2023 GENESIS G90 turn signal
[x] Cancel search: turn signalPage 365 of 676
6-55
06
Coasting Release Conditions
The Coasting function will be
automatically released when the
following conditions are met.
[ Comfort or Sport is selected for
driving mode
[ The driver uses the paddle shifter
[ Smart Cruise Control is activated (Set
speed appears on the cluster)
[ The vehicle’s speed exceeds 30~100
mph (50~160 km/h) range
[ The road gradient is under -5% or over
+5%
[ If the distance between the vehicle
ahead is too close or the relative
speed changes momentarily in Smart
mode
[ If lane change is predicated in Smart
mode (for example, the turn signal is
turned ON or a LKA warning appears
due to steering wheel control, etc.)
Information
It is recommended to turn off the
Coasting function if you are driving under
frequently stop-and-go condition. Change
the drive mode to Comfort or Sport or
deselect Coasting from the infotainment
system screen.
NOTICE
[ If the accelerator pedal is pressed
quickly for accelerating with the
Coasting function in operation,
acceleration may occur after the
engagement of the clutch inside the
transmission. In turn, the driver may
continue to feel acceleration even
after the system is turned off.
[ Driving with the Coasting function
off may be required in some cases
since the engine brake is not applied
while the Coasting function is
operating.
[ Operating the infotainment system
screen to activate or deactivate
the Coasting function while driving
may be dangerous as the driver’s
attention is dispersed.
Page 391 of 676
7-2
Driver Assistance System
ORS071083
Forward Collision-Avoidance Assist is
designed to help detect and monitor the
vehicle ahead or help detect a powered
two-wheeler, pedestrian or cyclist in
the roadway and warn the driver that
a collision is imminent with a warning
message and warning and application of
emergency braking.
In addition, when driving at high speeds,
Forward Collision-Avoidance Assist
will help detect vehicles in front and
adjacent lanes. If a collision is imminent
when changing lanes, Forward Collision-
Avoidance Assist will apply emergency
braking to help prevent a collision.Junction Turning functionORS071055
Junction Turning function can help avoid
a collision with an oncoming vehicle in
an adjacent lane when turning left at
a crossroad with the turn signal on by
applying emergency braking.
Junction Crossing function
ORS071056
Junction Crossing function can help
avoid a collision with oncoming vehicles
on the left or right side when crossing
an intersection by applying emergency
braking.
) 2 5 : $ 5 ' & 2 / / , 6 , 2 1
Page 429 of 676
7-40
Driver Assistance System
Collision warning
[ Collision warning will operate when
the turn signal is turned on in the
direction of the detected vehicle.
[ If ‘Warning Only’ is selected from the
Settings menu, the collision warning
will operate when your vehicle
approaches the lane the blind spot
vehicle is detected.
[ To warn the driver of a collision, the
warning light on the side view mirror
and head-up display (if equipped) will
blink. At the same time, an audible
warning will sound and the steering
wheel will vibrate.
[ When the turn signal is turned off or
you move away from the lane, the
collision warning will be canceled and
Blind-Spot Collision-Avoidance Assist
will return to vehicle detection state.
: $ 5 1 , 1 *
[ The detecting range of the front
corner radar or rear corner radar
L V G H W H U P L Q H G E \ D V W D Q G D U G U R D G
Z L G W K W K H U H I R U H R Q D Q D U U R Z U R D G
% O L Q G 6 S R W & R O O L V L R Q $ Y R L G D Q F H
$ V V L V W P D \ G H W H F W R W K H U Y H K L F O H V L Q
W K H Q H [ W Q H [ W O D Q H D Q G Z D U Q \ R X , Q
F R Q W U D V W R Q D Z L G H U R D G % O L Q G 6 S R W
& R O O L V L R Q $ Y R L G D Q F H $ V V L V W P D \ Q R W
E H D E O H W R G H W H F W D Y H K L F O H G U L Y L Q J L Q
W K H Q H [ W O D Q H D Q G P D \ Q R W Z D U Q \ R X
[ : K H Q W K H K D ] D U G Z D U Q L Q J I O D V K H U L V
R Q W K H F R O O L V L R Q Z D U Q L Q J E \ W K H W X U Q
V L J Q D O Z L O O Q R W R S H U D W H
Collision-Avoidance Assist (while
driving)
ORS071114L
[ To warn the driver of a collision, the
warning light on the side view mirror
will blink and a warning message will
appear on the instrument cluster. At
the same time, an audible warning will
sound, warning light on the head-up
display (if equipped) will blink and the
steering wheel will vibrate.
