1992 Lexus ES300 steering

MAINTENANCE
140Tire rotation
Rotate the tires every 12000 km (7500 miles). See page 183
for additional information.
Windshield wiper blades
Check for wear or cracks whenever they do not wipe clean.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid after
the vehicle has been parked for a while. If you smell fuel fumes
or notice any leak, have the cause found and corrected
immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate smoothly and
all latches lock securely. Make sure the engine hood
secondary latch still secures the hood when the primary latch
is released.
Vehicle interior
Items listed below should be checked regularly, e.g. while
performing periodic services, cleaning the vehicle, etc.
Lights
Make sure the headlights, stop lights, tail lights, turn signal
lights, and other lights are all working. Check headlight aim.Warning lights and buzzers
Check that all warning lights and buzzers function properly.
Horn
Make sure it works.
Windshield glass
Check that it is free from scratches, pits or abrasions.
Windshield wipers and washer
Check operation of the wipers and washer. Make sure the
wipers do not streak.
Windshield defroster
Check that air comes out the defroster outlet when operating
the air conditioner
Rear view mirror
Make sure it is mounted securely.
Sun visors
Make sure they move freely and are mounted securely.
Steering wheel
Check that it has the specified freeplay. See page 180 for
additional information. Be alert for changes in steering
condition, such as hard steering, excessive freeplay or strange
noise.

MAINTENANCE
142Brake and clutch fluid levels
Make sure the brake and clutch fluid levels are correct. See
page 176 for additional information.
Engine drive belts
Check all belts for fraying, cracks, wear or oiliness.
Engine oil level
Check the level on the dipstick with the engine turned off and
the vehicle parked on a level spot. See page 168 for additional
information
Power steering fluid level
Check the level through the reservoir. The level should be in
the “HOT” or “COLD” range depending on the fluid
temperature. See page 179 for additional information.
Automatic transmission fluid level
Check the level on the dipstick with the engine idling and the
selector lever in “P”. The level should be in the “HOT” or
“COOL” range according to the fluid temperature. See page
181 for additional information.
Exhaust system
Look for cracks, holes and loose supports. If you notice any
change in the sound of the exhaust or smell exhaust fumes,
have the cause located and corrected immediately. (See
engine exhaust cautions in Section 3-1.)
DOES YOUR VEHICLE NEED
REPAIRING?
Be on the alert for changes in performance, sounds, and visual
tip-offs that indicate service is needed. Some important clues
are as follows:

Engine missing, stumbling, or pinging

Appreciable loss of power

Strange engine noises

A fluid leak under the vehicle (However, water dripping from
the air conditioner after use is normal.)

Change in exhaust sound (This may indicate a dangerous
carbon monoxide leak. Drive with the windows open and
have the exhaust system checked immediately.)

Flat-looking tire; excessive tire squeal when cornering;
uneven tire wear

Vehicle pulls to one side when driving straight on a level
road

Strange noises related to suspension movement

Loss of brake effectiveness; spongy feeling brake or clutch
pedal; pedal almost touches floor: vehicle pulls to one side
when braking

Engine temperature continually higher than normal

MAINTENANCE
146SCHEDULE A
Maintenance operations:
A = Check and adjust as necessary; I = Inspect and correct or replace as necessary; R = Replace, change or lubricate.
Service interval
(Use odometer reading or
months, whichever comes first.)Maintenance services beyond 96,000 km (60,000 miles) should continue to be performed at the same intervals shown for each maintenance schedule.
Miles x 1,00013.757.511.251518.7522.526.253033.7537.541.254548.7552.556.2560MonthsMaintenance items km x 1,0001.66121824303642485460667278849096CHASSIS AND BODYBrake linings and drumsIIIIIIIII: Every 12 monthsBrake pads and discsIIIIIIIII: Every 12 monthsBrake fluidIIRIRR: Every 36 monthsBrake line pipes and hosesIIIII: Every 24 monthsSteering linkageIIIIIIIII: Every 12 monthsSRS airbagAfter inspection at 10 years, inspect every 2 years.Steering gear box See note (6)IIIIII: Every 24 monthsBill Joints, dust covers and drive shaft bootsIIIIIIIII: Every 12 monthsAutomatic transmisstion, manual transaxle and
differentiallRRRRR: Every 24 months
Bolts and nuts on chassis and body See note (7)IIIIIIIIII: Every 12 monthsBody inspection (paint, corrosion)IIIIIIIIII: Every 12 monthsROAD TESTIIIIIIIIII: Every 12 months
NOTE:
(6) Inspect the steering gear housing for oil leakage only.
(7) Applicable when operating mainly on rough and/or muddy roads. If not, follow schedule B.

