2023 HONDA ACCORD HYBRID change time

181
uuOperating the Switches Around the Steering Wheel uWipers and Washers
Continued
Controls
Wipers and Washers
The windshield wipers and washers can be
used when the power mode is in ON.
■MIST
The wipers run at high speed until you release
the lever.
■Wiper switch (OFF, INT*1/AUTO*2, LO,
HI)
Move the lever up or down to change the
wiper settings.
■Adjusting wiper operation*
Turn the adjustment ring to adjust the wiper
operation.
■Washer
Sprays while you pull the lever toward you.
When you release the le ver for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
and then stop.
*1: Models with manual intermittent operation
*2: Models with automati c intermittent operation
■Windshield Wiper/Washer1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get sc ratched, or the rubber
blades will get damaged.
NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation’s
shortest delay setting ( ) and the LO setting become
the same.
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in th is condition may damage
the wipers. Use the defogger to warm the
windshield, then turn the wipers on.
Models with intermittent time adjustment ring
Intermittent Time
Adjustment Ring*
MIST
INT
*1/AUTO*2
OFF
LO : Low speed wipe
HI : High speed wipe Pull to
use
washer.Lower speed, fewer sweeps
Higher speed, more sweeps
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 181 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

198
Controls
Interior Convenience Items
Interior Lights
■ON
The interior lights come on regardless of
whether the doors are open or closed.
■Door activated
The interior lights come on in the following
situations:
• When any doors are opened.
• When the driver’s door is unlocked.
• When the power mode is set to VEHICLE
OFF.
■OFF
The interior lights remain off regardless of
whether the doors are open or closed.
■Interior Light Switches1 Interior Light Switches
In the door activated position, the interior lights fade
out and go off about 30 se conds after the doors are
closed.
The lights go off after about 30 seconds in the
following situations:
•When you unlock the driver’s door but do not open
it.
•When you set the power mode to VEHICLE OFF but
do not open a door.
You can change the interi or lights dimming time.
2 Customized Features P. 318
The interior lights go off im mediately in the following
situations:
•When you lock the driver’s door.
•When you set the power mode to ON.•When you close the driver’s door in ACCESSORY
mode.
If you leave any of the doors open in VEHICLE OFF
mode, the interior light s go off after about 15
minutes.
To avoid draining the 12-vo lt battery, do not leave
the interior light on for an extended length of time
when the power system is off.
Door Activated Position
OFF
Door Activated Position
Front
Rear
ON
OFFON
23 ACCORD 4D US HEV MAP-3130B6000.book 198 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

Continued211
uuInterior Convenience Items uOther Interior Convenience Items
Controls
The seat heaters can be used when the power
mode is in ON.
Press the seat heater button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF setting (no indicators on)
When the power mode is turned on after it is
turned off, the previous setting is maintained.
Press the AUTO button:
Both the air conditioner and seat temperature
will automatically change to the setting most
suitable to the ambient environment. u When any seat heater button is pressed,
settings will switch to manual mode.
■Front Seat Heaters*1Front Seat Heaters*
Do not use the seat heaters even in LO when the
power system is off. U nder such conditions, the 12-
volt battery may be weakened, making the power
system difficult to start.
After a certain period of time, the strength setting for
the front seat heaters will automatically be reduced
by one level at a ti me until the front seat heaters shut
off. The elapsed time varies according to the interior
environment.
As time passes, the set temperature will fall, and
eventually the seat heater will shut off.
The seat heater may turn on if sensors detect weight
on the passenger seat due to luggage, etc.
To prevent automatic activation, you can turn off
automatic climate control for the front seat. 2 Customized Features P. 318
3WARNING
Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lowerlimb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
AUTO Button
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 211 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuInterior Convenience Items uOther Interior Convenience Items
212
Controls
The seat heaters or ve ntilators can be used
when the power mode is in ON.
The seat heaters: Use them to warm up the
seat.
The seat ventilators: Use them when you want
to ventilate the surface of the seats. When
used with the air conditioning, the surface of
the seats will become easier to cool.
Press the seat heater or the seat ventilation
button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF se tting (no indicators on)
When the power mode is turned on after it is
turned off, the previous setting is maintained.
Press the AUTO button:
Both the air conditioner and seat temperature
will automatically change to the setting most
suitable to the ambient environment. u When any seat heater or seat ventilation
button is pressed, settings will switch to
manual mode.
■Front Seat Heaters and Seat Ventilation*1Front Seat Heaters and Seat Ventilation*
Do not use the seat heater s and the seat ventilation
ev en in LO when the power syst em is off. Under such
conditions, the 12-volt ba ttery may be weakened,
making the power system difficult to start.
After a certain period of time, the strength setting for
the front seat heaters will automatically be reduced
by one level at a ti me until the front seat heaters shut
off. The elapsed time varies according to the interior
environment.
As time passes, the set temperature will fall, and
eventually the seat heater will shut off.
The seat heater and seat ventilation may turn on if
sensors detect weight on the passenger seat due to
luggage, etc.
To prevent automatic activation, you can turn off
automatic climate control for the front seat. 2 Customized Features P. 318
3WARNING
Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lowerlimb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
AUTO Button
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 212 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

