2023 HONDA ACCORD HYBRID ECO mode

97
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanation
Deceleration
Paddle Selector
Indicator
●Comes on when the paddle selector is
pulled.
●Blinks when deceleration does not occur
while pulling the paddle selector.
●Comes on with M when SPORT mode is
selected or pulling the paddle selector.
2 Deceleration Paddle Selector P. 380
Transmission
System Indicator
●Blinks if the transmission system has a
problem.●Have your vehicle checked by a dealer immediately.●Do not drive displays on the driver
information interface - Immediately stop in a safe
place and contact a dealer.
Seat Belt Reminder
Indicator
●Blinks and the beeper sounds for a few
seconds if you are not wearing a seat belt
when you set the power mode to ON, then
the indicator comes on.
●If the front passenger is not wearing a seat
belt, the indicator comes on a few seconds
later.
●Comes on for a while when the rear seat
belt is unfastened while the power mode in
ON.
●Blinks while driving if you and/or any
passenger has not fastened a seat belt. The
beeper sounds and the indicator blinks at
regular intervals.
●The beeper stops and the indicator goes off when
you and the passengers fasten their seat belts.
●Stays on after you and/or the passengers have
fastened the seat belt(s) - A detection error may
have occurred in the sensor. Have your vehicle
checked by a dealer.
2 Seat Belt Reminder P. 48
23 ACCORD 4D US HEV MAP-3130B6000.book 97 ページ ２０２２年１０月１３日　木曜日 　午後４時５０分

100
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanation
Low Tire Pressure/
TPMS Indicator*
●May come on briefly if the power mode is
set to ON and the vehicle is not moved
within 45 seconds, to indicate the
calibration process is not yet complete.
●Comes on and stays on when:
-One or more tires’ pressures are
determined to be significantly low.
- The system has not been calibrated.
●Comes on while driving - Stop in a safe place,
check tire pressures, and inflate the tire(s) if
necessary.
●Stays on after the tires are inflated to the
recommended pressures - The system needs to
be calibrated.
2 TPMS Calibration P. 394
●Blinks for about one minute, and then stays
on if there is a problem with the TPMS.●Blinks and remains on - Have your vehicle
checked by a dealer.
●Comes on if the TPMS is deactivated
temporarily after the 12-volt battery has
been disconnected, then re-connected.●Drive a short distance at more than 12 mph (20
km/h). The indicator should go off. If it does not,
have your vehicle checked by a dealer.
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 100 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

102
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanation
System Message
Indicator
•Comes on along with a beep when a
problem is detected. A system message on
the driver information interface appears at
the same time.●While the indicator is on, roll the right selector
wheel to see the message again.
2 Switching the Display P. 119●Refer to the Indicators in formation in this chapter
when a system message appears on the driver
information interface. Respond to the message
accordingly.
●The driver information interface will not return to
the normal screen unless the warning is canceled,
or the right selector wheel is rolled.
ECON Mode
Indicator●Comes on when you set the drive mode to
ECON .2Drive Mode System P. 384
NORMAL Mode
Indicator●Comes on when you set the drive mode to
NORMAL .2Drive Mode System P. 384
SPORT Mode
Indicator
●Comes on when you set the drive mode to
SPORT .●The ambient meter goes off and gauges in the
instrument panel light up in red as long as SPORT
mode is selected.
2 Drive Mode System P. 384
INDIVIDUAL
Mode Indicator●Comes on when you set the drive mode to
INDIVIDUAL .2Drive Mode System P. 384
23 ACCORD 4D US HEV MAP-3130B6000.book 102 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

103
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanation
AUTO Mode
Indicator●Comes on when you set the drive mode to
AUTO .2e Button P. 17
EV Mode Indicator●Comes on when you set the drive mode to
EV .2 e Button P. 17
CHARGE Mode
Indicator●Comes on when you set the drive mode to
CHARGE.2e Button P. 17
Immobilizer System
Indicator
•Blinks if the immobilizer system cannot
recognize the key information.•Blinks - You cannot start the power system. Set
the power mode to VEHICLE OFF, then select the
ON mode again.
Depress and hold the brake pedal before setting
the power mode to ON.
• Repeatedly blinks - The system may be
malfunctioning. Have your vehicle checked by a
dealer.
• Do not attempt to alter this system or add other
devices to it. Electrical problems can occur.
Security System
Alarm Indicator
•Blinks when the security system alarm has
been set.
2 Security System Alarm P. 162
IndicatorCanadian models
Indicator
23 ACCORD 4D US HEV MAP-3130B6000.book 103 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuGauges and Displays uHead-Up Display*
136
Instrument Panel
• Traffic Sign Recognition System: Shows
certain detected traffic signs while driving.
If speed limit warning is activated, the sign
icon blinks when th e maximum speed of
the traffic sign detect ed is exceeded by a
threshold, when compar ed with the vehicle
speed.
2 Traffic Sign Recognition System P. 473
Shows the display for changing the head-up display settings on the driver
information interface.
Roll the right selector wheel to scroll to select Head-Up Display settings, then
press the right selector wheel.
2 Switching the Display P. 119
Traffic Sign Recognition System
■Head-Up Display Settings
1Head-Up Display*
The default speed limit wa rning threshold is the
maximum speed of the traffic sign detected.
You can adjust the threshol d for speed limit warning.
2 Customized Features P. 318
1Head-Up Display Settings
HUD content
2 To change head-up display content P. 137
HUD brightness 2 Adjusting the head-up display brightness
P. 138
HUD height 2 Adjusting the head-up display height
P. 138
HUD rotation 2 Adjusting the head-up display angle P. 138
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 136 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

