1990 HONDA PRELUDE drain bolt

Engine Oil and Filter (cont'd)
Fuel Efficient Oil
For the best fuel economy from your car, it is recommended that
you use a fuel efficient SG oil. This oil is usually identified by the words such as: "Energy Conserving II," "Gas Saving," and "Fuel
Saving," etc.
Changing Oil and FilterEngine oil and filter should be changed together every 6 months or

7,500 miles (12,000 km), whichever occurs first. The filter is on the

engine block, below the intake manifold.

CAUTION:

The oil filter cannot easily be removed from above the engine.For this reason it is recommended
that the oil filter change be done by a skilled mechanic.

1. Start the car to warm up the
engine, then shut it off.

2. Remove the engine oil filler cap and drain bolt, and drain the oil. ENGINE OIL DRAIN BOLT
A warmed-up engine and the oil in it are hot; be careful not to burn
yourself.
3. Remove the oil filter and let the remaining oil drain out.
4. Install a new fitter according to
instructions on or with the filter.
OIL FILTERProCarManuals.comMain Menu t s

5. Reinstall the drain bolt with a new washer and tighten it securely.
Refill the engine with the recommended oil, to the upper mark on

the dipstick.

ENGINE OIL CHANGE CAPACITY (including filter):

3.8 l (4,0 US qt, 3.3 Imp qt)

6. Start the engine and make sure oil is not leaking from the drain
bolt or filter.

7. Shut off the engine and recheck the oil level.
NOTE:
Please dispose of used motor oil in a manner that is compatible with
the environment. We suggest you take it in a sealed container to

your local service station for reclamation. Do not throw it in the

trash or pour it on the ground.

CAUTION:
Used motor oil may cause skin cancer if repeatedly left in contact
with the skin for prolonged periods. Although this is unlikely unless you handle used oil on a daily basis, it is still advisable to
thoroughly wash your hands with soap and water as soon as possible after handing used oil.ProCarManuals.comMain Menu t s

Cooling System (cont'd)
Thermostat The thermostat in the cooling system does not need to be changedfor summer or winter operation. However, for extremely cold
climates, an optional thermostat is available from your Honda dealer.
Replacing CoolantReplace coolant at 36 months or 45,000 miles (72,000 km),
whichever comes first. Thereafter, replace every 2 years or 30,000
miles (48,000 km), whichever comes first.
RADIATOR COOLANT
REFILL CAPACITY:
including reserve tank 0.75 l (0.198 US gal, 0.165 Imp gal)

Manual transmission 2.0 S: 5.15 l (1.361 US gal, 1.133 Imp gal)
2.0 Si,Si: 6.15 l (1.625 US gal, 1.353 Imp gal)

Automatic transmission 2.0S:5.85 l (1.546 US gal, 1.287 Imp gal)

2.0 Si,Si: 6.15 l (1.625 US gal, 1.353 Imp gal)

1. Set the heater temperature lever to maximum heat.
2. Remove the radiator cap and loosen the drain plug when the radiator is cool, and drain the radiator.
RADIATOR
CAP BLEED BOLT
DRAIN BOLT
3. Remove the drain bolt from the front side of the cylinder block, and drain the engine and heater.
4. Apply non-hardening sealant to the drain bolt threads, then reinstall the bolt and tighten it securely.
5. Tighten the radiator drain plug securely.
DRAIN

PLUGProCarManuals.comMain Menu t s