MINOR REPAIRS
Replacing a Bulb
DIP/MAIN BEAM HEADLAMPS (Fig. 40 and 41)
They are fitted with bulbs: 12 V - 45/40 W.
To take the headlamp out: remove the screw (1), then tilt the unit
forward.
To replace a bulb:
Disconnect the black plastic connector (2) carrying the feed leads.
Swing the springs (3 and 4), which hold the bulb flange (5) in place\
,
through 90°.
Change the faulty bulb and fit the new one by turning the flange
until the locating lug falls into its slot.
Do not forget to clip over springs (3 and 4) and to reconnect the
connector (2).
To refit the headlamp unit (Fig. 42)
Position the lugs (1 and 2) opposite the white plastic buttons (3 and\
4).
Pivot the unit and refit it into the headlmap housing. Fit and tighten
the screw (1 - Fig. 40).
We recommend that you have your headlamp beam checked by a
specialist every time a bulb is changed.
Fig. 40
Headlamps
1 - Retaining screw
Fig. 41
Headlamps
1 - Connector
3-4 - Holding springs 5 - Bulb flange
Fig. 42
Headlamps
1-2 - Locating lugs
3-4 - White plastic buttons Fig. 43
Front side lamps 1 - Socket
SIDE AND TAIL LAMPS
Front bulbs (Fig. 43): 12 V - 4 W - BA 9S T 8/4
These bulbs are placed directly in the reflectors of the lamp units (1)\
.
Pull the socket, turning it slightly.
Tail lamps (Fig. 44): 12 V - 5 W - R 19/5
The bulbs (1) combined in the covers, include the brake and
direction indicator lamps.
To remove the covers, unscrew the two screws.
Direction indicators: 12 V - 21 W - P 25/1
FRONT: Remove the cover, unscrew the two screws.
REAR: See "Tail Lamps" (Fig. 44 - Mark 2).
Brake lamps: 12 V - 21 W - P 25/1
See "Tail Lamps" (Fig. 44 - Mark 3).
