Page 1 of 486
OWNER' S MANUAL
Operation
Maintenance
Specifications
All information in this Owner’s Manual is current at the time of
publication. However, HYUNDAI reserves the right to make
changes at any time so that our policy of continual product
improvement may be carried out.
This manual applies to all models of this vehicle and includes
descriptions and explanations of optional as well as standard
equipment.
As a result, you may find material in this manual that does not
apply to your specific vehicle.
We recommend that you contact a HYUNDAI authorised repairer
for information regarding current standard and optional equip-
ment levels.
Page 41 of 486
3-9
03
Seat cushion height
(for driver’s seat, if equipped)
OAC3039004R
To change the height of the seat
cushion:
‡ Push down the lever several times,
to lower the seat cushion.
‡ Pull up the lever several times, to
raise the seat cushion.
Armrest
(for driver’s seat, if equipped)
OAC3039005R
Pull the armrest down to use it.
Seatback pocket (if equipped)
OAI3039033
The seatback pocket is provided on
the back of the front seatback.
CAUTION
Do not put heavy or sharp objects
in the seatback pockets. In an acci-
dent they could come loose from
the pocket and injure occupants.
Page 48 of 486
3-16
Safety system
OAI3039009
Removal and installation
To remove the head restraint :
1. Raise it as far as it can go.
2. Press the release button (1) whilst
pulling upward (2).
To reinstall the head restraint :
1. Put the head restraint poles (3) into
the holes whilst pressing the
release button (1).
2. Adjust the head restraint to the
appropriate height.
Seat warmers (if equipped)
Seat warmers are provided to warm
the seats during cold weather.
WARNING
The seat warmers can cause a
SERIOUS BURN, even at low tem-
peratures and especially if used
for long periods of time.
Passengers must be able to feel if
the seat is becoming too warm so
they can turn it off, if needed.
People who cannot detect temper-
ature change or pain to the skin
should use extreme caution, espe-
cially the following types of pas-
sengers:
‡ Infants, children, elderly or dis-
abled persons, or hospital outpa-
tients.
‡ People with sensitive skin or
who burn easily.
‡ Fatigued individuals.
‡ Intoxicated individuals.
‡ People taking medication that
can cause drowsiness or sleepi-
ness.
Page 49 of 486
3-17
03
WARNING
NEVER place anything on the seat
that insulates against heat when
the seat warmer is in operation,
such as a blanket or seat cushion.
This may cause the seat warmer to
overheat, causing a burn or dam-
age to the seat.
NOTICE
To prevent damage to the seat
warmers and seats:
‡ Never use a solvent such as
paint thinner, benzene, alcohol
or petrol to clean the seats.
‡ Do not place heavy or sharp
objects on seats equipped with
seat warmers.
‡ Do not change the seat cover. It
may damage the seat warmer or
air ventilation system.
OAC3039008TU
Whilst the engine is running, push
either of the switches to warm the
driver’s seat or front passenger’s
seat.
During mild weather or under condi-
tions where the operation of the seat
warmer is not needed, keep the
switches in the OFF position.
‡ Each time you push the switch, the
temperature setting of the seat is
changed as follows:
OFF JHIGH () JMIDDEL () JLOW ()
K
‡ The seat warmer defaults to the
OFF position whenever the ignition
switch is turned on.
‡ When pressing the switch for more
than 1.5 seconds with the seat
warmer operating, the seat warmer
will turn OFF.
Page 111 of 486
4-21
04
Press brake pedal to start
engine (for smart key system
and Automated Manual
Transmission)
This warning message is displayed if
the Engine Start/Stop button changes
to the ACC position twice by pressing
the button repeatedly without
depressing the brake pedal.
You can start the vehicle by depress-
ing the brake pedal.
Press clutch pedal to start
engine (for smart key system
and Manual transmission)
This warning message is displayed if
the Engine Start/Stop button is in the
ACC position twice by pressing the
button repeatedly without depressing
the clutch pedal.
Depress the clutch pedal to start the
engine.
Press START button again
(for smart key system)
This message is displayed if you
were unable to start the vehicle when
the Engine Start/Stop button was
pressed.
If this occurs, attempt to start the
engine by pressing the Engine Start/
Stop button again.
If the warning message appears each
time you press the Engine Start/Stop
button, we recommend that you have
your vehicle inspected by a HYUNDAI
authorised repairer.
Shift to N to start engine
(for smart key system and
Automated Manual
Transmission)
This warning message is displayed if
you try to start the engine with the
shift button not in the N (Neutral)
position.
i Information
lever in the 1 ( 1eutral) position.
Check BRAKE SWITCH fuse (for
smart key system and
Automated manual transmis-
sion)
This warning message is displayed if
the brake switch fuse is disconnect-
ed.
You need to replace the fuse with a
new one. If that is not possible, you
can start the engine by pressing the
Engine Start/Stop button for 10 sec-
onds in the ACC position.
