1990 HONDA PRELUDE oil viscosity

Engine Oil and Filter

Checking

Check the engine oil a couple of minutes after shutting the engine
off, with the car parked on level ground. Remove the dipstick and wipe it clean. Reinsert it all the way down, then pull it out and read
the level. The level should be between the upper and lower marks.
ENGINE OIL
FILLER CAP

Adding
If the level has dropped close to the lower mark, add oil until it is
even with the upper mark. 1 .Turn the oil filler cap counterclockwise to remove. Add oil, then check the level again. Do not overfill.
2. Reinstall the cap and twist clockwise until it stops.

CAUTION:
Be sure the oil filler cap is correctly replaced before starting the

engine.
Engine oil is a major factor affecting the performance and

service life of the engine; you should use only a premium quality

detergent oil labeled SG grade.
LOOK FOR THIS LABEL
ON THE OIL CONTAINER

Use the proper viscosity oil for the
climate in which you drive:
Some oil labels may also include additional designations of quality
such as CC or CD. However, these are acceptable only when
used together with SG.
NOTE:

5W-30 viscosity
oil is recommended for improved fuel economy.

(cont'd)

Ambient Temperature

UPPER

LOWER
DIPSTICKProCarManuals.comMain Menu t s

Use the proper

viscosity oil for

the climate in
which you drive:
Ambient Temperature
Automatic
The automatic transmission fluid level is checked (with the engine off and the car on level ground) using the dipstick in the right end of
the transmission housing. Remove the dipstick and wipe it off.
Insert the dipstick and remove it. The fluid level should be between
the upper and lower marks.
If necessary, add fluid and recheck. Use only DEXRON ®
II
Automatic Transmission Fluid (A.T.F.) when adding or changing fluid. After checking the fluid level, push the dipstick in securely.

AUTOMATIC TRANSMISSION
FLUID CHANGE CAPACITY:
2.8 l (3.0 US qt, 2.5 Imp qt) DIP STICK

UPPER

LOWERProCarManuals.comMain Menu t s

Gas Station Information
Gasoline: UNLEADED onlyPump octane of 86 or higher.
Gas Tank-Capacity: 60 l (15.9 US gal, 13.2 Imp gal)
Tire Pressure (measured cold): Front/ Rear 195 kPa (28 psi) 180 kPa (26 psi)
Si (with 4WS) 195 kPa (28 psi) 195 kPa (28 psi)
Compact Spare Tire 415 kPa (60 psi)
Other Tire Information: Label on driver's door edge.
Hood Release: Pull handle under left side of dash.
Engine Oil: An "Energy Conserving II" SG grade oil is recommended. See page 83 for viscosity
recommendations.
Capacity (including filter):
3.8 l ( 4.0 US qt, 3.3 Imp qt)
Manual Transmission Oil: Recommended type—SAE 10W—30 or10W—40 weight, grade SE or SF.
Capacity (including differential):
2.1 l (2.2 US qt, 1.8 Imp qt)
Automatic Transmission Fluid:
Use DEXRON® II type Automatic Transmission Fluid
(ATF). Unscrew dipstick in right end of transmission,
wipe off, reinsert, remove and read fluid level-do not screw-in to check fluid level.
Capacity (Including differential):
2.8 l (3.0 US qt, 2.5 Imp qt)
Power Steering Fluid: Use only Honda power steering fluid: do not use ATF
or any other brand of power steering fluid because it
will damage the system.
AMERICAN HONDA MOTOR CO., INC.
1919 Torrance Blvd., Torrance, California 90501
1990 Honda Motor Co., Ltd. — All Rights Reserved
31SF1621
00X31-SF1-6211CRESTEC5009806 L PRINTED IN U.S.A.
ProCarManuals.comMain Menu t s