Continued147
uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
Controls
■Locking the doors and the trunk
Touch the door lock sensor on the front door.u Some exterior lights flash; the beeper
sounds; all the doors, fuel fill door and
trunk lock; and the security system sets.1Using the Keyless Access System
If you do not open a door within 30 seconds of
unlocking the vehicle with the keyless access system,
the doors and trunk will automatically relock.
You can lock or unlock doors using the keyless access
system only when the power mode is in VEHICLE OFF.
•Do not leave the keyless remote in the vehicle
when you get out. Carry it with you.
•Even if you are not carrying the keyless remote, you
can lock/unlock the doors while someone else with
the keyless remote is within range.
•The door may be unlocked if the door handle is
covered with water in heavy rain or in a car wash if
the keyless remote is within range.
•If you grip a front door ha ndle or touch a door lock
sensor wearing gloves, the door sensor may be
slow to respond or may no t respond by locking or
unlocking the doors.
•After locking the door, you have up to 2 seconds
during which you can pull the door handle to
confirm whether the door is locked. If you need to
unlock the door immediately after locking it, wait
at least 2 seconds befo re gripping the handle,
otherwise the door will not unlock.
Door Lock Sensor
23 ACCORD 4D US HEV MAP-3130B6000.book 147 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
150
Controls
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driver’s door.
3. Using the master door lock switch, operate
the lock as follows:
Lock Unlock Lock Unlock.
u The beeper sounds, and the function is
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle without using the auto lock
function.
• With the keyless remote on you, move out
of the auto lock function operation range.
• Open any door.1Locking the doors and trunk (Walk away auto lock ®)
The auto lock function does not operate when any of
the following conditions are met.
•The keyless remote is inside the vehicle.
•A door or the hood is not closed.•The power mode is set to any mode other than
OFF.
•The keyless remote is not located within a radius of
about 5 feet (1.5 m) from the vehicle when you get
out of the vehicle and close the doors.
Auto lock function operation stop beeper
After the auto lock function has been activated, the
auto lock operation stop beeper sounds for
approximately two seconds in the following cases.
•The keyless remote is put inside the vehicle through
a window.
•You are located too close to the vehicle.
•The keyless remote is put inside the trunk.
If the warning beeper sounds, check that you are
carrying the keyless remote. Then, open/close a door
and confirm the auto lock activation beeper sounds
once.
23 ACCORD 4D US HEV MAP-3130B6000.book 150 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
152
Controls
■Locking the doors
Press the lock button.
Once: u Some exterior lights flash, all the doors
and fuel fill door lock, and the security
system sets.
Twice (within five se conds after the first
push): u Some exterior lights flash, the beeper
sounds and verifies the security system is
set.
■Unlocking the doors
Press the unlock button.
Once: u Some exterior lights flash twice, and the
driver’s door and fuel fill door unlocks.
Twice: u Some exterior lights flash twice, and the
remaining doors and trunk unlock.
■Using the Remote Transmitter1Using the Remote Transmitter
If you do not open a door within 30 seconds of
unlocking the vehicle with the remote transmitter,
the doors will automatically relock.
The remote transmitter us es low-power signals, so
the operating range may vary depending on the
surroundings.
You can lock or unlock doors using the remote
transmitter only when the power mode is in VEHICLE
OFF.
If the distance at which the remote transmitter works
varies, the batter y is probably low.
If the LED does not come on when you press a
button, the battery is dead. 2 Replacing the Remote Battery P. 548
LED
Unlock
ButtonLock
Button
23 ACCORD 4D US HEV MAP-3130B6000.book 152 ページ ２０２２年１０月１３日　木曜日　午後４時５０分