[ Steering will be assisted to help
prevent collision with the vehicle in
the blind spot area.
[ Blind-Spot Collision-Avoidance Assist
will operate when your vehicle speed
is between 40-87 mph (60-140 km/h)
and both lane markings of the driving
lane are detected.
Page 463 of 676
7-74
Driver Assistance System
Blind-Spot View Monitor
2 S H U D W L Q J F R Q G L W L R Q V
When the left or right side turn signal
turns on, the image in that direction is
displayed on the instrument cluster.
Off conditions
[ When the turn signal turns off, the
image on the instrument cluster will
turn off.
[ When the hazard warning flasher
is on, Blind-Spot View Monitor will
turn off, regardless of the turn signal
status.
[ When other important warning is
displayed on the instrument cluster,
Blind-Spot View Monitor may turn off.
% O L Q G 6 S R W 9 L H Z 0 R Q L W R U
0 D O I X Q F W L R Q
When Blind-Spot View Monitor is not
working properly, or the cluster display
flickers, or the camera image does
not display properly, have the vehicle
inspected by an authorized retailer of
Genesis Brand products.
: $ 5 1 , 1 *
[ 7 K H L P D J H V K R Z Q R Q W K H F O X V W H U P D \
differ from the actual distance of the
R E M H F W 0 D N H V X U H W R G L U H F W O \ F K H F N
W K H Y H K L F O H
V V X U U R X Q G L Q J V I R U V D I H W \
[ $ O Z D \ V N H H S W K H F D P H U D O H Q V F O H D Q
, I W K H O H Q V L V F R Y H U H G Z L W K I R U H L J Q
P D W H U L D O L W P D \ D G Y H U V H O \ D I I H F W
F D P H U D S H U I R U P D Q F H D Q G % O L Q G
6 S R W 9 L H Z 0 R Q L W R U P D \ Q R W R S H U D W H
S U R S H U O \
Page 467 of 676
7-78
Driver Assistance System
Operating conditions for
Acceleration Assist
Overtaking Acceleration Assist operates
when the turn signal indicator is turned
on to the left while Smart Cruise Control
is operating, and the following conditions
are satisfied:
[ Your vehicle speed is above 40 mph
(60 km/h)
[ A vehicle is detected in front of your
vehicle
Overtaking Acceleration Assist does not
operate in the following conditions.
[ The hazard warning flasher is on
[ Vehicle speed is reduced to maintain
distance with the vehicle in front
: $ 5 1 , 1 *
When the turn signal indicator is turned
R Q W R W K H O H I W Z K L O H W K H U H L V D Y H K L F O H
D K H D G W K H Y H K L F O H P D \ D F F H O H U D W H
W H P S R U D U L O \ 3 D \ D W W H Q W L R Q W R W K H U R D G
F R Q G L W L R Q V D W D O O W L P H V
Turning on Smart Cruise Control
ORS071025
[ Press the Driving Assist button to turn
on Smart Cruise Control. The speed
will be set to the current speed on the
cluster.
[ If there is no vehicle in front of you,
the set speed will be maintained, but
if there is a vehicle in front of you,
the speed may decrease to maintain
the distance to the vehicle ahead. If
the vehicle ahead accelerates, your
vehicle will travel at a steady cruising
speed after accelerating to the set
speed.
Information
, I \ R X U Y H K L F O H V S H H G L V E H W Z H H Q P S K
N P K Z K H Q \ R X S U H V V W K H ' U L Y L Q J
$ V V L V W E X W W R Q W K H V H W V S H H G Z L O O E H V H W W R
P S K N P K
Page 499 of 676
7-110
Driver Assistance System
ORS072093N
A: Ready/Operating,
B: Standby/Canceled
(1) Highway Lane Change Assist
indicator
[ Green on : Ready state
[ Green blink : Operating state
[ Grey on : Standby state
[ White blink : Canceled state
(display only a certain time)
(2) Green lane line
The lane line is displayed same as
the Highway Lane Change Assist
indicator (1). However, if the function
is on standby, it displays whether the
lane line is detected.
