2024 MAZDA CX90 seats

WARNING
Do not seat a child in a child-restraint
system on the front passenger seat if
the front passenger air bag
deactivation indicator light does not
illuminate.
While it is always better to install any
child-restraint system on the rear seat,
it is imperative that a child-restraint
system ONLY be used on the front
passenger seat if the deactivation
indicator light illuminates when the
child is seated in the child-restraint
system (page 3-16). Seating a child in
a child-restraint system installed on the
front passenger seat with the front
passenger air bag deactivation
indicator light not illuminated is
dangerous. If this indicator light does
not illuminate, this means that the
front passenger front and side air bags,
and knee air bags, and seat belt
pretensioners are ready for
deployment. If an accident were to
deploy an air bag, a child in a
child-restraint system sitting in the
front passenger seat could be seriously
injured or killed. If the indicator light
does not illuminate after seating a
child in a child-restraint system on the
front passenger seat, seat a child in a
child-restraint system on the rear seat
and consult an Authorized Mazda
Dealer as soon as possible.
Using the LATCH Lower
Anchor
Your Mazda is equipped with LATCH
lower anchors for attachment of
specially designed LATCH
child-restraint systems in the
second-row/third-row right seats. Both
anchors must be used, otherwise the
seat will bounce around and put the
child in danger. Most LATCH
child-restraint systems must also be
used in conjunction with a tether to be
effective. If they have a tether you must
use it to better assure your child's
safety.
Equipment to Protect Occupants/Pedestrians
Child-restraint Systems
3-64
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the LATCHLower Anchor
Installation on second-row/third-row
right seat
1.(Second-row seat)
First, adjust the front seat to allow
clearance between the
child-restraint system and the front
seat.
Refer to How to Use the Front Seats
on page 3-30.
2. (Second-row seat)
Adjust the second-row seat
position using the following
procedure.
1. Fold the second-row seatback
forward.
2. Raise the second-row seatback until a click sound is heard and
it is locked in place.
3.(Second-row seat)
Adjust the angle of the second-row
seatback so that there is no gap
between the child-restraint system
and the second-row seatback.
4. Make sure the seatback is securely latched by pushing it back until it is
fully locked.
5. Remove the cover of the child-restraint system's LATCH
lower anchors to verify the
locations of the LATCH lower
anchors.
Second-row seat
Third-row seat
1. LATCH lower anchor
NOTE
The LATCH lower anchors
marking on the cover indicates
the position of the LATCH lower
anchors for the attachment of a
child-restraint system.
6. Remove the head restraint. However, when installing a backless
booster seat, always install the
vehicle head restraint to the seat
where the backless booster seat is
installed.
Refer to How to Use the Head
Restraints on page 3-48.
7. Secure the child-restraint system using BOTH LATCH lower anchors,
following the child-restraint system
manufacturer's instruction. Pull on
the child-restraint to be sure both
anchors are engaged.
Equipment to Protect Occupants/Pedestrians
Child-restraint Systems
3-66
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

8. If your child-restraint system cameequipped with a tether, that means
it is very important to properly
secure the tether for child safety.
Please carefully follow the
child-restraint system
manufacturer's instructions when
installing tethers.

Installation on second-row center seat
The LATCH lower anchors at the center
of the second-row seat are much
further apart than the sets of LATCH
lower anchors for child-restraint system
installation at other seating positions.
Child-restraint systems with rigid
LATCH attachments cannot be
installed on the center seating
position. Some LATCH equipped
child-restraint systems can be placed in
the center position and will reach the
nearest LATCH lower anchors which
are 500 mm (19.7 in) apart. LATCH
compatible child-restraint systems
(with attachments on belt webbing)
can be used at this seating position
only if the child-restraint system
manufacturer's instructions state that
the child-restraint system can be
installed to LATCH lower anchors that
are 500 mm (19.7 in) apart. Do not
attach two child-restraint systems to
the same LATCH lower anchor. If your
child-restraint system has a tether, it
must also be used for your child's
optimum safety.

