1988 JEEP CHEROKEE maintenance reset

If equipped, the EMR light (some models may use a reminder
flag) reminds vehicle operator that an emission system maintenance is
required. This indicator is activated after a predetermined
time/mileage.
When performing a smog check inspection, ensure EMR indicator
is not activated. On models using an EMR light, light should glow when
ignition switch is turned to ON position and should turn off when
engine is running.
If an EMR flag is present or an EMR light stays on with
engine running, fail vehicle and service or replace applicable
emission-related components. To reset an EMR indicator, refer to
appropriate MAINTENANCE REMINDER LIGHTS in the MAINTENANCE section.
MALFUNCTION INDICATOR LIGHT (MIL)
The Malfunction Indicator Light (MIL) is used to alert
vehicle operator that the computerized engine control system has
detected a malfunction (when it stays on all the time with engine
running). On some models, the MIL may also be used to display trouble
codes.
As a bulb and system check, malfunction indicator light will
glow when ignition switch is turned to ON position and engine is not
running. When engine is started, light should go out.

MAIN TE N AN CE R EM IN DER L IG HT R ESET P R O CED URES

1988 J e ep C hero ke e
1988-92 MAINTENANCE
Chrysler Motors Maintenance Reminder Lights
Jeep; Cherokee, Comanche, Wagoneer (1988-90), Wrangler
EMISSION MAINTENANCE INDICATOR LIGHT (1988-90)
Vehicles are equipped with an emission maintenance indicator
light on instrument cluster. This light will come on one time at 82,
500 miles to alert driver that emission service is required. At this
time, oxygen sensor and PCV valve must be replaced and all other
emission components should be inspected and serviced or replaced as
necessary.
Indicator timer is located under dash, near accelerator pedal
or to right of steering column. Timer cannot be reset. To turn off
light, timer must be replaced or disconnected. Since timer and sensor
are interdependent, if timer should fail prematurely, oxygen sensor
should be replaced at same time to preserve correct replacement
interval.
To replace timer on Cherokee, Comanche and Wagoneer models,
remove cruise control module (if equipped). Remove timer mounting
screws. Disconnect electrical connector. On Wrangler models, remove
timer mounting screws. Disconnect electrical connector. On all models,
install remaining components.
EMISSION MAINTENANCE INDICATOR LIGHT (1991-92)
Vehicles are equipped with an emission maintenance indicator
light on instrument cluster. This light will come on one time at 82,
500 miles to alert driver that emission service is required. At this
time, oxygen sensor must be replaced and all other emission components
should be inspected and serviced or replaced as necessary. Chrysler's
Diagnostic Readout Box (DRB-II) tester is required to reset the
emission maintenance indicator light.
Reset Procedure
Using DRB-II tester, access SELECT SYSTEMS. Select
appropriate engine. Select with or without A/C. Select FUEL &
IGNITION. Select ADJUSTMENTS. Select RESET EMR LIGHT. Reset EMR light.
When DRB-II is finished resetting light, DRB-II display will read EMR
LIGHT IS RESET.

SER VIC E IN DIC ATO R & W AR NIN G L IG HTS

1988 J e ep C hero ke e
1984-92 MAINTENANCE
AMC/Jeep/Eagle Service Indicator & Warning Lights
Jeep; Cherokee, Wagoneer
SERVICE INDICATOR & WARNING LIGHTS
BRAKE WARNING LIGHT
If the light stays on when the parking brake is off, it
indicates a possible brake system fluid leak or low pressure level.
LOCK INDICATOR LIGHT (1984-87)
Indicates that Selec-Trac transfer case is in part time 4WD
(high or low range).
FULL TIME 4WD INDICATOR LIGHT
Indicates that Selec-Trac transfer case is in full-time 4WD
(4x4 FULL TIME).
PART TIME 4WD INDICATOR LIGHT
Indicates that Selec-Trac transfer case is in part time 4WD
(4x4 PART TIME or 4 LO) or that Command-Trac transfer case is in 4WD
(4H or 4L).
WATER IN FUEL LIGHT (TURBO DIESEL)
Indicates water has collected in the fuel filter and should
be drained immediately.
DIESEL WAIT LIGHT (TURBO DIESEL)
Illuminates during glow plugs warm-up cycle.
LOW FUEL WARNING LIGHT
Glows when approximately 2 gals. (7.6L) remain in fuel tank.
EMISSION MAINTENANCE INDICATOR LIGHT
Illuminates at approximately 82,500 miles to indicate
scheduled maintenance (or recommended maintenance on California
vehicles). Light will remain on until system is serviced and light is
reset.
CHECK ENGINE LIGHT
If this light illuminates and remains on while driving, it
indicates a potential engine control problem that needs service.
CHECK ANTI-LOCK LIGHT
Illuminates to indicate a self-check is in process at vehicle
start up. If light remains on after start-up or comes on and stays on