2023 GENESIS GV60 power steering
[x] Cancel search: power steeringPage 393 of 690
6-59
06
DRIFT mode is a driving mode that
automatically activates rear wheels(2WD)
and brakes or Electronic Limited Slip
Differential(e-LSD) to easily achieve drift
with a small steering wheel angle and
accelerator pedal.
To Activate DRIFT Mode
Pull and hold the left and right paddle
shift levers for more than 3 seconds at
the same time to switch to drift mode.
When activated DRIFT mode, the
message "DRIFT mode activated" and
the DRIFT indicator will illuminate on the
instrument panel.
To activate the DRIFT mode, satisfy all of
the following conditions:
- Gear in P (Park)
- The ESC OFF is in state 2
- The drive mode is SPORT mode
- Depress the brake pedal
DRIFT Mode Disabled
The DRIFT mode will be cancelled or
limited when:
- If the driving mode is changed to a
mode other than SPORT during DRIFT
mode operation
- The ESC OFF stage 2 is released
- When pull and hold the left and right
paddle shift levers for more than 3
seconds at the same times during
DRIFT mode operation
- The power down warning
(
) indicator or service warning()
indicator is illuminate
- The ESC or e-LSD indicator is
illuminate
WARNING
[ The driver should hold the
responsibility to safely drive and
control the vehicle when using DRIFT
mode.
[ Use the drift mode in wide and flat
road surface without pedestrians,
vehicles or obstacles for the safety of
vehicles and pedestrians.
[ Always look ahead cautiously to
prevent unexpected and sudden
situations from occurring.
[ If you drive in DRIFT mode
continuous, it can cause premature
wear or damage to drive shafts and
brake parts.
' 5 , ) 7 0 2 ' (
Page 423 of 690
7-9
07
OJWEV071002L
( P H U J H Q F \ % U D N L Q J
[ To warn the driver that emergency
braking will be assisted, the
‘Emergency Braking’ warning
message will appear on the cluster,
an audible warning will sound and the
steering wheel will vibrate.
[ If a vehicle is detected in front,
the function will operate when
your vehicle speed is between
approximately 6-53 mph (10-85 km/h).
[ If Forward Collision-Avoidance Assist
judges that avoiding a collision is
difficult even by changing the driving
lane, the function will operate when
your vehicle speed is between
approximately 6-62 mph (10-100
km/h) (if equipped with front corner
radar).
The function operation range may
decrease due to the front traffic
condition or the surroundings of the
vehicle.
[ If a pedestrian or cyclist is detected
in front, the function will operate
when your vehicle speed is between
approximately 6-40 mph (10-65
km/h).
[ In emergency braking situation,
braking is assisted with strong braking
power by the function to help prevent
collision with the vehicle, pedestrian
or cyclist ahead.
OJWEV071003L
6 W R S S L Q J Y H K L F O H D Q G H Q G L Q J E U D N H F R Q W U R O
[ When the vehicle is stopped due
to emergency braking, the ‘Drive
carefully’ warning message will
appear on the cluster.
For your safety, the driver should
depress the brake pedal immediately
and check the surroundings.
[ Brake control will end after the vehicle
is stopped by emergency braking for
approximately 2 seconds.
Page 424 of 690
7-10
Driver Assistance System
Junction Turning function
Warning and control
Junction Turning function will warn and
control the vehicle depending on the
collision risk level: ‘Collision Warning’,
‘Emergency Braking’ and ‘Stopping
vehicle and ending brake control’.
OJWEV071009L
Collision Warning
[ To warn the driver of a collision, the
‘Collision Warning’ warning message
will appear on the cluster, an audible
warning will sound and the steering
wheel will vibrate.
[ The function will operate when
your vehicle speed is between
approximately 6-19 mph (10-30 km/h)
and the oncoming vehicle speed is
between approximately 19-44 mph
(30-70 km/h).
[ If ‘Active Assist’ is selected, braking
may be assisted.
OJWEV071239L
( P H U J H Q F \ % U D N L Q J
[ To warn the driver that emergency
braking will be assisted, the
‘Emergency Braking’ warning
message will appear on the cluster,
an audible warning will sound and the
steering wheel will vibrate.
[ The function will operate when
your vehicle speed is between
approximately 6-19 mph (10-30 km/h)
and the oncoming vehicle speed is
between approximately 19-44 mph
(30-70 km/h).
[ In emergency braking situation,
braking is assisted with strong braking
power by the function to help prevent
collision with the oncoming vehicle.
Information
If the driver's seat is on the left side,
Junction Turning function will operate
only when you turn left. If the driver's seat
position is on the right side, the function
will operate only when you turn right.
Page 426 of 690
7-12
Driver Assistance System
OJWEV071007LOJWEV071006L
( P H U J H Q F \ % U D N L Q J
[ To warn the driver that emergency
braking will be assisted, the
‘Emergency Braking’ warning
message will appear on the cluster,
an audible warning will sound and the
steering wheel will vibrate.
[ The function will operate when
your vehicle speed is between
approximately 6-19 mph (10-30 km/h)
and the detected crossing vehicle
speed is between approximately 6-12
mph (10-20 km/h).
[ In emergency braking situation,
braking is assisted with strong braking
power by the function to help prevent
collision with the crossing vehicle.
