SA15T-04
F05181
F04386
SST
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER (w/ Diff. Lock)
SA-1 19
2069 Author: Date:
2004 LAND CRUISER (RM1071U)
REMOVAL
1. SHIFTING REAR DIFF. LOCK
(a) Turn the ignition switch to the ON position.
(b) Shift the transfer shift lever to L position.
(c) Turn the differential lock control switch to the RR position
and lock the rear differential.
HINT:
While rotating the tires, check they are in the differential lock
condition.
(d) Disconnect the cable from the negative terminal of the
battery.
2. REMOVE 2 REAR WHEELS
Torque: 131 N´m (1,340 kgf´cm, 97 ft´lbf)
3. DRAIN HYPOID GEAR OIL
Torque: 49 N´m (500 kgf´cm, 36 ft´lbf)
4. DISCONNECT BRAKE LINES
(a) Using SST, disconnect the brake line and remove the clip.
SST 09023-00100
Torque: 15 N´m (150 kgf´cm, 11 ft´lbf)
(b) Employ the same manner described above to the other
side.
5. DISCONNECT PARKING BRAKE CABLES
(a) Remove the 2 clips, pin and disconnect the parking brake
cable from the bellcrank.
(b) Employ the same manner described above to the other
side.
D02866
ON
OFF
TR06V-02
D02867
L
NH
Z15367
Relay side:
- TRANSFERMOTOR SHIFT CONTROL SYSTEM
TR-49
1937 Author: Date:
2004 LAND CRUISER (RM1071U)
INSPECTION
1. INSPECT SWITCH POSITION
(a) Start the engine, and shift the transfer shift lever to the ºHº
position.
(b) Check that the center diff. indicator light comes on when
the the switch is in ºONº position. Check that the light goes
off when the switch is in ºOFFº position.
2. INSPECT SHIFT LEVER POSITION
(a) Start the engine, and turn the center diff. lock switch to
OFF.
(b) Check that the center diff. indicator light comes on when
the transfer shift lever is shifted to the ºLº position. Check
that the light goes off when the lever is shifted to the ºNº
or ºHº position.
3. INSPECT CENTER DIFF. LOCK CONTROL RELAY
(a) Check that continuity exists between each terminal, as
shown in the chart.
Tester connected terminal numberSpecified condition
1 - 2Continuity
2 - 4Continuity
6 - 7*
*: There is a diode between the terminals 6 and 7.
If no continuity exists, check that continuity exists when chang-
ing the position of probe for the position of negative probe
of tester.
(b) Apply battery positive voltage between each terminal and
check that continuity exists between each terminal, as
shown in the chart.
Battery voltage
applied terminalTester connected terminal
numberSpecified condition
6 (+) - 5 (-)1 - 3
1 - 2Continuity
No continuity
7 (+) - 2 (-)9 - 10No continuity
9 (+) - 10 (-)3 - 4
2 - 4Continuity
No continuity
If continuity is not as specified, replace the relay.
