Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF
Front
turn
signals
To
change a bulb the
turn
signal housing must be taken out to the
front.
•
Insert
the
flat
blade of a screwdriver be tween headlight and
turn
signal
with
bonnet
open.
This presses the securing tabs which hold the
turn
signal housing to the
side.
• Swing screwdriver to
front
as shown in illustration so
that
the
turn
signal housing is
pressed
out forward. • Turn bulb holder out to the
left.
• Turn bulb out and renew.
•
Insert
bulb holder. •
Insert
turn
signal housing in the grooves provided (top and
bottom)
and press it in
until
the securing tabs engage.
Fog
lights*
The foglight bulbs can betaken out from un
derneath the bumper.
• Turn cap on rear of fog
light
to the
left
to remove it.
• Unhook spring clip of bulb holder and swing it away.
• Take bulb out.
•
Insert
new bulb so
that
the locating lug on bulb plate engages
recess
in the reflec
tor.
• Swing spring clip over bulb plate,
squeeze
it together and engage it in the re
taining lugs.
• Fit cap again.
• Have beam alignment
checked.
Rear
lights
Renewal
of the bulbs for the rear lights is
done from the luggage compartment
through the rear panel trim.
•
Reach
into
the hole in the rear panel
trim
with
one hand and squeeze the two retaining tabs of bulb carrier together.
• Take bulb carrier out (illustration). •
Press
defective bulb
into
holder slightly,
turn
it to the
left
and take it out.
•
Insert
new bulb and
turn
fully to the
right
• Install bulb carrier.
125
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans
Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF
Rear
fog
light
• Renewal of the bulbs for the rear lights
is
done from the luggage compartment
through the rear panel trim.
• Take housing out.
• Turn bulb holder out to the
left.
• Take bulb out and renew.
• Turn bulb holder back in.
•
Insert
left
side of housing in the recess
first
and press in
firmly
until
the tabs en
gage.
Number
plate
lights
The lights are secured
with
2 screws.
• Take lens off
• Pull complete
light
out
• Pull bulb housing out • Pull defective bulb out and renew
•
Insert
bulb housing
• Secure lens
firmly
Interior
and
reading
light*
Interior
light
(A)
•
r.sert
a knife blade or something similar
into
gap between housing and lens and
carefully lever lens off.
• Change bulb.
• Dress lens
into
housing again, when doing this the lug on the lens must fit in the
recess
in the housing.
'26
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans
