2024 LEXUS UX light

72
UX250h_QG_OM76733U_(U)
4Test the HomeLink® operation by pressing the newly programmed button and observ-
ing the indi cator light:
● Indicator light illuminates: Programming of a fixed code device has completed. The
garage door or other device should operate when a HomeLink
® button is pressed
and released.
● Indicator light flashes rapidly: The garage door opener motor or other device is
equipped with a rolling code. To complete programming, firmly press and hold the
HomeLink
® button for 2 seconds then release it.
● If the garage door or other device does not operate, proceed to “Programming a
rolling code system”.
5Repeat the steps above to program another device for any of the remaining
HomeLink
® buttons.
■Programming a rolling code system
2 or more people may be necessary to complete rolling code programming.
1Locate the “Learn” or “Smart” button
on the garage door opener motor in
the garage.
This button can usually be found where
the hanging antenna wire is attached to
the unit. The name and color of the but-
ton may vary by manufacturer. Refer to
the owner’s manual supplied with the
garage door opener motor for details.
2Press and release the “Learn” or
“Smart” button.
Perform
3 within 30 seconds after
performing
2.
3Press and hold the desired
HomeLink
® button (inside the vehicle)
for 2 seconds and release it. Repeat
this sequence (press/hold/release) up
to 3 times to complete programming.
If the garage door opener motor oper-
ates when the HomeLink
® button is
pressed, the garage door opener
motor recognizes the HomeLink
® sig-
nal.

73
UX250h_QG_OM76733U_(U)
■Enabling 2-way communication with a garage door (only available for compat-
ible devices)
When enabled, 2-way communication allows you to check the status of the opening and
closing of a garage door through indicators in your vehicle.
2-way communication is only available if the garage door opener motor used is a compati-
ble device. (To check device compatibility, refer to www.homelink.com.)
1Within 5 seconds after programming the garage door opener has been completed, if
the garage door opener motor is trained to HomeLink
®, both garage door operation
indicators will flash rapidly (green) and the light on the garage door opener motor will
blink twice, indicating that 2- way communication is enabled.
If the indicators do not flash, perform
2 and 3 within the first 10 presses of the HomeLink®
button after programming has been completed.
2Press a programmed HomeLink® button to operate a garage door.
3Within 1 minute of pressing the HomeLink® button, after the garage door operation
has stopped, press the “Learn” or “Smart” button on the garage door opener motor.
Within 5 seconds of the establishment of 2-way communication with the garage door
opener, both garage door operation indicators in the vehicle will flash rapidly (green)
and the light on the garage d oor opener motor will blink tw ice, indicating that 2-way
communication is enabled.
■Reprogramming a single HomeLink® button
When the following procedure is performed, buttons which already have devices registered
to them can be overwritten:
1With one hand, press and hold the desired HomeLink® button.
2When the HomeLink® indicator starts flashing (orange), continue to hold the
HomeLink
® button and perform “Programming HomeLink®” 1 (it takes 20 seconds
for the HomeLink
® indicator to start flashing).
Press the appropriate HomeLink
® button. The HomeLink® indicator light should turn on.
Operating HomeLink®

74
UX250h_QG_OM76733U_(U)
Microphone
“SOS” button
LED light indicators
Subscribers have the following Sa fety Connect services available:
● Automatic Collision Notification
In case of either airbag deployment or seve re rear-end collision, the system is designed
to automatically call the response center. The responding agent receives the vehicle’s
location and attempts to speak with the vehicle occupants to assess the level of emer-
gency. If the occupants are unable to communicate, the agent automatically treats the
call as an emergency, contacts the nearest emergency services provider to describe the
situation, and requests that assistance be sent to the location.
Safety Connect (if equipped)
Safety Connect is a subscription-based telematics service that uses Global Positioning
System (GPS) data and embedded cellular technology to provide safety and security fea-
tures to subscribers. Safety Connect is suppo rted by Lexus’ designated response center,
which operates 24 hours per day, 7 days per week.
Safety Connect service is available by subs cription on select, telematics hardware-
equipped vehicles.
System components
A
B
C
Services

