Page 323 of 516

3216-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E✽
: If equipped
Maintenance and care
6
⬛Brake fluid can absorb moisture from the air
Excess moisture in the brake fluid can ca use a dangerous loss of braking efficiency.
Use only newly opened brake fluid.
WARNING
⬛When filling the reservoir
Take care as brake fluid can harm your hands and eyes and damage painted
surfaces.
If fluid gets on your hands or in your eyes, flush the affected area with clean
water immediately.
If you still experience discomfort, consult a doctor.
NOTICE
⬛If the fluid level is low or high
It is normal for the brake fluid level to go down slightly as the brake pads wear
out or when the fluid level in the accumulator is high.
If the reservoir needs frequent ref illing, there may be a serious problem.
Battery
Check the battery as follows.
⬛Caution symbols✽
The meanings of each caution symbol on the top of the battery are as fol-
lows:
No smoking, no naked
flames, no sparksBattery acid
Shield eyesNote operating instructions
Keep away from childrenExplosive gas
Maintenance.fm 321 ページ 2022年6月16日 木曜日 午前9時43分
Page 325 of 516

3236-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Maintenance and care
6
⬛Before recharging
When recharging, the battery produces hydrogen gas which is flammable and
explosive. Therefore, observe the following before recharging:
⚫If recharging with the battery installed on the vehicle, be sure to disconnect
the ground cable.
⚫Make sure the power switch on the charger is off when connecting and dis-
connecting the charger cables to the battery.
WARNING
⬛Chemicals in the battery
Batteries contain poisonous and corrosive sulfuric acid and may produce
hydrogen gas which is flammable and expl osive. To reduce the risk of death or
serious injury, take the following precautions while working on or near the bat-
tery:
⚫Do not cause sparks by touching the battery terminals with tools.
⚫Do not smoke or light a match near the battery.
⚫Avoid contact with eyes, skin and clothes.
⚫Never inhale or swallow electrolyte.
⚫Wear protective safety glasse s when working near the battery.
⚫Keep children away from the battery.
⬛Where to safely charge the battery
Always charge the battery in an open area. Do not charge the battery in a
garage or closed room where th ere is insufficient ventilation.
⬛Emergency measures regarding electrolyte
⚫If electrolyte gets in your eyes
Flush your eyes with clean water for at least 15 minutes and get immediate
medical attention. If possible, continue to apply water with a sponge or cloth
while traveling to the nearest medical facility.
⚫If electrolyte gets on your skin
Wash the affected area thoroughly. If you feel pain or burning, get medical
attention immediately.
⚫If electrolyte gets on your clothes
It can soak through clothing on to yo ur skin. Immediately take off the cloth-
ing and follow the procedure above if necessary.
⚫If you accidentally swallow electrolyte
Drink a large quantity of water or milk. Get emergency medical attention
immediately.
RAIZE_OM_General_BZ358E.book 323 ページ 2022年5月17日 火曜日 午後1時59分
Page 326 of 516
3246-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
WARNING
⬛When there is insufficient battery fluid
If the battery is used or charged while the battery fluid level in any cell is below
the “LOWER LEVEL” line displayed on th e side of the battery, the battery life
may become short and the battery may explode or generate heat.
NOTICE
⬛When recharging the battery
Never recharge the battery while the engi ne is running. Also, be sure all acces-
sories are turned off.
⬛When adding distilled water
Avoid overfilling. Water spilled during battery recharging may cause corrosion.
Washer fluid
⬛Inspection procedure
Check the liquid surface with your
eyes from the side of the washer
tank.
⬛Refill procedure
Remove the cap from the washer
tank and dilute the fluid by referring
to the freezing temperature shown
on the washer fluid container.
KBRO620910N
KBRO620911N
RAIZE_OM_General_BZ358E.book 324 ページ 2022年5月17日 火曜日 午後1時59分
Page 327 of 516
3256-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Maintenance and care
6
WARNING
⬛When adding washer fluid
Do not add washer fluid when the engine is hot or running as washer fluid con-
tains alcohol and may catch fire if spilled on the engine, etc.
NOTICE
⬛Do not use any fluid other than washer fluid
Do not use soapy water or engine an tifreeze instead of washer fluid.
Doing so may cause streaking on the vehicle’s painted surfaces, as well as
damaging the pump leading to proble ms of the washer fluid not spraying.
⬛Diluting washer fluid
Dilute washer fluid with water as necessary.
Refer to the freezing temperatures list ed on the label of the washer fluid bot-
tle.
Air cleaner filter
Check the air cleaner filter as follows:
a Release the clips.
KBRO620913E
RAIZE_OM_General_BZ358E.book 325 ページ 2022年5月17日 火曜日 午後1時59分
Page 328 of 516
3266-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
bRelease the 2 claws.
c Lift the cover and take out the air
cleaner filter.
Inspect the outer surface of the filter, and replace the filter if it is
extremely dirty. If the filter is only moderately dusty, use compressed air
to blow dust out of the filter.
WARNING
⬛To prevent inhaling dust
Wear a respirator when using compressed air to clean the air cleaner filter.
NOTICE
⬛To prevent damaging the engine
Do not drive with the air cleaner filter removed. Doing so causes excessive
engine wear.
KBRO620915E
KBRO620914E
RAIZE_OM_General_BZ358E.book 326 ページ 2022年5月17日 火曜日 午後1時59分
Page 330 of 516