MAINTENANCE
148SCHEDULE B
Maintenance operations:
A = Check and adjust as necessary; I = Inspect and correct or replace as necessary; R = Replace, change or lubricate.
Service interval
(Use odometer reading or
months, whichever comes first.)Maintenance services beyond 96,000 km (60,000 miles) should continue to be performed at the same intervals shown for each maintenance schedule.
Miles x 1,00017.51522.53037.54552.560MonthsMaintenance items km x 1,0001.61224364860728496CHASSIS AND BODYBrake linings and drumsIIIII: Every 24 monthsBrake pads and discsIIIII: Every 24 monthsBrake fluidIIRIRR: Every 36 monthsBrake line pipes and hosesIIIII: Every 24 monthsSteering linkageIIIII: Every 24 monthsSRS airbagAfter inspection at 10 years, inspect every 2 years.Steering gear box See note (4)IIIIII: Every 24 monthsBill Joints, dust covers and drive shaft bootsIIIII: Every 24 monthsAutomatic transmisstion, manual transaxle and differential IIIIII: Every 24 monthsBolts and nuts on chassis and bodyIIIIII: Every 24 monthsBody inspection (paint, corrosion)IIIIIIIIII: Every 12 monthsROAD TESTIIIIIIIIII: Every 12 months
NOTE
(4) Inspect the steering gear housing for oil leakage only.

MAINTENANCE
150Spark plugs
Install news plugs of the same type as originally equipped. A
qualified technician should perform this operation.
Charcoal canister
Inspect for internal damage or clogging. Clean with
compressed air or replace if necessary. A qualified technician
should perform this operation.
CHASSIS AND BODY
Brake linings and drums
Check for scoring, burning, broken parts, and excessive wear.
A qualified technician should perform this operation.
Brake pads and discs
Check the pads for excessive wear and the discs for runout
and wear. Also check for leaking fluid. A qualified technician
should perform this operation.
Brake and clutch fluids
Check for correct levels of the brake and clutch fluids. If the
level is low, add FMVSS No. 116 DOT3 or SAE J1703 brake
fluid to the brake or clutch reservoir. Change the brake and
clutch fluids as scheduled. A qualified technician should
perform those operations.Brake line pipes and hoses
Visually check for proper installation. Check for chafing,
cracks, deterioration, and any evidence of leaking. Replace
any deteriorated or damaged parts immediately. A qualified
technician should do these operations.
Steering linkage
With the vehicle stopped, check for excessive freeplay in the
steering wheel. Check the linkage for bends or damage. Check
the dust boots for deterioration, cracks, or damage. Replace
any damaged parts.
Steering gear box
Inspect the steering gear box for signs of leakage. If you
discover any leakage, have it repaired by a qualified technician
immediately.
Drive shaft boots
Inspect the drive shaft boots for clamp looseness, grease
leakage or damage. Replace any deteriorated or damaged
parts immediately. A qualified technician should perform these
operations.
Ball joints and dust covers
Check the suspension and steering linkage ball joints for
looseness or damage. Check all dust covers for deterioration
or damage. A qualified technician should perform these
operations.

MAINTENANCE
151 Automatic transmission, manual transaxle and differential
Inspect each component for signs of leakage. If you discover
any leakage, have it repaired by a qualified technician
immediately. Under severe driving conditions, change the fluid
and oil when scheduled.
SRS airbag
This should be periodically inspected by a qualified technician.
Bolts and nuts on chassis and body
Where necessary, retighten to specified torque.
Body inspection (paint, corrosion)
Visually check for corrosion, scratches and other damage.
Check body outer panels, underneath the vehicle, inner panels
of the hood and doors, etc. Apply touch-up paint to any chips
or scratches, or have them repaired by a qualified technician.
ROAD TEST
While driving the vehicle, chock the proper operation of engine,
transmission, brakes and steering, and check for abnormal
noise or vibration from any part of the vehicle.