228
uuAudio System Basic Operation uStart Up
Features
Start Up
The 12.3 inch Color Touchscr een starts automatically when you set the power mode
to ACCESSORY or ON. At start-up, the followi ng screen about the data upload will
be displayed. When adding a new user, entry of user information is required at start-
up. Select OK.
u If you want to change the settings for
data upload, select Data Sharing, then
select the ON/OFF settings on the Data
Sharing Setting screen.
u If you do not select OK, the system will
automatically be switched to the home
screen, or the top screen of the last
executed application, after a certain
period of time.
u If there is no registered device, select OK
and the Bluetooth ® pairing screen will be
displayed.
u If you check the box with Do not show
this again, this screen will not be
displayed.1 Start Up
Data Sharing Setting
ON : Data communicati on is available.
OFF: Data communication is not available.
23 ACCORD 4D US HEV MAP-3130B6000.book 228 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

232
uuAudio System Basic Operation uAudio/Information Screen
Features
■Trip Computer
Displays the trip co mputer information.
• Current Drive tab: Displays the current trip information.
• Trip A /Trip B tab: Displays information for the current and three previous drives.
The information is stored every time you reset Trip A/B.
To reset the Trip A/B, select Menu, then select Delete Trip History .
To change the setting of how to reset Trip A/B, select Menu, then select “Trip A”
Reset Timing or “Trip B” Reset Timing.
■Clock
Displays the clock.
■System Updates
Updates the software version of the audio system.
2 System Updates P. 246
■FM/AM/USB/Bluetooth Audio
Displays information fo r each audio format.
■Profile Settings
Displays the profile settings screen or change user screen.
2 User Information P. 290
■Vehicle Settings
Displays the vehicle settings screen.
2 Customized Features P. 318
23 ACCORD 4D US HEV MAP-3130B6000.book 232 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuAudio System Basic Operation uAudio/Information Screen
238
Features
You can change, store, and delete the wa llpaper on the audio/information screen.
■Import wallpaper
1.Connect the USB flash drive to the USB port
in the center pocket.
2 USB Ports P. 221
2.Select Clock.
3. Select Menu.
4. Select Clock Faces.
5. Select Add More .
6. Import a desired picture.
u Multiple pictures can be imported at the
same time.
7. Select Select Files.
8. Select Add Files.
u The display will return to the Clock Faces
screen.
■Wallpaper Setup1 Wallpaper Setup
The wallpaper you set up on Clock Faces cannot be
displayed on the driver information interface.
•When importing wallpaper files, the image must be
in the USB flash drive’s root directory. Images in a
folder cannot be imported.
•The file name must be fewer than 64 bytes.
•The file format of the im age that can be imported
is BMP (bmp) or JPEG (jpg).
•Up to 21 pictures can be imported.
•The maximum image size is 4,096 × 2,304 pixels. If
the image size is less, the image is displayed in the
middle of the screen with the extra area appearing
in black.
23 ACCORD 4D US HEV MAP-3130B6000.book 238 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

246
uuAudio System Basic Operation uSystem Updates
Features
System Updates
System Updates uses the telematics con trol unit (TCU) or Wi-Fi communication
capability to operate.
When an update for your system becomes available, a screen prompting you to
update your system will be displaye d on the audio/information screen.
■Performing System Updates
1.Select Agree to Update to give permission
for the update.
u If Automatic Update is set to OFF, this
screen will not be displayed.
2. When the power mode is turned to OFF,
the permission screen is displayed.
Once a system update is started, the vehicle
will become unable to move.
u When you select Proceed Now, the
system update begins immediately.
u If you select Set Update Time , you can
set a time for the update to be
performed.
u If you select Remind Me Later , you can
delay the system update. The permission
screen will be displayed again the next
time the power mode is turned to OFF.
For important updates, Remind Me Later
will stop displaying after it has been
selected a certain number of times.
■Performing/Scheduling System Updates
1 System Updates
NOTICE
When a system update is started, the vehicle will
become unable to move.
If new software has been released, perform an
update as soon as possible.
If a system update fails , please consult a dealer.
System updates that change specifications may result
in some discrepancies with the information in this
owner’s manual.
1 Performing/Scheduling System Updates
NOTICE
For important updates, Remind Me Later will stop
displaying after it has been selected a certain number
of times.
Make sure your ve hicle is stopped in a safe location
before starting a system update.
23 ACCORD 4D US HEV MAP-3130B6000.book 246 ページ ２０２２年１０月１３日　木曜日　午後４時５０分