3286-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E✽
: If equipped
Tire rotation
Rotate the tires in the order shown.
To equalize tire wear and help exte nd tire life, Toyota recommends that
tire rotation is carried out appr oximately every 5000 km (3000 miles).
▶Vehicles with a spare tire of differ-
ent wheel type from the installed
tires▶Vehicles with a spare tire of the
same wheel type as the installed
tires
Tire pressure warning system✽
Your vehicle is equipped with a tire pressure warning system that uses tire
pressure warning valves and transmitters to detect low tire inflation pres-
sure before serious problems arise.
If the tire pressure drops below a predetermined level, the driver is
warned by a warning light. (➞P. 382)
Installing tire pressure warning valves and transmitters
(vehicles with a tire pressure warning system)
When replacing tires or wheels, tire pressure warning valves and transmit-
ters must also be installed.
When new tire pressure warning valv es and transmitters are installed,
new ID codes must be registered in the tire pressure warning computer
and the tire pressure warning system must be initialized. Have tire pres-
sure warning valve and transmitter ID codes registered by your Toyota
dealer. ( ➞P. 329)
KBTC620401
Front
KBRO620402N
Front
RAIZE_OM_General_BZ358E.book 328 ページ 2022年5月17日 火曜日 午後1時59分
Page 331 of 516

3296-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Maintenance and care
6
Initializing the tire pressure warning system
(vehicles with a tire pressure warning system)
⬛The tire pressure warning system must be initialized in the
following circumstances:
⚫When rotating front and rear tires which have different tire inflation
pressures
⚫When changing the tire size
When the tire pressure warning system is initialized, the current tire infla-
tion pressure is set as the benchmark pressure.
⬛How to initialize the tire pressure warning system
a Park the vehicle in a safe place and turn the engine switch to “OFF”.
Initialization cannot be performed while the vehicle is moving.
b Adjust the tire inflation pressure to the specified cold tire inflation pres-
sure level. ( ➞P. 428)
Make sure to adjust the tire pressure to the specified cold tire inflation
pressure level. The tire pressure warning system will operate based on
this pressure level.
c Turn the engine switch to “ON”.
d Press and hold the tire pressure
warning reset switch until the tire
pressure warning light blinks
slowly 3 times.
e Wait for a few minutes with the engine switch in “ON” and then turn the
engine switch to “ACC” or “OFF”.
KBRO620403E
RAIZE_OM_General_BZ358E.book 329 ページ 2022年5月17日 火曜日 午後1時59分
Page 332 of 516

3306-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Registering ID codes (vehicles with a tire pressure warning system)
The tire pressure warning valve and transmitter is equipped with a unique
ID code. When replacing a tire pressure warning valve and transmitter, it
is necessary to register the ID code. Have the ID code registered by your
Toy o t a d e a l e r.
⬛When to replace your vehicle’s tires
Tires should be replaced if:
⚫The treadwear indicators are showing on a tire.
⚫You have tire damage such as cuts, spli ts, cracks deep enough to expose the
fabric, and bulges indicating internal damage
⚫A tire goes flat repeatedly or cannot be properly repaired due to the size or
location of a cut or other damage
If you are not sure, consult with your Toyota dealer.
⬛Replacing tires and wheels (vehicles wi th a tire pressure warning system)
If the ID code of the tire pressure war ning valve and transmitter is not regis-
tered, the tire pressure warning system will not work properly. After driving for
about 10 minutes, the tire pressure war ning light blinks for 1 minute and stays
on to indicate a system malfunction.
⬛Tire life
Any tire over 6 years old must be checked by a qualified technician even if it
has seldom or never been used or damage is not obvious.
⬛Routine tire inflation pr essure checks (vehicles with a tire pressure
warning system)
The tire pressure warning system does not replace routine tire inflation pres-
sure checks. Make sure to check tire inflation pressure as part of your routine
of daily vehicle checks.
⬛Initializing the tire pressure warning system (vehicles with a tire pressure
warning system)
Initialize the system with the tire inflation pressure adjusted to the specified
level.
RAIZE_OM_General_BZ358E.book 330 ページ 2022年5月17日 火曜日 午後1時59分