(3) Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started
operating, and until the lane change
has completed.
(4) Message
[ Message is displayed when the
function does not operate even
though the turn signal is used.
[ Message is displayed when
the function is canceled while
operating.
7 R W X U Q R Q + L J K Z D \ / D Q H & K D Q J H $ V V L V W
Highway Lane Change Assist function
will turn on when the following
conditions are satisfied.
[ The Driving Assist button or Lane
Driving Assist button is used to turn
on Highway Driving Assist.
+ L J K Z D \ / D Q H & K D Q J H $ V V L V W U H D G \ W R
R S H U D W H
While Highway Lane Change Assist
function is on, the function will be
ready to operate when all the following
conditions are satisfied:
[ Highway Driving Assist is operating
[ Lane Following Assist is operating
[ A vehicle in the rear area of your
vehicle is detected more than once
after the engine is turned on
[ Your vehicle speed is above 50 mph
(80 km/h)
[ Hands-off warning is not displayed on
the cluster
[ Hazard warning flasher is off
Page 500 of 676
7-111
07
Information
[ While Lane Change Assist functionis
turned on (indicator on), Lane
Following Assist will not cancel even
if the turn signal indicator or hazard
Z D U Q L Q J I O D V K H U L V R S H U D W L Q J
[ Lane Change Assist function turn
off automatically when driven in the
following road conditions:
-One driving lane
-A road with a intersection
orcrosswalk ahead
-A road with no structure, such as a
P H G L X P V W U L S J X D U G U D L O V H W F
- 7 K H U H L V D S H G H V W U L D Q R U F \ F O L V W R Q W K H
road ahead
[ When the function is in the ready state,
D Q G Y H K L F O H V S H H G L V E H O R Z P S K
N P K W K H I X Q F W L R Q Z L O O F K D Q J H W R W K H
standby state.
: $ 5 1 , 1 *
: K H Q + L J K Z D \ / D Q H & K D Q J H $ V V L V W
I X Q F W L R Q W X U Q V R I I Z K L O H R S H U D W L Q J
V W H H U L Q J D V V L V W Z L O O E H W H P S R U D U L O \
F D Q F H O H G $ O Z D \ V E H F D X W L R X V Z K L O H
G U L Y L Q J
+ L J K Z D \ / D Q H & K D Q J H $ V V L V W R S H U D W L Q J
ORS071269
M: Center
Highway Lane Change Assist function
will operate, when you push the turn
signal lever up or down to the A or B
position while the function is in the ready
state (indicator is green), and all of the
following conditions are satisfied:
[ The driver has his/her hand on the
steering wheel
[ There is no collision risk in the
direction of lane change
[ There is a single dotted lane line in the
direction of lane change
[ There are no Forward Collision-
Avoidance Assist and Blind Spot
Collision-Avoidance Assist warnings
[ The vehicle is driven in the middle of
the lane (should not be driving close
to one side of the lane)
[ The road you are driving on, or the
road you are about to change lane is a
road that the function can operate
Page 501 of 676
7-112
Driver Assistance System
Information
[ + L J K Z D \ / D Q H & K D Q J H $ V V L V W R S H U D W H V
Z K H Q W K H W X U Q V L J Q D O O H Y H U L V S R V L W L R Q H G
at A. If the turn signal lever is released
to the center M E H I R U H V W H S S L Q J R Q W K H
O D Q H + L J K Z D \ / D Q H & K D Q J H $ V V L V W
cancels. If the turn signal lever is
released to the center M D I W H U V W H S S L Q J
R Q W K H O D Q H + L J K Z D \ / D Q H & K D Q J H
Assist changes the lane and turns off
the turn signal after lane change is
F R P S O H W H
[ : K H Q W K H W X U Q V L J Q D O O H Y H U L V S O D F H G D W
% S R V L W L R Q I R U D F H U W D L Q S H U L R G R I W L P H
W K H J U H H Q D U U R Z Z L O O D S S H D U $ W W K L V
time, even when the lever is released
D Q G U H W X U Q V W R L W