The procedure for installation on the
rear outboard seats is the same.
LATCH lower anchor location
Equipment to Protect Occupants/Pedestrians
Child-restraint Systems
3-67
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Panorama Sunroof*
The panorama sunroof can be opened
or closed when operating the
overhead tilt/slide switch at the front
seats.
1. Tilt/slide switch
Jam-safe function
If foreign matter caught between the
panorama sunroof and the window
frame is detected while it is closing
automatically, the panorama sunroof
stops and opens partway.
NOTE
When the jam-safe function is
inoperable, the panorama sunroof
initial setting is not performed.
Refer to Initializing the Panorama
Sunroof on page 8-32.
Warnings and Cautions
for Using the Panorama Sunroof
WARNING
When closing the panorama sunroof,
be careful that a passenger’s hand or
head does not get pinched.
If a hand or head becomes pinched, it
could cause serious injury.
Do not let a child operate the tilt/
slide switch.
If a hand or head becomes pinched, it
could cause serious injury.
Do not allow a passenger to put a
hand or head out of the area where
the panorama sunroof opens while
driving the vehicle.
If the person's hand or head hits
something outside the vehicle, or
sudden braking is applied, it could
result in serious injury or death.
While driving, do not let occupants
stand up and extend a part of their
body out of the opening.
Extending your head, arms, or other
parts of your body from the panorama
sunroof is dangerous. Your head or
arm may hit something while driving,
which could result in a fatal injury.
Just before the panorama sunroof
completely closes, make sure there is
nothing obstructing the panorama
sunroof.
The jam-safe function may not prevent
the panorama sunroof from closing
completely. Getting your fingers
pinched could cause serious injury.
Opening/closing
Sunroof
*Some models.4-31
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Moonroof*
The moonroof can be opened or
closed when operating the overhead
tilt/slide switch at the front seats.
1. Tilt/slide switch
Jam-safe function
If foreign matter caught between the
moonroof and the window frame is
detected while it is closing
automatically, the moonroof stops and
opens partway.
NOTE
Before leaving the vehicle or washing
your Mazda, make sure the
moonroof is completely closed so
that water does not get inside the
cabin area.
After washing your Mazda or after it
rains, wipe the water off the
moonroof before operating it to
avoid water penetration which could
cause rust and water damage to your
headliner.
The jam-safe function may operate
under the following conditions.
A strong impact is detected while
the moonroof is closing
automatically.
The moonroof is closing
automatically during very low
temperatures.
When the jam-safe function is
inoperable, the moonroof initial
setting is not performed.
Refer to Initializing the moonroof on
page Reference 8-33.
Opening/closing
Sunroof
4-34*Some models.
CX-90_8KG7-EA-22L_Edition1_new2022-11-17 16:05:04

Rear Seat Alert*
The Rear Seat Alert is a system that
reminds the driver to check if any
occupants or luggage have been left
behind on the second/third-row seats.
The Rear Seat Alert determines if there
is the possibility that occupants or
luggage are on a second/third-row
seat based on the opening and closing
history of the rear doors. For this
reason, the system may operate
differently from the actual conditions,
such as it is not activated even if
occupants or luggage are occupying a
second/third-row seat.
Warnings and Cautions
for Using the Rear Seat Alert
WARNING
Do not rely completely on the system.
The Rear Seat Alert is not a system that
detects occupants and luggage using
sensors. Over reliance on the system
could lead to an accident.
When leaving the vehicle, always
visually check the conditions of the
second/third-row seats.
Opening/closing
Rear Seat Alert
4-42*Some models.
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the Rear SeatAlert
If any of the following operations is
performed, a message appears in the
instrument cluster to notify that the
system is active. Make sure that a
message appears. The message
disappears after a short period of time.
When the Rear Seat Alert is not
needed, temporarily deactivate the
system according to the message.
A rear door is opened and the hybrid
system is started.
The hybrid system is started within
about 10 minutes after a rear door is
opened and closed.
A rear door is opened after the
hybrid system is started.
The vehicle power is switched ON
while the system is active.
If the vehicle power is switched OFF
while the system is active, a message in
the instrument clus ter and a warning
sound indicate the possibility of
occupants or luggage on a second/
third-row seat. The message
disappears after a short period of time.
If the driver's door is opened/closed
after the message in the instrument
cluster disappears, notification is made
again.

When deactivating the system, perform
any of the following operations.
Switch the vehicle power to ACC or
OFF and open a rear door.
Switch the vehicle power ON again
and open a rear door before starting
the hybrid system.
Open a rear door and switch the
vehicle power to ACC or OFF.
Temporarily deactivate the system
according to the message in the
instrument cluster.
NOTE
The Rear Seat Alert determines if there
is the possibility that occupants or
luggage are on a second/third-row
seat based on the opening and closing
history of the rear doors. For this
reason, depending on the usage, it
may not be activated even if occupants
or luggage are on the second/
third-row seats, or it may activate even
if no occupants or luggage are on the
second/third-row seats. The system
will continue to be active until it is
canceled.
Examples of when the system does
not activate even if occupants or
luggage are on the second/third-row
seats.
A rear door is opened and closed in
a very short period of time.
Remote engine starting via
Connected Service is used*.The lead-acid battery charge is low.The lead-acid battery connection
was disconnected/connected.
Examples of when the system
activates even if no occupants or
luggage are on the second/third-row
seats.
A rear door is opened and closed,
but no occupant or luggage is in the
vehicle.
Occupants and luggage are
unloaded while the engine is
running.
A rear door is opened and closed in
a very short period of time.
Opening/closing
Rear Seat Alert
*Some models.4-43
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

How to Use the FullyAutomatic Climate Control System
(Operation from front seats)
1. Start the hybrid system.
2. Turn the front climate control system on.
3.
The indicator light turns on.
NOTE
When the rear climate control
system is turned on using the Rear
climate control system power
switch, each setting is the setting
before the rear climate control
system was turned off.
4.
The indicator light turns on and the
screen changes to the rear climate
control system operation screen.
5. Press the temperature setting switch to set the desired temperature.
Each function is automatically
controlled according to the set
temperature.
NOTE
The following switches cannot be
operated while the rear climate
control system operation screen is
displayed.
Air intake selector switchFront passenger’s side
temperature setting switch
A/C switchIf none of the following switches
are operated, the screen returns
to the front climate control
system operation screen after 10
seconds.
AUTO switchDriver’s side temperature
setting switch
SYNC (synchronized
temperature) switch
Mode selector switchFan control switch
6. To stop the operation, press the climate control system power
switch.

Equipment to Make Cabin More Comfortable
Fully Automatic Climate Control (Rear)
6-19
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04