1993 BUICK RIVIERA instrument panel

The person keeps going until stopped by something.
In
a real vehicle, it could be the windshield ...
or the instrument panel ...
23

I A CAUTION:
Air bags :..Hate with great force, faster than the
blink of an eye. If you’re too close to an inflating
air bag, it could seriously injure you. Safety
belts help keep you
in position for an air bag
inflation
in a crash. Always wear your safety
belt, even with an air bag, and sit as far back as
you can while
still maintaining control of your
vehicle.
-
Air Bag System Light
There is an air bag readiness light on the instrument
panel, which shows “INFLATABLE RESTRAINT”. You
will see this light flash
for
a few seconds when you
The system checks itself and. $helight
?: tells you if there is
a problem. turn your ignition
to “Run”
or
“Start.” Then the light
should go out, which means
the system
is ready.
A CAUTION:
If the air bag readiness light doesn’t come on
when you start your vehicle, or stays on, or
comes on when you are driving, your air bag
system may not work properly. Have your
vehicle serviced right away.
33

Avoid wires wrapped with yellow tape, or yellow
connectors. They are probably part of the air bag
system.
But if the ignition has to be on for electrical work, or if
the steering column is to be disassembled, the air bag
system must be disconnected.
To do this:
Turn off the ignition.
0 ‘Remove the SIR (air bag) fuse (see “Fuses and
Circuit Breakers” in the Index).
Safety Belt Use During Pregnancy
Safety belts work for everyone, including pregnant t
women. Like all occupants, they are more likely to be
seriously injured if they don’t wear safety belts.
A pregnant woman should wear
a lap-shoulder belt, and ’
the lap portion should be wok as low as possible
throughout the pregnancy.
0 Disconnect the yellow connector at the&ase of the
When the work is complete, if the air bag system was
disconnected, be sure to reattach everything and replace
the fuse before turning the ignition
on. When you turn
the ignition key on, be sure you see the inflatable
restraint light on the instrument panel.
If you don’t see
this light flash and then
go out as usual, have your air
bag system repaired. steering column.
37

@) Part 2 Features & Controls
Here you can learn about the many standard and optional featur\
es on your Buick. and information on starting. shifting
and braking
. Also explained are the instrument panel and the warning systems that tell you if everything is working
properly
.. and what to do if you have a problem .
Part 2 includes:
Keys
........................................................................\
....
DoorLocks ....................................................................... \
NewVehicleBreak-In ..............................................................
StartingtheEngine .................................................................
ShiftingtheTransaxle ..............................................................
Windows ........................................................................\
.
TiltSteeringWheel ................................................................
Multi-FunctionLever ...............................................................
TurnandLaneChangeSignals ...................................................
Headlight High-Low Beam Changer ..............................................
Windshield Wipermasher ......................................................
CruiseControl ................................................................
Instrumentpanel ...................................................................
Speedometer and Odometer ......................................................
Warning Lights and Gages ......................................................
60
61
70
72
75 84
84
85
85 87
87
90
105
105
107
c 59

Headlight High-Low Beam
To change the headlights
from low beam to high or
high to low, pull the turn signal lever all the way
toward
you. Then release it.
When the high beams are
on, a blue light on the
instrument panel also will
be on.
If your headlights are on, but on low beam: The system
works normally. Just pull the lever until it clicks. Your
headlights will shift to high beam and stay there. To
return to low beam, just pull the lever toward you.
Windshield Wipers
Flash-To-Pass Feature
This feature lets you use your high beam headlights to
signal a driver in front of you that
you want to pass. It
works even if your headlights are
off.
To use it, pull the headlight beam toward you a little
(but not
so far that you hear a click). When you do:
If your headlights are off Your high beam headlights
will
turn on. They’ll stay on as long as you hold the
lever there. Release the lever to turn them
off.
.
. . . ~
You control the windshield wipers by turning the band
marked “WIPER.”
For a single wiping cycle, turn the band to
“MIST.”
Hold it there until the wipers start, then let go. The
wipers will stop after one cycle. If
you want more
cycles, hold the band on
“MIST” longer.
87

To Set Cruise Control
1. Move the Cruise
Control switch to
“ON.”
I A CAUTION:
2. Get up to the speed you want.
3. Push in set the button at
the end of the lever and
release it. (The
“C.RUISE” light on the
instrument panel
will
If you leave your Cruise Control switch on when
you’re not using Cruise, you might hit a button
and go into Cruise when you don’t want to. You
could be startled and even lose control. Keep
the Cruise Control switch
“OFF” until you want
to use it.
I
come on.)
4. Take your foot off the accelerator pedal.
91

Lights
'
1 0 Headlights
The LIGHTS switch controls these light systems:
Taillights
Parking Lights
0 License Lights
Sidemarker Lights
Instrument Panel Lights
0 Interior Courtesy Lights
Push the LIGHTS switch to turn the
headlights on or
off. Push the "P" (PARK) switch to turn the parking
lights
on or off.
Headlight ''On" Warning
If the light switch is left on you'll hear a warning tone
when you turn the ignition off and open the driver's
door.
\,
Panel and Interior Lights
The instrument panel light
brightness can be adjusted when the parking or
headlights are
on. Slide the
lever toward HI to make
them brighter; toward
LO to
dim them. Push the lever to
INT to
turn on the interior
lights.
96

Twilight Sentinel
Twilight Sentinel turns your headlights
on and off by
sensing how dark it
is
outside.
To operate
it, leave the light switch off and move the
Twilight Sentinel control to any position but
OFF.
If you move the control. all the way to MAX, your lights
will remain on for three minutes after you turn
off your
engine.
If you move the control almost all the way in the
other direction, the lights will
go off quickly when you
turn off your engine. You can change this delay time
from only a few seconds to three minutes. Your
Twilight Sentinel and Daytime Running Lights
(Canada Only) work with the light sensor
on top of your
instrument panel. Don’t cover it up, if you
do it will read
“dark” and your lights will come on.
97