1991 LEXUS SC400 engine

Location of Connectors in Instrument Panel
TR±42±
ENGINE TROUBLESHOOTING Location of Connectors
WhereEverybodyKnowsYourName

±
ENGINE TROUBLESHOOTING Location of ConnectorsTR±43
WhereEverybodyKnowsYourName

Location of Connectors in Instrument Panel (Cont'd)
TR±44±
ENGINE TROUBLESHOOTING Location of Connectors
WhereEverybodyKnowsYourName

Location of Connectors in Body
±
ENGINE TROUBLESHOOTING Location of ConnectorsTR±45
WhereEverybodyKnowsYourName

CIRCUIT INSPECTIONDiag. Code 12
RPM Signal Circuit (No. 1)
CIRCUIT DESCRIPTION
The distributor in the Engine Control System contains three pick±up coil\
s (G1, G2 and NE).
The G1, G2 signals inform the ECU of the standard crankshaft angle.
The NE signals inform the ECU of the crankshaft angle and the engine spe\
ed.
 Code No. Diagnostic Code Detecting Condition Trouble Area
  
NoºNEºorºG1ºandºG2ºsignal to ECU within 2
 

Open or short in NE G circuit  No ºNEº or ºG1º and ºG2º signal to ECU within 2
sec after cranking 
Open or short in NE, G circuit.

Distributor
 12 sec. after cranking. 
Distributor

Open or short in STA circuit.
ECU  Open in ºGº
circuit. 
Oen or short in STA circuit.

ECU
TR±46±
ENGINE TROUBLESHOOTING Circuit Inspection
WhereEverybodyKnowsYourName

DIAGNOSTIC CHART
WIRING DIAGRAM
Check resistance of each pickup coils in
distributor
Check for open and short in harness and
connector between ECU and distributor.
Check air gap.
Check and replace ECU.
Replace distributor.
Repair or rep lace harness or connector.
Replace distributor
±
ENGINE TROUBLESHOOTING Circuit InspectionTR±47
WhereEverybodyKnowsYourName

Disconnect distributor connector.
Measure resistance between each terminal shown in
table below.
Check resistance of each picup coils in distributor.

During cranking or idling, check between terminals G1,
G2, NE and G
of engine (&ECT) ECU.
HINT: The correct waveforms appears as shown in the illustration on the left.
Replace distributor.
Check for open and short in harness and connector between engine
(&ECT) ECU and distributor (See page IN±27
Repair or replace harness or connector.
INSPECTION PROCEDURE
TR±48±
ENGINE TROUBLESHOOTING Circuit Inspection
WhereEverybodyKnowsYourName

Remove distributor cap & rotor.
Using SST (G1 and G2 pickups) and a thikness gauge
(NE pickup). measure the air gap between the signal
rotor projection and pickup coil.
SST 09240±00020 fro G1 and G2 pickups
Air gap: 0.2±0.4 mm (0.008±0.016 in.)
Replace distributor.
Check and replace engine (& ECT) ECU.
±
ENGINE TROUBLESHOOTING Circuit InspectionTR±49
WhereEverybodyKnowsYourName