OJWEV071003L
6 W R S S L Q J Y H K L F O H D Q G H Q G L Q J E U D N H F R Q W U R O
[ When the vehicle is stopped due
to emergency braking, the ‘Drive
carefully’ warning message will
appear on the cluster.
For your safety, the driver should
depress the brake pedal immediately
and check the surroundings.
[ Brake control will end after the vehicle
is stopped by emergency braking for
approximately 2 seconds.
CAUTION
If the collision angle with the crossing
Y H K L F O H L V E H \ R Q G D F H U W D L Q U D Q J H
Junction Crossing function warning and
F R Q W U R O P D \ E H O D W H R U P D \ Q R W R S H U D W H
Page 545 of 690
7-131
07
OPDEN060039OJWEV071041L
OJWEV071225L
Emergency Braking
[ To warn the driver of an approaching
a detected vehicle from the rear left/
right side of your vehicle, the warning
light on the outside rearview mirror
will blink and a warning message will
appear on the cluster. At the same
time, an audible warning will sound
and the steering wheel will vibrate.
A warning will also appear on the
infotainment system screen.[ Rear Cross-Traffic Collision-Avoidance
Assist will operate when all the
following conditions are satisfied:
- The gear is shifted to R (Reverse)
- Vehicle speed is below 5 mph (8
km/h)
- The approaching a detected vehicle
is within approximately 5 ft. (1.5 m)
from the left and right side of your
vehicle
- The speed of the a detected vehicle
approaching from the left and right
is above 3 mph (5 km/h)
[ Emergency braking will be assisted
to help prevent collision with
approaching vehicles from the left
and right.
: $ 5 1 , 1 *
% U D N H F R Q W U R O H Q G V Z K H Q W K H F R Q G L W L R Q V
R I W K H D S S U R D F K L Q J Y H K L F O H I U R P W K H
U H D U O H I W R U U L J K W V L G H D U H D V E H O R Z
[ 7 K H D S S U R D F K L Q J Y H K L F O H L V R X W R I W K H
detecting range
[ 7 K H D S S U R D F K L Q J Y H K L F O H S D V V H V
E H K L Q G \ R X U Y H K L F O H
[ 7 K H D S S U R D F K L Q J Y H K L F O H G R H V Q R W
G U L Y H W R Z D U G \ R X U Y H K L F O H
[ 7 K H D S S U R D F K L Q J Y H K L F O H V S H H G V O R Z V
down
[ 7 K H G U L Y H U G H S U H V V H V W K H E U D N H S H G D O
with sufficient power
Page 667 of 690
9-40
Maintenance
Instrument panel fuse panel
Fuse NameFuse Rating Circuit Protected
EPCU310A Rear Inverter (System)
E-SHIFTER 410A SCU
WASHER15A Washer Relay
BATTERY
MANAGEMENT10A Battery System Assembly (BMU)
POWER
HANDLE15A Steering Tilt & Telescopic Unit
MODULE 67.5A IBU, IAU
MODULE 410AELSD Unit, Rear Inverter (System), ECS Unit, Rear Corner
Radar LH/RH, Front View Camera, ADAS unit (Driving/
Parking), Crash Pad Switch, VESS Unit, Steering Tilt &
Telescopic Unit, Front Radar, Front Corner Radar LH/RH,
Front Inverter (System)
MODULE 510AData Link Connector, CCIC Head Unit, Electro Chromic
Mirror, DCU, CCIC Keyboard, Smart Phone Wireless
Charger, Console Switch, AMP, Driver/Passenger Power
Seat Module, Front Seat Warmer Control Module, Rear
Seat Warmer Control Module, Face Recognition Unit,
Front Air Ventilation Seat Control Module
MODULE 210AFace Recognition Unit, Center Control Panel, AMP, IBU,
CCIC Head Unit,P/R Junction Block (RLY. 11), Instrument
Cluster, CCU, DCU, IAU, ADAS Unit (Parking)
SPARE (B+)10A Not Used
Page 673 of 690
9-46
Maintenance
Vehicle compartment fuse panel
Type Fuse NameFuse Rating Circuit Protected
MULTI
FUSE-1LDC200A P/R Junction Block (Fuse : F2, S1, S2, S3, S4, S5)
MDPS1 *1100A MDPS Unit
MULTI
FUSE-2C/FAN80A Cooling Fan Motor
RR HTD150A P/R Junction Block (RLY.3)
B+150A ICU Junction Block (IPS1, IPS2, IPS3, IPS4, IPS5)
TRAILER150A CTM (CAN Type Trailer Module)
B+240A ICU Junction Block (IPS6, IPS7, IPS8)
MULTI
FUSE-3B+560A PCB Block (IG3 Main Relay, Fuse : F2, F3, F4, F6)
B+360AICU Junction Block (Fuse : F1, F11, F12, F21, F22,
F31,F32, F41, F42, F51)
BLOWER50A P/R Junction Block (RLY.9)
IEB160A IEB Unit
IEB260A IEB Unit
IG140A P/R Junction Block (RLY.5, RLY.7)
IG240A P/R Junction Block (RLY.10)
*1 : MDPS (Motor Driven Power Steering) is the same as EPS (Electric Power Steering)