Page 149 of 486
5-21
05
Tilt steering / Telescope
steering
WARNING
Never adjust the steering wheel
whilst driving. You may lose steer-
ing control and cause severe per-
sonal injury, death or accidents.
i Information
After adjustment, sometimes the lock-
release lever may not lock the steering
wheel.
It is not a malfunction. 7his occurs
when two gears are not engaged cor-
rectly. In this case, adjust the steering
wheel again and then lock the steering
wheel.
OAC3059009R
To change the steering wheel angle
and height:
1. Pull down the lock-release lever
(1).
$ G M X V W W K H V W H H U L Q J Z K H H O W R W K H
desired angle (2) and height (3, if
equipped). Move the steering
wheel, so it points toward your
chest, not toward your face. Make
sure you can see the instrument
panel warning lights and gauges.
3. Pull up the lock-release lever to
lock the steering wheel in place.
Push the steering wheel both up and
down to be certain it is locked in posi-
tion.
CAUTION
Whilst adjusting the steering wheel
height, please do not push or pull
it hard since the fixture can be
damaged.
Page 169 of 486
5-41
05
Turn signals and lane change
signals
OHCR046350
To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).
The lever will return to the OFF posi-
tion when released or when the turn
is completed.
If an indicator stays on and does not
flash or if it flashes abnormally, one of
the turn signal bulbs may be burned
out and will require replacement.
2ne-touch turn signal function
To activate a one-touch turn signal
function, move the turn signal lever
slightly and then release it. The lane
change signals will blink 3, 5 or 7
times.
You can activate or deactivate the
One Touch Turn Signal function or
choose the number of blinks (3, 5, or
7) from the User Settings Mode on
the LCD display. ) R U P R U H G H W D L O V
refer to “LCD Display Modes” in
chapter 4.
Front fog light (if equipped)
OHCR046362
Fog lights are used to provide
improved visibility when visibility is
poor due to fog, rain or snow, etc.
1. Turn on the park light.
2. Move the light switch (1) to the
front fog light position.
3. To turn off the front fog light, turn
the light switch to the front fog light
position again or turn off the
Parking (Position) light
NOTICE
When in operation, the fog lights
consume large amounts of vehicle
electrical power. Only use the fog
lights when visibility is poor.
Page 240 of 486
![HYUNDAI I10 2023 Owners Manual 5-112
Convenient features
Restarting the current playback
On the control panel after the song
has played for 2 seconds, press the
[ 6 ( ( .] button.
‡ You can also push the Up lever on
the](/manual-img/35/56218/w960_56218-239.png "HYUNDAI I10 2023 Owners Manual 5-112
Convenient features
Restarting the current playback
On the control panel after the song
has played for 2 seconds, press the
[ 6 ( ( .] button.
‡ You can also push the Up lever on
the")
5-112
Convenient features
Restarting the current playback
On the control panel after the song
has played for 2 seconds, press the
[ 6 ( ( .] button.
‡ You can also push the Up lever on
the steering wheel.
Playing the previous or next
song
To play the previous song on the con-
trol panel within the first 2 seconds of
the current song, press the [ 6 ( ( .]
button. To play the next song, press
the [ 7 5 $ & . !] button on the control
panel.
‡ If more than 2 seconds of playback
have elapsed, press the [ 6 ( ( .]
button on the control panel twice to
play the previous song.
‡ You can also push the Up/down
lever on the steering wheel.
NOTICE
3 U H V V W K H > 0 ( 1 8 @ E X W W R Q R Q W K H
F R Q W U R O S D Q H O W R G L V S O D \ W K H P R G H
V H O H F W L R Q Z L Q G R Z W X U Q W K H > 7 8 1 ( @
N Q R E W R I L Q G W K H G H V L U H G V R Q J D Q G
S U H V V W K H N Q R E W R S O D \ W K H I L O H
Playing repeatedly
On the control panel, press the [ 5 3 7]
button. The repeat play mode changes
each time you press it. The corre-
sponding mode icon will be displayed
on the screen.
Playing in random order
On the control panel, press the
[ 6 + ) /] button. The shuffle play mode
is activated or deactivated each time
you press it. When you activate the
shuffle mode, the corresponding mode
icon will be displayed on the screen.
NOTICE
' H S H Q G L Q J R Q W K H F R Q Q H F W H G
% O X H W R R W K G H Y L F H R U P R E L O H S K R Q H
5 3 7 6 + ) / I H D W X U H V P D \ Q R W E H
V X S S R U W H G
Searching folders
1. On the control panel, press the
[ 0 ( 1 8 & / 2 & .] button.
2. When the option selection window
displays, turn the [TUNE] knob to
select the ) R O G H U O L V W and then
press the knob.
3. Navigate to the desired folder in
the ) R O G H U O L V W and then press the
[TUNE] knob.
