HEATER
Three control levers provide full control of the
optional Corvair gasoline heater.
FAN-this is the AIR-ON control and the blower control.
This lever must be pushed down before the unit will
operate.
DEF-diverts heated air to the defroster ducts for
defogging or deicing windows.
HEAT-Allows for selecting degree of heat desired.
Heater will begin to supply heat in a minimum of
30 seconds. For efficient heating and heat distribu
tion, keep all windows closed.
NOTE: When heater or ignition switch is shut off,
the combustion blower will continue to operate
for 30 to 40 seconds to remove unburned fuel
and vapor from the system. This is normal for this
type of heater.
10
RADIO
The optional Corvair radio control knobs are shown
below. For best reception the antenna should be extended
to at least the height of the car roof. For long distance
reception, extend the antenna to its full length.
ON-OFF SWITCH AND VOLUME CONTROl TONE CONTROl
HEATER~---1!m~!d CONTROLS TUNING
KNOB
ammonia or soda solution and flush with clear
water. Check state of charge regularly, espe
cially in freezing weather, for an undercharged
battery may freeze and break.
16. FUEL FILTER
Every 15,000 miles-Replace filters, located in each
carburetor inlet. If flooding occurs, replace more
often.
17. BRAKE MASTER CYLINDER
Check frequently and maintain fluid level at mark
inside reservoir below filler opening, using G. M.
Hydraulic Brake Fluid, Super No. 11. If addition
of fluid is required more often than ·every 1000
miles the entire system should be checked for
leaks.
18. PARKING BRAKE & CLUTCH PULLEYS
AND CABLES
Every 10,000 miles-Lubric.ate pulleys under dash.
Remove the
tunnel cover under vehicle and lubri
cate pulleys and cable bearing points with lub
riplate. lubricate gearshift lever ball and socket
and shift rod universal joint at transmission con
nection with lubriplate.
BODY LUBRICATION POINTS
Most body lube points do not need frequent, heavy
23
lubrication as does the chassis. However, periodic checks
of certain points on the Corvair body, and lubrication
when needed will eliminate annoying squeaks and
noises . Be careful not to over-lubricate. Wipe off all
surplus lubricant.
The following items should be lubricated periodically:
1. DQQr Hinges-Wipe off dirt and apply Lubriplate.
2 . Door Lock
Striker-Wipe off dirt and apply stick type lubricant.
3. Door Bottom Drain Hole Sealing Strip-Apply silicone rub-
ber lubricant.
4. Door Jamb Switch-Apply Lubriplate.
5 .
Rear Door Weatherstrip-Apply silicone rubber, lubricant.
6 . Front
and Rear Compartment Lid Lock-Apply Lubriplate.
7. Front Compartment Lid Torque Rods-Apply dripless oil to bearing points.
8. Gas Tank Filler Door Hinge-Apply dripless oil. 9. Glove Box Door Hinge-Apply dripless oil. 10. Rear Folding Seat Back Support Link Assembly & Filler Panel Hinge-Apply dripless Qil to bearing points.
The following items moy be lubricated whenever
access to the item is availoble:
11. Door Outsi.de Handle Lock Cylinder Shaft-Apply Lubri-
plate. 12. Door Window Regulator and Cams-Apply Lubriplate .
13. Door Lock Parts-Apply Lubriplate . 14. Door Locking Mechanism-Apply Lubriplate .
15. Front and Rear Compartment Hinges-Apply Lubriplate.
