DO NOT expose the ABS control unit to prolonged periods of high heat (185°F/85°C for 2 hours is
generally considered a maximum limit).
BLEEDING BRAKE SYSTEM
For ABS hydraulic unit bleeding, see HYDRAULIC UNIT under REMOVAL & INSTALLATION.
BRAKE LINE BLEEDING SEQUENCE
(1)
DIAGNOSIS
ABS system can only be diagnosed using ABS Tester (0000-42-0010). See Fig. 13 . An Adapter Harness
(49N0-66-001) is also required to test Miata ABS system. ABS tester cannot diagnose ABS control unit. If a
malfunction is detected in ABS and all other components in brake system are okay, replace ABS control unit.
If ABS tester is unavailable, test each component of ABS. See test procedures under TESTING. If all ABS
components test okay, replace control unit with a known good unit, and retest system for correct operation.
PRE-DIAGNOSIS INSPECTION
Perform a visual inspection of ABS components that could cause anti-lock problem. Visual inspection may help
identify cause of simple problem.
DIAGNOSTIC PROCEDURE WITH ABS TESTER
ABS tester uses one display window and 2 switches for reading information from unit. Become thoroughly
familiar with ABS tester displays and operation before proceeding. See Fig. 13
. To diagnose ABS system, go
to TESTING SEQUENCE charts under DIAGNOSING ABS SYSTEM. When diagnosing ABS system,
complete tests in order given under TESTING SEQUENCE. If ABS tester does not operate, check fuses,
ignition switch and ignition circuit.
TESTING
NOTE: See BRAKE BLEEDING article in the BRAKES Section.
ApplicationSequence
Miata & 929Longest Line First
RX7RR, LR, RF, LF
(1)If rear caliper has not been disassembled, open upper bleed valve only.
NOTE: Before testing ABS components, ensure battery and charging system are
functioning properly. To prevent damage to ABS control unit connector, use
very thin pins when probing connector.
1991 Mazda MX-5 Miata
ANTI-LOCK BRAKE SYSTEM 1988-91 BRAKES Mazda Anti-Lock Brake System
Microsoft
Sunday, July 05, 2009 2:17:31 PMPage 4 © 2005 Mitchell Repair Information Company, LLC.
