08
8-11
If either telltale illuminates, immediately 
reduce your speed, avoid hard cornering 
and anticipate increased stopping 
distances. You should stop and check 
your tires as soon as possible. Inflate the 
tires to the proper pressure as indicated 
on the vehicle’s placard or tire inflation 
pressure label located on the driver’s 
side center pillar outer panel.
If you cannot reach a service station or 
if the tire cannot hold the newly added 
air, replace the low pressure tire with the 
spare tire.
The Low Tire Pressure Telltale will remain 
on and the TPMS Malfunction Indicator 
may blink for one minute and then 
remain illuminated (when the vehicle 
is driven approximately 10 minutes at 
speed above 15.5 mph (25km/h)) until 
you have the low pressure tire repaired 
and replaced on the vehicle.
 Information
The spare tire is not equipped with a tire 
pressure sensor.
 CAUTION
In winter or cold weather, the Low Tire 
Pressure Telltale may be illuminated if 
the tire pressure was adjusted to the 
recommended tire inflation pressure 
in warm weather. It does not mean 
your TPMS is malfunctioning because 
the decreased temperature leads to a 
proportional lowering of tire pressure.
When you drive your vehicle from a 
warm area to a cold area or from a cold 
area to a warm area, or the outside 
temperature is greatly higher or lower, 
you should check the tire inflation 
pressure and adjust the tires to the 
recommended tire inflation pressure.
 WARNING
Low pressure damage
Significantly low tire pressure makes 
the vehicle unstable and can contribute 
to loss of vehicle control and increased 
braking distances.
Continued driving on low pressure tires 
can cause the tires to overheat and fail. 
08
8-13
Each wheel is equipped with a tire 
pressure sensor mounted inside the tire 
behind the valve stem (except for the 
spare tire). You must use TPMS specific 
wheels. Always have your tires serviced 
by an authorized HYUNDAI dealer.
You may not be able to identify a tire 
with low pressure by simply looking at it. 
Always use a good quality tire pressure 
gauge to measure the tire’s inflation 
pressure. Please note that a tire that is 
hot (from being driven) will have a higher 
pressure measurement than a tire that is 
cold.
A cold tire means the vehicle has been 
sitting for 3 hours and driven for less 
than 1 mile (1.6 km) in that 3 hour period.
Allow the tire to cool before measuring 
the inflation pressure. Always be sure 
the tire is cold before inflating to the 
recommended pressure.
 WARNING
[ The TPMS cannot alert you to severe 
and sudden tire damage caused by 
external factors such as nails or road 
debris.
[  If you feel any vehicle instability, 
immediately take your foot off 
the accelerator, apply the brakes 
gradually with light force, and slowly 
move to a safe position off the road.
 WARNING
Tampering with, modifying, or disabling 
the Tire Pressure Monitoring System 
(TPMS) components may interfere 
with the system’s ability to warn the 
driver of low tire pressure conditions 
and/or TPMS malfunctions. Tampering 
with, modifying, or disabling the Tire 
Pressure Monitoring System (TPMS) 
components may void the warranty for 
that portion of the vehicle.
 Information
This device complies with Part 15 of the 
FCC rules.
Operation is subject to the following three 
conditions:
1.  This device may not cause harmful 
interference.
2.  This device must accept any 
interference received, including 
interference that may cause undesired 
operation.
3.  Changes or modifications not expressly 
approved by the party responsible 
for compliance could void the user’s 
authority to operate the equipment.