamps. For.example,
some jurisdictions may require that you operate your
lower beam lamps with fog lamps at -all times, or that
headlamps. be turned
on whenever you.must use your
windshield wipers. In addition, most jurisdictions
prohibit driving solely with parking lamps, especially at
dawn or dusk. It is recommended that you check with
you own State or Provincial highway authority. for
applicable lighting regulations.
Headlight High-Low Beam
To change the headlights.
l .from low beam to high or..'
:hi:& -to low, pull the turn
signal lever all the way
'toward you. Then .release it.
When the high beams are
on, a blue light, on the
instrument panel -also will
be on.
90

If you leave your Cruise Control si ch on when
you’re not using Cruise, you. might hit a button
and go into Cruise when you don’t want
to.. Yoe
could be startled and even lose control. Keel
I the Cruise Control switch “OFF’’ until you want
to use
it.
2. Get up to the speed you want.
3. Push in the set button
at the
end of ihe lever
and release
it.
(The “CRUISE’ light an
the instrument panel will
corne an.)
4. Take your foot off the. accelerator pedal.
To Resume a Set Speed
Suppose you set your Cruise Control at a desired speed
and then you apply the brake. This,
of course, shutsoff
the Cruise Control. But you don’t need to reset it. Once
you’re going- about 25 mph (40 h/h) or more, you can
move the Cruise Control switch from “ON’ to
“Resurne/Accelerate” for about half
a second.
95

Using LruIse Control on Hills
How well your Cruise Control will work on hills
depends upon your speed, load, and the steepness ofthe
hills. When going up steep hills, you may have to step
on the accelerator pedal to maintain: your speed. When
going downhill, you
may have to brake or shift to a
lower gear to keep your speed duwn.
Of course,
applying the brake takes you out of Cruise Control.
Many drivers find this to be too much trouble and don't
use Cruise Control
on steep hills., , .
To Get Out of Cruise'Control
There are two ways to turn off the Cruise Control:
1. Step lightly on the
., .-..
1; ;', , ;;brake pedal ; OR
! it
E
To Erase Speed Memory
When you turn off the Cruise Control or the ignition,
your Cruise Control .set speed memory is erased.

i
Lights
These switches control
the following li-ght
systems:
Headlight C60n?' Warning
If the light switch is left on you'll hear a warning tone
when
you turn off the ignitbn.
Twilight Sentinel (Option)
0
a
*
0
,*
a
Headlights
Taillights
Parking Lights
License Lights Sidemarker Lights
Instrument Panel Lights
Interior Courtesy Lights
By rotating the switch marked MAX and INT you can
make the instrument panel lights bright
or dim and turn
the courtesy lights
on or off.
Twilight Sentinel turns your
headlights on and
off '
autcimatically by sensing
how dark it is outside.
.. To operate it, leave the LIGHTS switch off and move
the Twilight Sentinel control to any position but
OFF.
99

Wagon Rear Lompartment Light and
Assist Handles .
There are courtesy lights and assist handles in the rear
compartment located on each side
of the tailgate
window.
Mirrors
Inside Mirror
When you are sitting in a comfortable driving position,
adjust the mirror
so: you can see clearly behind your car.
The day-night adjustment allows you
to adjust the
mirror
to avoid glare from the lights behind you.:

Automatic Mirror (Option)
Your Buick may have the automatic inside mirror.
The automatic mirror adjusts for the glare
of headlights
behind you. It detects changes
in light, and then adjusts
for day
or night operation.
During the day the mirror reflects all the light from
behind your car. At night; when the glare
is too high, it
changes to the night mode. Then, it reflects only part of
the light from behind you. When the mirror changes to
the night-mode,jt holds that position until glare is no
longer present.
d
Time Delay
The mirror delays before switchingcfrom the night back
to the day position. This delay prevents rapid changing
of the mirror as you drive under li-ghts and through
traffic.
Reverse Gear Day Mode
The-reverse mode is another important €eature of the
automatic mirror. When the shift lever
is placed in "R'
(Reverse), the mirror shifts to the day mode. This gives
you a bright image in the mirror
as you back up.
Automatic/Off Switch
Push the switch up for the AUTO position. The switch
cap will light indicating the mirror will automatically
adjust for glare.
To turn the automatic adjust off, push the switch down.
Front Reading Lights
There are two reading lights located on .the rearview
mirror. Push the switch closest'to the light to turn it on
or off.
103

Light Visor Vanity Mirror (Option) , .I. .. ,
The lighted visor vanity mirror lights up when the
mirror cover is opened.
Closing the mirror cover turns
off the lights.
i
Ashtrays
The front center ashtray may be lifted out for cleaning.