82
UX250h_QG_OM76733U_(U)
●Turn the power switch off and ensure that all the doors and windows are closed.
● Confirm the type of fuel.
1Press the opener switch.
The fuel filler door will open within
about 10 seconds of the switch being
pressed. Before refueling is possible, a
message will be shown on the multi-
information display in the instrument
cluster to indicate the progress of the
fuel filler door opener.
2Turn the fuel tank cap slowly and
remove it, then put it into the holder on
the fuel filler door.
After refueling, turn the fuel tank cap until
you hear a click. Once the cap is released, it
will turn slightly in the opposite direction.
Fuel Tank Cap
Before refueling the vehicle
Opening the fuel tank cap
Closing the fuel tank cap

What to do if...
83
UX250h_QG_OM76733U_(U)
List of Warning/Indicator Lights
Immediately stop the vehicle in a safe place and contact your Lexus dealer. Continu-
ing to drive the vehicle may be dangerous.
(U.S.A.)
Brake system warning light
(Red)
(Canada)
Immediately stop the vehicle in a safe place and contact your Lexus dealer.
Low engine oil pressure warn-
ing light(U.S.A.)Malfunction
indicator lamp
Charging system warning light(Canada)
Have the vehicle inspected by your Lexus dealer immediately.
SRS warning light
(Flashes)
Intuitive parking assist OFF
indicator (if equipped)
(U.S.A.)
ABS warning light(Flashes)
Brake hold operated indicator
(Canada)
(Yellow)
Brake system warning light
(Red or yellow)
Electric power steering
system warning light
(Flashes)
RCTA OFF indicator (if
equipped)
(Flashes or
illuminates)PCS warning light
(Flashes)
PKSB OFF indicator (if
equipped)
Slip indicator(Blinking and then continu-
ously on)
Tire pressure warning light
For further information, refer to the “OWNER’S MANUAL”.

84
What to do if...
UX250h_QG_OM76733U_(U)
Follow the correction procedures.
(Flashes)(U.S.A.)Parking brake
indicator
Rear passengers’ seat belt
reminder lights
(Flashes)
(Canada)
(Orange)
LTA indicator
Inappropriate pedal
operation warning light
(Illuminates without
blinking)
Tire pressure warning light*
Low fuel level warning light
Driver’s and front passenger’s
seat belt reminder light
(Orange)
Low traction battery charge
warning light
Stop and check.
High coolant temperature
warning lightHybrid system overheat warn-
ing light
For further information, refer to the “OWNER’S MANUAL”.

What to do if...
85
UX250h_QG_OM76733U_(U)
See the “OWNER’S MANUAL”
Turn signal indicatorBSM indicator (if equipped)
Headlight indicator (U.S.A.)Intuitive parking assist OFF
indicator (if equipped)
Tail light indicator (Canada)RCTA OFF indicator (if
equipped)
Headlight high beam indicatorPKSB OFF indicator (if
equipped)
Automatic High Beam
indicatorBrake hold standby indicator
Fog light indicator (if
equipped)Brake hold operated
indicator
Cruise control indicatorSecurity indicator
Dynamic radar cruise control
indicatorSmart access system with
push-button start indicator
Cruise control “SET” indicatorLow outside temperature
indicator
(White or green)LTA indicator“READY” indicator
(Flashes in orange)LTA indicatorEV drive mode indicator
(Flashes)
Slip indicatorEV indicator
VSC OFF indicator(U.S.A.)Parking brake
indicator
PCS warning light(Canada)
BSM outside rear view mirror
indicators (if equipped)
For further information, refer to the “OWNER’S MANUAL”.

86
What to do if...
UX250h_QG_OM76733U_(U)
*: It also comes on due to natural causes such as natural air leaks and tire inflation pressure
changes caused by temperature. Adjust the tire inflation pressure to the specified level.
The light will turn off after a few minutes. In case the light does not turn off even if the tire
inflation pressure is adjusted, have th e system checked by your Lexus dealer.
See the “OWNER’S MANUAL”
(U.S.A.)
“AIR BAG ON/OFF” indica-
tor
(Canada)
“AIR BAG ON/OFF” indica-
tor
●Drive mode indicators
Except F SPORT modelsF SPORT models
Eco drive mode indicatorCustom mode indicator
(if equipped)
Sport mode indicatorEco drive mode indicator
Sport mode indicator
(if equipped)
Sport S mode indicator
(if equipped)
Sport S+ mode indicator
(if equipped)
For further information, refer to the “OWNER’S MANUAL”.